Banana Popperz

RainbowTreez GERMINATION (Day 1 - 14) Day 1: Mon 19th May - [ ] Remove the seeds from the package and allow them to soak in a glass of room temperature water for 24 hours in a warm, dark environment. Day 2: Tue 20th May - [ ] Transfer the seeds to an airtight container between layers of damp tissue paper, seal it, and let it sit for an additional 24 hours. Day 3: Wed 21st May - [ ] Soak the root riot propagation plugs in 0.5ml of voodoo juice per liter for a minimum of 5 minutes. - [ ] Remove excess water and gently place the seeds into the propagation plugs. - [ ] Cover the plugs with the humidity dome and position the propagator on the 30w heat mat. - [ ] Suspend the 100w LED light 10cm above the propagator lid. - [ ] Adjust the heat mat thermostat to ensure ideal germination conditions: Room Temperature 22-26°C, Room Humidity 65-75%, Dome Humidity 80-90%. Day 4: Thu 22nd May - [ ] Take off and clean the humidity dome. Day 5: Fri 23rd May - [ ] Take off and clean the humidity dome. Day 6 : Sat 24th May - [ ] Take off and clean the humidity dome. - [ ] Open the air vents of the humidity dome to facilitate airflow. Day 7: Sun 25th May - [ ] Take off and clean the humidity dome. Day 8: Mon 26th May - [ ] Take off the humidity dome and keep it off. - [ ] Administer 10ml of nutrient solution to each plug and pour 200ml into the bottom of the propagator. Day 9: Tue 27th May Day 10: Wed 28th May Day 11: Thu 29th May Day 12: Fri 30th May Day 13: Sat 31st May Day 14: Sun 1st Jun - [ ] Replace the propagation light with a 200w LED, beginning at 60% intensity, and adjust the light cycle to 18 hours on and 6 hours off. - [ ] Refill the 5-liter humidifier and adjust the environmental and lighting controls to ensure ideal conditions for the vegetative stage: Room Temperature 24-28°C, Room Humidity 65-75% - [ ] Fill the 2-liter square pots with coco, ensuring it's tightly packed. Insert an aerosol spray can in the center to form a hole for planting the plugs. - [ ] Place the plugs into the created holes, cover them with coco, and compact it around each plug to secure them firmly. - [ ] Use a syringe to water each plug with 250ml of nutrient solution, applying it around the seedling as they grow, feeding further from the stem. - [ ] Set the light to be 50cm above the plants initially, then lower it to 25cm over the course of the next 3 days. - [ ] Suspend the Exhale Co2 bag at a height of 1 meter above the plants, and install a 6-inch circulation fan directed towards the Co2 bag. - [ ] Seal the tent and check afterwards to ensure everything is functioning properly and optimal conditions are upheld. NOTES - Raise the light intensity by 5% daily for the next 8 days. - Following the initial dry back raise, raise to 500ml and continue to repeat as necessary.