Bioweed Highlighting the germination speed of the bubblegum from TH Seeds, which, even after being stored in the fridge for 6/7 years, were the first to germinate. A watering was done with 30ml of solution. In this watering, we added Micro Boom and Boom Roots at a rate of 0.5ml/liter. Climate parameters:
Humidity 75/80%
Temperature 24/26 degrees
VPD 0.6/0.8
PPM CO2 664
PPFD 150 µmol/m²
4 likes
1 comment
Share
Used method
Glass Of Water
Germination Method
1
Week 1. Vegetation
3d ago
18 hrs
Light Schedule
26 °C
Day Air Temp
6.0
pH
No Smell
Smell
350 PPM
TDS
70 %
Air Humidity
20 °C
Solution Temp
22 °C
Substrate Temp
24 °C
Night Air Temp
1 l
Pot Size
0.1 l
Watering Volume
60 cm
Lamp Distance
664 PPM
CO₂ Level
Nutrients 1
Root Boom
0.5 mll
Bioweed A week later, they have grown at a good pace, slowly colonizing the substrate. When needed, we did another watering of 100ml per pot using osmosis water to which we added cal mag up to 0.4 ec. By adding boom roots, we raised it to 0.7 ec and watered with a pH of 6.0. No anomalies in growth are observed.
We raised the ppfd to 200 µmol/m2.
The rest of the parameters remain the same.
4 likes
comments
Share
2
Week 2. Vegetation
3d ago
18 hrs
Light Schedule
26 °C
Day Air Temp
6.0
pH
No Smell
Smell
400 PPM
TDS
70 %
Air Humidity
20 °C
Solution Temp
22 °C
Substrate Temp
24 °C
Night Air Temp
1 l
Pot Size
0.15 l
Watering Volume
60 cm
Lamp Distance
664 PPM
CO₂ Level
Nutrients 2
Root Boom
0.5 mll
Crecimiento Boom (Growth Boom)
1 mll
Bioweed Second week since they were potted, and you can already see the difference between the bubblegum and the rest; they're quite a bit more advanced. This week we added boom grow at half the minimum dose, 1ml/l. The roots are starting to peek out from the bottom of the pot, and next week we'll transplant to a final 10-liter fabric pot and start a strong vegetative phase with apical pruning and low scrog net training.
We're raising ppfd to 250/260 umol/m2
Humidity is down to 70%
Temperature is between 25/26 degrees
CO2 ppm is 650
VPD is 0.8/1.2
6 likes
comments
Share
Used techniques
ScrOG
Technique
3
Week 3. Vegetation
2d ago
1/6
18 hrs
Light Schedule
26 °C
Day Air Temp
6.0
pH
No Smell
Smell
400 PPM
TDS
70 %
Air Humidity
20 °C
Solution Temp
22 °C
Substrate Temp
24 °C
Night Air Temp
10 l
Pot Size
1 l
Watering Volume
60 cm
Lamp Distance
664 PPM
CO₂ Level
Nutrients 4
Root Boom
1 mll
Crecimiento Boom (Growth Boom)
0.5 mll
Silic Boom
0.5 mll
Bioweed In their second week since germination, I've already done the transplant. I could have waited a bit longer, but I see they're growing really fast, and I preferred to do the transplant now to minimize stress since I'm going to do a SCROG and apical pruning, and I want to fill the tent well. I think the key to such rapid growth has been the substrate mix; this time I've used 50% coco top crop and 50% complete mix top crop. That extra aeration along with the perlite really oxygenates the roots. I watered them all with 1 liter to thoroughly moisten the substrate and avoid air pockets. I've lowered the PPFD from 300 to 250 µmol/m² until they recover from the transplant. The last photo is about 14 hours after the transplant, already recovered and reaching for the light. I'm surprised at how quickly they've bounced back; I expected a slowdown of 1-2 days, but they're pushing through like champions. The importance of the substrate and climate is key for the good development of the plants.