First off, I consider this to be the start of week 4, not week 3! Anyways the inzane auto is growing nicely. I made some changes to the environment as I have 30'ish plants in a 6x3 scaffolding set up so it's a very fluid and a constantly changing environment/space. I repositioned the 110w quantum board to angle more towards that area as I also have seedlings directly below the inzane auto. Below the inzane? How? I built a cradle and am hanging her from the ceiling! I should of never popped the inzane auto after starting a photo run a month earlier. Yet here we are. Oh and I fed her a light dose of npk nutes along with a rather large amount of beneficial bacterias I'm shoving into her ecosystem. I also added a 2nd uv-b light and ordered a 2nd uv-a for the grow. I installed the low stress training clips on her on Jan 2nd. All in all, so far it's been a smooth grow with her. Space has been the issue as the 5 gallon fabric pot the inzane is in is 4 gallons bigger than any other pot in my scaffolding grow, everything else is 1 gallon or less. Anyways thanks for reading.
@bioaccessory, hey bio, she's a super squat plant that shot out a shit ton of bud sites very low and I want that bottom stuff to catch up to the upper (wrapped) buds. Yeah I could decrease upper light etc... but I'm just going full throttle on this girl. Basically I put too much light on her and I'm slowing down the upper half from getting done and crispy before the bottom matures more. Happy growing my cannabis brother/sister!
Fascinating devices for stem bending. I wasn't aware of such tools, will definitely make use of them. ๐ฑ๐ ๏ธ
This diary brings back memories of my first grow, which also didn't make it into GrowDiaries and started off with a lamp as well. ๐๐ก
Wishing you a successful grow and bountiful harvests! ๐๐ฟ
@MyDearDiary, look into low stress training clips. They make them in various sizes and you can even make your own if you have a 3d printer. Happy growing!!