Zami Runtz

I first prepare an Hydrogen Peroxyde 3% solution, ~3ml in a bit less of 1 litter of water. I'll refer this solution as "Baby Bath" from now. ;) Then I put a bit of Baby Bath in the bottom of a small glass and dip the seed in it. I add just ~1.5ml of Root Booster in the remaining Baby Bath. After ~24h, I grab the not-yet-germinated seed with a tweezer, put some paper towel in the glass to pump the solution, place the seed on it and add another towel on top of it. This last piece of paper is fill with the updated Baby Bath. 12h later, the seed splits. I grab it with the tweezer and put it on a a Romberg cellulose-coco pot filled with fine parts of the soil I'll use in lager pot : Guano Production Zero Mix. I place the pot in my DIY 6 pots micro-greenhouse aside 3 other strains (each one will have their own diary), spray Baby Bath on it, fill the bottom of the *propagator* with it, then put it in the dark, on top of a 2×200W stereo amplifier (who generate a bit of heat). This is the first time I use Hydrogen Peroxyde to germinate breeders' seeds. A friend give me a batch of unknown [good] seeds, but old enough to need a bit help from oxygenated water for my last grows. So I was a bit surprised when I saw, less than 2 days later, that the seed have already germinated and had stretch. I quickly add a 5000K 5W LED light on top of the micro-greenhouse, add ~0.1g of Elycitor in the remaining Baby Bath, put 2 little pieces of Aptus AIO Pellet (~0.25g) in the soil and spray it with the latest Baby Bath. Hopefully, after full 24h the light stop the stretch so i start the 18/6 light cycle. -- It's was a hard week, for me and for the plants, because it was the first time I use my DIY micro-greenhouse and I was too busy too keep an eye on it. I didn't have time either to sanitize the grow space after the previous nor take in action pictures to feed this diary. The Runtz looks good, with a bit yellowish, but good. But, I'm more confident to start directly into the soil. So, at day 6, I filled a 3L Air-Pot of Guano Diffusion Zero Mix, spray a solution of Hydrogen Peroxide and water on top until it leak at the bottom. Then I waited about 10 hours before mixing 20g of Aptus AIO Pellet in it, prepare a hole to put the cellulose-coco pot with 5g of Mycorex, spray a solution of water with 3ml/l of Orgatrex + 2.5ml/l of Root Booster + 0.25g/l of Elycitor and put the pot under the Grow LED light.