Gorilla Zkittlez SeaofGreen

🗓️ 7 May 5:34 - Time for the first feeding of the plant, I make do with half dose of two-component 👉GOROGNA POWER BLOOM so 2ml/l plus 👉BACCHUS - TERRA TASTE 2ml/l, 👉Terpinator 2,6ml/l and of course 👉Voodoo Juice 2ml/l for the roots total ppm is around 👉 560ppm. all mixed in 👉4000ml 👆more details in the picture above👆 ..feeding only once a week. 🗓️ 8 May 8:34 - Plants respond almost immediately to a change in that photoperiod .. 👉 we can see the yellow spots so 👉👉 flowering has just begun 😈😈 🗓️12 May 9:24 - I'm raising the watering to 10l and we'll see, I'd like the girls to last at least 48 hours 😛 👉 At the same time, we're going to defoliate more today so that the energy goes into the flowers and they don't shade each other 👉 remember that it is good to remove the leaves that goes inside the plant 👈👽 🗓️12 May 10:30 - Plant height ranges from 40 to 60 cm. Number 1 & 5 are significantly higher than the others. 🗓️12 May 11:06 - All data are based on the arithmetic average over the period. 📑Day to day works📑 👉Air temperature check ☑️ 👉Air humidity check ☑️ 👉Substrate temperature check ☑️ 👉Ventilation functionality check ☑️ 👉Substrate moisture level check ☑️ 👉Plant health status check ☑️ 👉Calculate VPD (vapor pressure deficit) ☑️ 🗑️ Flower Pot (11l plastic pot square) 🗑️ Light Mix 73% 💪 🥥Biobizz Coco Mix 18% 💪 👇Plagron Euro Pebbles 9%, the bottom layer of the pot for better drainage👇 🏗️GrowBox🏗️ 💡 Lumatek ATS 300W PRO 2.7, LED luminaire with power control at OFF-25%-50%-75%-100% levels 💪 🎪Bud Box PRO L200 100x100x200 white 💦SonicAir 10l - 800ml/h humidifier with power control 🌀Pure Factory Dehumidifier 0,75l/24h + CORNWALL MINI dehumidifier 0,25l/24h 🌡️ibebot AirComfort Wireless Thermometer/Hygrometer,Urban WiFi Air Quality monitor, CO2 metr, CORNWALL drawer hygrostat ExHale CO2 Bag, natural CO2 generator 🕸️Screen of Green net 🔄Ventilation🔄 🌪️oscillating fan - Pure Factory 20W, 2-speed - Ø18cm 💤 💨Exhaust fan - GENT ECco TT100 - 280 m3/h, fan with EC motor 💤 💩Odour filter - Prima Klima ECO K2601 flat 440 m3/h, 125 mm 🚨GSE temperature controller, min/max speed for fans with EC motor 💧Input water (RO) - pH - 4,08; EC - 11ppm; T - 14,7°C💧 💧pH range - 6 - 6,1💧 💧EC range - 20ppm max💧 💧Temperature range - 18°C - 21°C💧