The Grow Awards 2026 🏆
Likes
Comments
Share
#1 Has stretched up and out! If she continues to fatten as tight as the other two, she will probably be the one with the most weight. Her branches are the tallest and reaching up at least 4-6 inches past both her sisters. Her main cola has some light bleaching, nothing I can do about that, we’ll see how she wraps up. #2 is going to be a producer! She has so many tips and they are all fattening and developing at about the same rate, she is going to be a beast! Her main cola is rock hard. Did a defoliation on her, she is appreciating the extra light penetration 😎💨 #3 is fattening up! She never did stretch, but then again I had her tied and trained pretty far out. She has been thirsty, I have been feeding a dose close to 700 ppm every other feed which has been every 3rd day for her. During the lower feeds, ppm has been around 275. Her tricomes are mostly clear, with some cloudy starting to show. She has the longest to go, but us already dense, and will only get better.
Likes
3
Share
Not going to grown this one so soon. There are plenty of better option from this seed bank. Could not reach buds as good as they ones from hulkberry. It's a bigger plant with more banana like buds and not so dense and round. But still a strong high and enjoyable smoke.
Likes
8
Share
We really like to test the great new products that Zamensia prepares for our growers, this time we have a great plant that we conventionally call Test #3, it is doing well both in the topping version and in the straight version that I will show you in a few days. We have just done the last topping that brings her 16 tops on almost all the plants after which we grow a few more days and off we go. During the topping the use of nitrogen is a very delicate subject. The topping cuts slow down the plant and the leaves tend to grow bigger going a bit in over, it happened to her then you cut off and it tends to discharge now we are at the moment that we are starting to give nitrogen again to then go into flowering. It is a process that must be nuanced very delicately. Ideally it is to start by preparing the soil with fertilizer and add if necessary. I went a bit in excess with the plants but it is something that I have always managed very well once I got to flowering. Next time we will add something to the fertilizer soil with this technique is very suitable. Wait the uncle BreadandBuds.... We are always using soil, feeding and all the recommended additives from Plagron 100% organic, we have only lowered the amount of grow in this topping phase for the reasons mentioned above. ---- Decide on the right soil and calculate your fertilizer sheet based on the soil on the official website. -- www.plagron.com Try a seed of this strain that drives us crazy.. -------- Strain Coming Soon! Try another Zamnesia Masterpiece instead Zamnesia Description // Strain Coming Soon! Stay Tuned! All the best that mother nature can offer is on ---- www.zamnesia.com
Likes
79
Share
@Hou_Stone
Follow
- Water: tap water at 300 PPM, I add 0.6g of Hybrid powder and 0.4g of booster PK+ per liter to reach 950PPM and I adjust the PH to 5.8. I water every 2 days because it is too wet, I water until the water runs out of the pot (to release the nutrients from previous waterings) -Daytime temperature: 21-26°C -Night temperature: 21-23°C -Humidity: 55-80% :/ too high -Lamp: Mars Hydro FC3000. intensity 90% at 35cm from the top leaves -Room: Mars Hydro 100x100x180cm -Extractor: Mars hydro 402 CFM Max. power 3/10 -Substrate : 70% coco, 25% perlite, 5% vermiculite. My instagram : https://www.instagram.com/p/CuMhQ_BsjRP/?utm_source=ig_web_copy_link&igshid=MzRlODBiNWFlZA== Looking for MarsHydro equipment for your crop? 🔥 You can use my promo codes! 🙏😻 3% off with "houstone3" for: TS LED Grow Light, Tent, Ventilation 5% off with "houstone5" for: FC&FC-E&SP LED Grow Lights; Grow Tent Kits https://www.mars-hydro.com/?acc=hou-stone
Likes
6
Share
The last week before harvest! I love Vanilla Latte Auto! Thank you Humboldt Seed Company for such a good genetics! I love you very much!...
Likes
6
Share
Week 4 of flower now plants are stoped the strech now and growing and packing on some size. Av struggled with some heat stress due to weather but they seem to be growing good and fine @growerchoice @SHOGUN COCO A 4ml/L 160ml @SHOGUN COCO B 4ml/L. 160ml @SHOGUN ACTIVE BOOST 2ml/L. 40ml @SHOGUN CAL MAG 1ml/L 20ml @SHOGUN PK WARRRIOR 1ml/L 20ml
Likes
22
Share
@Cauli
Follow
So far nothing special, everything seems to be fine. She had some sunny days at the beginning, but weather got cloudy and relatively cold – this has slowed her growth for sure. But want her to adapt well to her conditions, so only put her inside in really cold nights. She got her endpoint directly on day 3, it's a 9L airpot. root was already at the bottom of the small starting pot. so maybe this stressed and slowed her too. Let's see how she will grow the next days. Video for this week will follow. Filming quality of my phone is not as good as would have liked it. But working on it.
Likes
2
Share
A brown leaf revealed the moldy core of the bud. Based on this sign, I harvested most of the plant. otherwise the Plant did grow well and has some terps leaning to the sour, limone side. had to throw away about 8G modly stuff from main colar. Seems to be about 30-40g left without mold.
Likes
4
Share
Week 5 veg - clones and Week 3 - Blueberry Cupcake (Humboldt Seed Co.) and French Macaron (TH Seeds) from seed. G-41, Frosty Gelato, and Frozay Gas topped with 2 clones each taken from cuttings to propagate placed in 2x2 clone/seedling tent with low LED lighting. Temps in low 80F w/60% ROH. Clone cuttings covered with sandwich bags used as humidity domes. After taking cuttings transferred G-41, Frosty Gelato, and Frozay Gas to 3x3x6 AC Infinity tent under Mars-Hydro FC-E3000 set at 50 percent power (PPFD range for veg). Black Cherry Gas clone, Blueberry Cupcake, and French Macaron from seed remain in 2x4x5 AC Infinity under Spider Farmer SF-2000 with dimmer set at 50 percent power (PPFD range for veg). Continued twice weekly IPM foliar treatment with Organishield as well as watering soil program (SP).
Likes
62
Share
Happy 1 Month To My Girls (Inserts Celebration Emojis) I’m Very Proud Of The 1st Month’s Progress These Girls Has Really Exceeded My Expectations. I’m Very Proud Of The Of The Purple Power If You Go Back To Week 1 You Will See That She Started Off The Slowest But She Is Now The Tallest In The Pack Standing At 21 Inches (that’s without adding the few cm I covered with soil) She Has Also Shown Signs Of Purple In Her Bud Development (Favourite Color) Can’t Wait To See Them, You Go Girl! I’m Also Proud Of The Gorilla Glu (12 inches) Stardawg (17 inches) And Girls Scout Cookies (16 inches) Development, They Are My Favorite Buds Here In The UK. They Are Very Bushy & Branchy And Their Stems Are Very Thick. They Have The 3 Main Pillars To Accommodate BIG Buds. Happy Growing Everyone. #OwlGang #AGrowingEmpire
Likes
4
Share
Alright Robust in the original shape of a Christmas tree, its thick leaves and well-resined flowers the pistil phase starts to turn orange the trichomes we can go further to have milky with amber, and enjoy its performance until the end its smell is very strong it is sweet .
Likes
19
Share
Let’s Go Day 67 from seed !! So this week went real great! 2 Ogreberrys an Bruce Banner started getting flushed! The rest will follow up and start flush next week ! Today the 3 will continue getting flushed while the 3 others get there dose of nutrients, PHd at 6.5! Let’s grow lil ladies let’s grow!!! You all have an amazing productive day as well as a a great safe week !! Peace love and positive vibes to y’all Cheers 😶‍🌫️💨💨💨💨🤙🏻If there’s any questions please ask, I’ll be opened up to answer at best of my knowledge! Thank you all have a dank day !!
Likes
70
Share
@MrJones
Follow
Sky Walker ~~~~~INDOOR~~~~~ DAY 141 Above Dirt 💬SUNDAY 01.13.24 - So this is the update that I did not have time to do over the weekend, the girls are bouncing back from the hard time I put them through last week, and the flowers are starting to chunk up along with more foliage, however, there will be no more defoliation until we are close to completion, for now, its just water, and wait, allowing the Gaia Green to do its thing, the light is at 100% and the girls love it. ~~~~~~~~~~~~~~~ 🌱Sky Walker 👨‍🌾🏽Sativa Jones 🌤️@Medicgrow420 SeedBank Seeds 📝@gaiagreenorganics 📝Bokashi Biochar ~~~~~~~~~~~~~~~ 📝 Skywalker OG Strain is a top-shelf Indica dominant hybrid. It is a cross of Original Amsterdam Blueberry, OG Kush, and the indica strain Mazar from Afghanistan, and is best known for its super potent effects and sky-high THC levels.
Likes
8
Share
Likes
19
Share
@DrLaggis
Follow
🌱 Day 57 - Start of the Second-to-Last Flowering Week 🌱 Hello, Grow Friends! Today marks the start of the second-to-last flowering week—Week 9 overall, and Week 5 of flowering. 🌿 I’m getting more and more excited as my first grow nears its end. As I approach harvest, I’ve decided, based on my research, to stop feeding nutrients and stick to just pH-adjusted water for the final two weeks. 💧⚖️ Watering Routine: I’ll keep the same watering schedule—1 liter every two days, which is about 10% of the pot volume. 🌱💧 This should be enough to flush out the remaining nutrients, ensuring a clean finish for the plant. Temperature & Humidity: The temperature remains stable between 19-23°C, which I believe is ideal for this stage of the grow. 🌡️🍂 No more high temperatures to worry about! The humidity is fluctuating between 45-58%, and I’m keeping a close eye on it to stay below 60%. 💧🔍 Everything seems on track for now. 🌿 Plant Health & Growth: The plant still looks very healthy overall. 🌱💪 However, I’ve noticed that in the past three days, there haven’t been any visible changes in the size of the buds. 🤔 It could just be that I’m not seeing the growth clearly, but the only noticeable change is the daily opening of new flower calyxes. 🌸 Harvest Preparation: I’m already getting my equipment ready for drying after harvest. 🛠️ Once it’s time to cut, I’ll be hanging the plant to dry for the first 10 days. 🌿✂️ I want to make sure everything is set for a smooth drying process. Stay tuned for more updates, and as always, daily photos of the plant will be posted! 📸🌱