First off, I consider this to be the start of week 4, not week 3! Anyways the inzane auto is growing nicely. I made some changes to the environment as I have 30'ish plants in a 6x3 scaffolding set up so it's a very fluid and a constantly changing environment/space. I repositioned the 110w quantum board to angle more towards that area as I also have seedlings directly below the inzane auto. Below the inzane? How? I built a cradle and am hanging her from the ceiling! I should of never popped the inzane auto after starting a photo run a month earlier. Yet here we are. Oh and I fed her a light dose of npk nutes along with a rather large amount of beneficial bacterias I'm shoving into her ecosystem. I also added a 2nd uv-b light and ordered a 2nd uv-a for the grow. I installed the low stress training clips on her on Jan 2nd. All in all, so far it's been a smooth grow with her. Space has been the issue as the 5 gallon fabric pot the inzane is in is 4 gallons bigger than any other pot in my scaffolding grow, everything else is 1 gallon or less. Anyways thanks for reading.
@bioaccessory, hey bio, she's a super squat plant that shot out a shit ton of bud sites very low and I want that bottom stuff to catch up to the upper (wrapped) buds. Yeah I could decrease upper light etc... but I'm just going full throttle on this girl. Basically I put too much light on her and I'm slowing down the upper half from getting done and crispy before the bottom matures more. Happy growing my cannabis brother/sister!
Fascinating devices for stem bending. I wasn't aware of such tools, will definitely make use of them. 🌱🛠️
This diary brings back memories of my first grow, which also didn't make it into GrowDiaries and started off with a lamp as well. 😉💡
Wishing you a successful grow and bountiful harvests! 🍀🌿
@MyDearDiary, look into low stress training clips. They make them in various sizes and you can even make your own if you have a 3d printer. Happy growing!!