Auto Euforia

April 10, day 21, the Euforia is starting to take off. Lots of branching that will need to be trained low and wide to fill up as much of the 6sqft space as possible. I turned on my second HLG 100 light to bring the lighting up to 200w. I did this to make sure as many of the new branches have light as possible, as some of the fan leaves have grown is very thick and the plant is quite stocky. I raised the distance of the lights as I don't want to overdo it with the second one running and the internodal spacing is already tight. I pushed up the EC slightly without any issue, so 1.4 is around where I will stay through veg. I also have allowed the PH to range lower as I am less concerned about cal mag issues at this point. Fertigations will continue to be 1x per day untill the roots spread more and the coco dries quicker. Then it will be up to 2x or 3x per day as needed. April 12, day 23, the Euforia is growing well, while remaining very tight and bushy. I did some minor LST tying two dominant side branches down to start opening up the plant, but will need a bit more height and growth before I can continue with more areas of the plant. April 13 day 24, lots of vigorous growth and the LST is working to expose more new growth to light for this very dense little plant. Increases fertigations back to twice daily, for 20 second watering intervals. The 26 seconds of watering was barely producing runoff now that the plant is larger, so this increased watering should help keep the coco well flushed even when the plant is significantly large. April 15, day 26, removed some leaves blocking nodes and lower growth that will never develop. I don't like removing leaves when I don't have to, but the plant is growing in thick enough there needs to be more room for growth around the center of the plant. Also performed some more LST and leaf tucking. April 16 day 27, LST widening the plant and opening up the center to new growth. Removed a few leaves as needed. The Euforia is growing well and I am hoping that by the end of the flowering stretch it will take up the majority of the tent. One topmost branch that was growing in thin after the FIM had to be removed while still fairly young. It's connection point seemed so thin it made the branch extremely fragile, and I decided I did not want the risk of it falling off after spending a lot of energy on bud production that could be spent elsewhere. When taken off I could confirm that it was around 1mm of the branch that was actually connected to the main stock, which just isn't enough. I will keep this in mind for the future in terms of FIMming vs topping. RIP lil' branchy.