The Grow Awards 2026 🏆
Likes
Comments
Share
Week 8 flower and the OG Kush looks like fire 🔥 so frosty and covering everything. I thought this seed was a dud but it is definitely not! Flowers are not huge but that’s ok. Tight, frosty, and the smell very nice and getting stronger. The development is slow and has been since the beginning, might be something I’m doing or did, not to sure? Lights are at 12” and she is responding well. Looks like about two weeks to go. TS 600’s have done well again! Blimburn OG Kush seems to be producing some potent looking flowers. Need to do a better job taking care of the fungus gnats moving forward. Thanks for the view!
Likes
1
Share
I soaked 3 Laughing Buddha seeds - 2 developed a taproot - 1 bad I soaked 3 Acapulco Gold seeds - 2 developed a taproot - 1 bad I soaked 3 Amnesia Lemon - All 3 were bad and did NOT develop a taproot I also tried the paper towel method on 2 Amnesia Lemon - Both were bad and did NOT develop a taproot Seeds were soaked by using 75F degree water, water was kept warm using a heating pad over night, cups were covered to prevent light leaks Seeds were sown on wet paper towels inside of a plastic baggy, covered and placed on heating pad for warmth at 75% water PH level 6.4 4 seeds that developed at taproot were placed in 78F grow tent, 80% humidity, 16 hour light cycle, lights 24 inches away, light meter reads around 250 with the plants moved off slightly to the side of a 4x2 tent 5 foot tall. Carbon filter not used as it was taking the temperature and humidity down too much. I DO NO RECOMMEND BARNEYS SEEDS - THEY DO NOT STAND BEHIND THEIR PRODUCTS I was offered a 30% off coupon on a future purchase, but I was not compensated for their out of date seeds. worth of garbage seeds, one strain would not germinate and the other two strains did not fully germinate. Customer service was condesending and rude.
Likes
18
Share
June 7 - We ordered some new lights last week, they are 240w kingbrite samsung lm310h with uv/ir, 3000k, and meanwell drivers. We setup the new room and moved the girls into there. After a bit of LST and a watering (with nutrients) at roughly 7ph, they were ready to go under the 2 new lights and the same SF-1000 we have been using in this grow. The new room is a 12 ft enclosed trailer. I moved everything from the small tent into this. I put clear poly on the walls, floor and ceiling. I put poly on the shelf I am going to be keeping in there as well. I bought 50ft of 6mm mylar and lined the floors, roof and sides with it. I plan to get some reflective tape to seal everything and to cover the wood. I did not get much of a chance to watch temp's today as they it was later in the evening after all was said and done. The inline fan blowing in air from outside. June 8 - 9 AM i checked the plants, they were at 25.2 and 50% RH. Late through the day I had checked and we had gotten up to around 32 degrees. So I moved the inline fan to the closer vent, hooked up to that, and had the air blowing out of the trailer with the inline fan sucking it from above the lights. I then added oscillating fan and had it blowing air on the left side of the room so it would somewhat circulate once I closed the doors. I then checked at about 9pm and we were at 22 degrees. Definitely noticed a decent amount of growth already. I have the lights on a 22/2 cycle as I was worried about the heat at night time. June 9 - Some great growth from the girls, still having problems controlling the temps in the afternoon. I decided to prop the door open a bit to have a constant breeze throughout the day while I am at work. Decided to do some more LST and also a bit of defoliation. I took about 25% of the leaf's that were blocking the new growth as it was getting a bit bunched up. I was then told the leaf's are almost solar panels for them. So from now on I will be trying to just do some tucking unless needed. The leaf's I removed were most of the damaged leaf's, I am not to sure if that makes much of a difference. I gave them a watering with only water as there is a potential I am getting a bit of a nutrient buildup along with the PH problem. Or potentially the reason for the ph problem is nutrient buildup. After watering with A PH of 7 I got some run off and tested it. The smaller plant gave me a PH of about 5.5 where the bigger one is around 5.0. June 10 - Plants are looking happy and showing tons of growth. Seems to be trying to stretch outwards. Not a ton of sign of PH issues showing so potentially getting it under control. Still a bit of damage to previous leaf's but it is what it is! The last few days I have been leaving the door open a bit in order to keep the temps down. I decided to test something and turn the lights off (automatically) at 11AM and back on at 5PM so light schedule has now changed to 18/6 and it seems I may have figured out the issue. We haven't had lots of sun the last couple days so it hasn't been to hard and I have yet to know if it truly fixed the heat issue for now. (I will be looking into a ac unit as well since it typically gets to around 30-35 around here. June 11 - Pulled some of the branches back down and added a few more LST spots. Seems we have a good amount of growth from the smaller plant out of the 2 topped spots. Unfortunately it looks like I fucked up on the bigger plant and only one of the nodes seems to have new growth. I will continue to monitor that but I think I cut the node to low and also to soon. Other then that, the girls are doing great. They seem to be absolutely loving these new lights. I gave them some nutrient water today as well. roughly 3L each. They seem to be A hell of A lot more thirsty under these new lights. June 12 - The girls are doing great , they are still just doing growing away. Lots of progress everyday. I am going to be getting a go-pro so I can set-up a time-lapse for the rest of this grow. I received my new inline fan, I got A ac infinity CLOUDLINE T4 with the temperature humidity controller. I am going to be having one fan pushing fresh air in and one fan pulling out the hot air. I will be doing that tomorrow since I have to work today. June 13 - I ordered another 50ft of mylar and that showed up today. I have decided to remove the shelf and add another 3+ feet to the grow space. So today I installed more poly, mylar, the ac infinity fan. I have it set-up to pump in air if it gets to warm. I am thinking of switching it to the output that way if it gets to hot or to humid I can have that air pulled out of the trailer. Right now my other inline fan is the outtake and I just have it set on full. Overall I think everything is set-up a bit better and more accessible. I will be putting my 2x2 tent in there at the left of the doors so I can have a veg room when these 2 are in flower. I plan to have 4 in veg and 4 in flower for the next grow. Still waiting on JOTI seeds, ordered 3 weeks ago and still have not been shipped. I will be getting those going the moment they arrive. The girls seem to be happy still, did a bit more LST to try to keep everything even, mainly I'm just pulling down on the spots I already have tie wire on.
Likes
43
Share
@Targona
Follow
Hello GrowDiaries friends. 74 days since my little girl sprouted from seed/harvest time🌱 Technical and general parameters from the breeder Original Sensible Seeds: OG Eddy Lepp Auto 💚🌺💚🌺 Growing OG Eddy Lepp Auto by the breeder: OG Eddy Lepp Auto is a cannabis strain created in honor of medical cannabis activist Charles “Eddy” Lepp. With a predominance of indica, it produces dense spherical buds with a rich dark green color and a touch of dull brown, which highlight the bright orange pistils that sparkle like flames. From seed to harvest in less than 70 days My experience: I made two major mistakes when growing - high pH at the beginning of flowering and over-fertilizing during one watering 💩💩 It affected all the plants in the tent. Some more, some less. This plant was one of the more resistant ones. Autoflowering plants are very sensitive, this strain did very well in this test. I really like it and it has incredibly hard and thick buds 💚🌺🌱 I am really very happy with the harvest result 👍🌞 OG Eddy Lepp Auto strain data sheet Brand: Original Sensible Seeds Parents: OG Kush × Grape Ape × autoflowering genetics Genetics: Hybrid 50/50 Flowering type: Autoflowering Flowering time: 60 - 70 days THC: 22% CBD: Low Terpenes: Dom. terpene: Limonene Other: Myrcene For growing I used: ---------------------------------------------------- Growing tent Mammoth PRO+ 80: 80x80x180 cm 1x circulation fan: 15 W 🌬️ LED lighting: Mars Hydro TS 1000 - 150 W - vegetation and flowering 💡💡 Exhaust: duct fan - RAMTT100 🌬️ Odor filter: carbon filter PRO-ECO HF 160-240m3/h - 100mm - maximum air flow up to 240m3/h 4x Airpots 11 l I mix the substrate: Biobizz Lightmix + Perlite + Coco coir For sale here 👇👇👇👇👇👇👇👇👇👇👇👇: ⚡⚡⚡⚡⚡⚡https://originalsensible.com/original-sensible-seeds-og-eddy-lepp-auto~22667 ⚡⚡⚡⚡⚡⚡ Thanks for the likes :) See you soon 😍😍
Likes
10
Share
@Jerrza
Follow
New week, plants start to produce loads of sugar and a strong smell is coming trough
Likes
9
Share
@Scoota710
Follow
I decided to top her at the beginning of week 3 and she did super well! More than happy with all the extra growth I got from doing the Topping. Just debating on doing some lead stripping on it to allow more light into the bottom and center of the plant
Likes
4
Share
Likes
7
Share
Well the finale is here 76 grams from this plant buds are pretty nice and large. Stay turned for next grow !
Likes
13
Share
@RoyColt
Follow
Always R.O Water Watering the plant 3 times for per week 1st Watering with nutriens. (750 ppm) (13.03.2023) 4 liter 2st Watering with nutriens. (750 ppm) (16.03.2023) 3 liter 3st Watering with only R.O water & CalMag. (300 ppm) 4 liter 1000 PPFD