Recommended
Likes
Comments
Share
@Natrona
Follow
FBA2502 Week 3 April 13-19 Veg 2 This week I introduced nutrients to the watering schedule. My planned feed schedule will be to feed, feed, water each week until the time to flush. , adjusting nutrients per the growth cycle. Hopefully this will keep from overfeeding and reduce salt build up in the soil. Nutrients: I will be using General Hydroponics Flora line at ½ feed rate and Cal mag throughout this grow. My tap water measures 8.3-8.5 so even after adding nutrients, I have to PH down my feed solution. Regarding nutrients, I’ve tried Fox Farm, TPS1, Plagron and now General Hydroponics. What I am looking for is organic, ease of use, minimal individual bottles that will yield large, dense sticky buds that hit hard in effect. Plants range in height from 5-7” except #1 which has been pinned to the soil. I will try wrapping her around the perimeter of the pot. Since she leaned over, I pinned her down and have been anchoring along the rim, twisting the stem so the node is on the side or top rather than underneath. I don’t think she likes training since the stems are a bit floppy. They are all still in veg, bushy with large indica leaves. I’ve been tucking the large leaves under the bud sites to give more light under the canopy. I’m tempted to top one of the bigger plants to have a comparison on resistance and final yield. This week I made a short video for each 2502 tester and a pic or 2. GH Flora Micro ½ tsp /gal Gro ½ tsp /gal Bloom ½ tsp /gal Fox CalMag ½ tsp /gal PPM 573 & 715 when I added Plagrons Royal Rush 4ml. PH 6.7 Temp 65 Your likes and comments are appreciated. Thanks for stopping by. Growers love 💚🌿 💫Natrona💫
Likes
13
Share
@Lfuego22
Follow
Good week. Day 41-48 from clone about day 21-28 in veg 3 weeks in clone
Likes
12
Share
@DBQush
Follow
Dear diary, Week 9 marks the last week of veg as it ends with us finally transitioning into the flowering phase. As we embark onto flowing, I continue to fine-tune the environmental conditions and adjust nutrient levels to support optimal development. 🍀🍀🍀🍀🍀🍀🍀🍀🍀🍀 ⏰ Day 60: I administered a feeding with a nutrient strength of 1.66ms and adjusted the pH to 5.8. Additionally, I increased the light intensity from 20 to 25 dli (daily light integral). To maintain the desired humidity levels, I turned on the air conditioner to dehumidify the space, successfully bringing it back down to 58% as it started slipping up to the 70s again. However, this adjustment caused a slight drop in temperatures to 24.5 degrees Celsius. ⏰ Day 61: During the evening feeding session at 18:00, the plants received a feeding with a nutrient strength of 1.66ms and a pH level of 5.8. Furthermore, I elevated the light intensity from 25 to 28 dli, positioning the lights 50cm above the canopy. The night temperatures have also stabilized at 22.5 degrees Celsius after the AC change. ⏰ Day 62: I provided a feeding with a nutrient strength of 1.67ms and a pH level of 5.6. I also conducted some light low-stress training and removed any growth on the horizontal stems, as each stem already possesses its intended 16 tops. These adjustments will help maintain an even canopy and ensure optimal light penetration. ⏰ Day 63: During the evening feeding session, I administered a feeding with a nutrient solution at a strength of 1.67ms and adjusted the pH to 5.7. To enhance light exposure, I increased the light intensity to 32 dli/500ppfd and positioning the lights 48cm above the canopy. ⏰ Day 64: At 11:55, just before lights off, I applied pesticides to address any potential pest issues. During the evening feeding session, I provided a feeding with a nutrient strength of 1.67ms and a pH level of 5.7. Additionally, I removed some excess growth and increased the light intensity to 37 dli/580ppfd, getting to the optimal levels before flowering starts. ⏰ Day 65 (Day 1 Flower): I initiated the flowering phase by switching the lights to a 12/12 cycle and provided a feeding with a nutrient strength of 1.85ms and a pH level of 6.1. As the plants enter the flowering stage, I have adjusted the nutrient composition. The calmag has been reduced to 1.5ml/l, Bud Candy has been added at 1ml/l, and the A+B mix has been increased to 3ml/l. The plants water consumption has also increased, now reaching approximately 2 liters per day, which aligns well with the timing of the light cycle change. The temperatures have stabilized around 25 degrees Celsius during the day, and the relative humidity ranges between 55-60%. I have also set up the scrog net in preparation for the upcoming stretch phase. ⏰ Day 66: During the evening feeding session, I administered a feeding with a nutrient strength of 1.85ms and adjusted the pH to 6.0.
Likes
31
Share
Not too much to report this week. Smell is picking up a bit and trichromes are developing nicely. Plenty of growth all around. No problems—everything looks happy.
Likes
4
Share
Did LST and topped Pheno 1 & 2, 3 is too funky to mess with. I think PH was just my issue and possible too high intensity light as I lowered to 60%, but also brought my PH to 6.5 so I'm guessing that helped too.
Likes
32
Share
@Weediz
Follow
Day 58: Everything seems to go smooth. I got my new lamp up, and are experimenting with dimmer, hang height, and space between the bars. This is new for me, my old lamps is garbage compared to this! But as I have 2 pre-/flowering girls, and 4 babies I decided to go with little space between the first 4 bars (for the adults) and the last 2 have some more space between (for the babies), and are not going all the way to the edge. The adults is higher, than comes the teens, and finally the babies so they don't get the same light intensity. I am currently running it pretty low, about 35% and will see the next couple of days how the girls will react Day 61: The girls are starting to hang a bit. I do not know what is causing it, or is it just normal? I took the pictures and video about 3 hours after the light turns off, so it might just be that they are sleeping? Other causes could be too little light, as I just switched to my new light, and are running it for the first time. Maybe I do not water them enough? The humidity has also increased, and is around 50-65%, maybe that is the reason? I also started using RO water, so could be something with the nutrients? Do any of you fellow growers have any idea? UPDATE: Big thank you to @Maltaherbman for your answer. I have raised the lamp a bit. I read 900+ ppdf on my phone before, and now I am getting maximum 800. This is properly not a correct reading, but at least I have it to compare with. I waited to see what happened after the light turned on. Ill took 2 new pictures, and the left lady is all ready recovered, the right one almost, so they might just have been sleeping, but ill keep the light as it is for now. Also a big thank you to you @GrowingGrannie - I keep the coco wet at all time. I have been flushing them a couple of times before, so maybe the watering volume this week is a little lower than usual. Also the watering volume is kind of an estimate, but I will take your advise and keep better track of how much I am watering, but I think its about 2-3L every 2-4 days
Likes
6
Share
@Chino8
Follow
Decided to start dark period(24-48hrs) day 85 mostly milky not much amber maybe some amber on the sugar leaves. I wanted to go 90+days with this auto but I needed the space in the tent for my photos and she looks almost ready, would’ve liked to see a little more amber but nevertheless I haven’t grown much at all so don’t have too much preference yet on trichomes. I’ll chop in a day or two and dry in my smaller tent and hopefully it goes well, my first harvest I dried too fast in low humidity and wasn’t that pleased with the end result. This time I’m planning on lowering exhaust speed and to not be so scared of 50+humidity in drying area and raise it to around 60humidity after a few days. Can’t think of anything else to write, but I’ll update after the chop and dry and 🙏 hopefully all goes well.
Processing
Likes
9
Share
@GetTheGat
Follow
Well 84 days later ...in Flower its was finally time to Harvest . I sure had my challenges as a beginner and learned a lot by my mistakes and learning about fixing issues and keeping the environment Consistent . I did turn my 600HPS down to 400 as i was my plants were getting light burn and heat burn ..... lets just say i was learning all the way throw . it was exciting being my very first time . I started flowering too late late and they stretched and stretched ... i dont have much space ....lesson learned . I had to train them to grow sideways which did help significantly as did the lower my light to 400 watts ..my space is a square Meter and low ...... it was crazy but I really enjoyed it and there hanging ..... Personally I thought id end up killin them ...lol Thanks for the advice and comments they were greatly appreciated ... Happy growing .... Hope my next ones are Prettier ,,,,LOL Cheers
Likes
15
Share
@Lazuli
Follow
Tangie 1 is flowering Tangie 2 starts flowering Blue dream is still in pre flower
Likes
4
Share
60x60 cm tent in a 1920's peek-in-closet Oversized vent for silence High power DIY LED True SoG 12/12 from seed with 15 plants in 2L pots Watering all plants in bottom tray with 30% of total pot size (10L) WEEK 1 DAY 1 - Germinated in paper towel DAY 3 - Planted into pots + Lights ON at 125w DAY 5 - All plants have broken soil DAY 7 - Slight stretch - Light at 185w WEEK 2 Two of the Iced Out are lagging behind, others are on point - I'm trying to push light and nutes to the max. Extraction fan (AC infinity Cloudline T6) on level 2. DAY 13 - First full watering (10L) with 20 ml Canna Terra Vega DAY 14 - Circulation fan turned on (low) during lights on WEEK 3 Good growth, two Iced Out still lagging DAY 18 - Light at 225w, Extraction fan on level 3 during lights on DAY 20 - 2nd watering, 8L with 30ml Vega + Light at 250w DAY 21 - On point, mostly :) Could've pushed nutes a bit more from the go
Likes
8
Share
This is officially my first grow. I have some experience with gardening and especially bonsai. Its going to be quite challenging given the limited height of my tent.
Processing
Likes
15
Share
@MG2009
Follow
LED is back, and the girls doing great..👍, will do more photos mid week.✌️✌️
Likes
57
Share
Well guys! home stretch! as you can see in the photo, harvest day is not far away)) Both plants look amazing! the structure of the Buds, trichomes, smell, stickiness and oiliness, all this is in excess!)) Buds are very solid and elastic .. very happy ..
Likes
10
Share
Day 64 my baby is going really well by now, she s been running fast until now and I think that’s enough with fertiliser. From today o start my flush, I will give today my last dose of regulator and from next irrigation just on controlled water until the end of maturation, I want this baby to eat everything . day 65 started flushing. ph controlled water at 6.0 i think 20 more days at max before m Day 68 First check with micro today. The baby looks already milky and amber on the top buds but the rest of the plant is still transparent. I’ll wait at least until this weekend for a re check maybe I’ll cut her in two rounds. As I be been watching a lot with micro I noticed so many dust and other stuff on the buds so I think I’ll wash her in water. Today watered ph 6. Let’s see! 🌱🔥🌱🔥🌱🔥🔥
Likes
5
Share
Very happy with how this lady has performed, amazing quality buds, very sticky and dense flower with a concrete smell that I love so much, which is that kind of fruity sweet flavor that this lady is able to produce, it's been a beautiful journey, I'm gonna enjoy a lot this flowers. Very recomended guys!
Likes
3
Share
@PoshGrow
Follow
Welcome to GhostGrow Chapter One by PoshGrow! 🌳 Week #10 June 28th - July 5th 7th week of flowering. Humidifier was raplaced with dehumidifier to maintain 50% rH. Week #10 day 1 Completely removed ScroG and did dead leaf removal and major clean up. Scrog did his job, but at this point, it does not help much now. I need clear access to all plants because few of them going down in week or so and other need abit more time to finish. Strange thing is that all Alaskan strain seeds come from one package, but they all different. Alaskan #2 still in first side of flowering and for example Alaskan #4 almost done... Same nuts, same pH, same watering schedule. Despite these few small isues, everything is going good. Buds are still packing up some weight, plants looks healthy, tought and dear god they smell... 😅 Also I think I manage the Alaskan #5 Nitrogen deficiency. Looking abit better and stopped yellowing. At the end of the week going to clean and preapare Alaskan #2 for flowering, remove popcorn nugs, dead leafs and all leafs that is blocking light to a budsites. I will upload some more pics and comment at the end of the week #10.
Likes
2
Share
Likes
15
Share
This was an auto that was not an auto. However, Loved the dank lemon coming off the phenotype so decided to clone it and do a full run to ensure I have plenty of weed while I wait for the seasons outdoor crop to be ready.