RelooM: Fruity curve

A lot has happened. Kept the two isolated from any work/care for 2 weeks while I was on vacation. That is basically the maximum amount of time until they drink the res empty. Unfortunately some clear slimey residue formed on the roots. Not to an alarming state but clearly a start to something bad. So: Full water change with a proper pot / res and tube clean. Additional to that I ran the system with a small chlorine dosage for a few days. Some good news: I got a new air filter, a bigger tent, new water and air pump. Expecting to see some changes for my next grow :) While changing the tent I also did another water change because I had to dismantle my system anyway cause the res is outside of the tent connected through some self made holes for the piping. Makes water adjustment and control easier. The PH controller got a some code review from me and my old calculation formula went into the garbage bin. After some research I found out that I left out some very important stuff. Trusting that device again! Also dialed in my ppm. Was starting a little too high with 800-1000 ppm. You can see that the ppm keeps rising after setting it. Meaning the plant wont take that much nutrients up (or got a lockout at some point). Leaving it like that would just kill the plant. So lowered it again to 700 and viola 7 days of happy and steady eating :). Now to the Plant itself: I mean look at her. Strong af and some quite remarkable side branches that will probably also get some wheight in flower. The root ball just exploded after I found the 700 ppm mark. Before that she struggled quite a bit and also would not grow for a week. Would have gone into flower already but I wanted to start flower with a thriving plant instead of a recovering one.