Likes
Comments
Share
First week of flowering. The plant will stretch, so i adjusted the LED dimmer to 100%. Did a good defoliation too. Doing good, very healthy big plant. It grew a lot of ramifications.
Likes
Comments
Share
@Chamed33
Follow
We at week 5 Flower and the buds are still pushing !! From week 1 to now I did not encounter any issues on the plant
Processing
Likes
3
Share
@Dico29
Follow
Day 101, been cutting off fan leaves on lower nodes, adding ice cubes and spraying cold water on buds. Expecting about 5 more weeks till harvest but I don’t know just guessing Also I don’t know how to change the question so I’m gonna put it here, has anyone tried to defoliate some smaller colas then tie them together will that be beneficial for bigger bud(promote one another) or is it better to leave oxygen to pass through, thanks
Likes
7
Share
Date: 30.09.2024 So the green gelato is doing fine inside shes kinda starting to turn purplish red on some parts of her buds. The 2 Lemon Cherrys are still outside Im starting to lose hope for the 2 girls but fck it hope will still get smth out. Date: 04.10.2024 Sooo I think that the gelato is going to get chopped down in the next 2-3 weeks. The 2 Lemon Cherrys aint getting any where with the weather atm so I think im just gone give them a few more weeks and hopefully this strain will be good enough for a bit of rosin or IceOLator
Likes
Comments
Share
Hi liebe Community and Welcome back! 💚 Ein schönes Wuchsbild verreint mit einem doch unterschätzen Stretch! Die Pflanze hat innerhalb der letzten 3 Wochen einen starken Stretch von knappen 23 cm hingelegt. Das bedeutet, das die Diesel Sativa Gene jetzt voll durchgeschlagen haben. Nach dieser Woche kommt der Stretch jedoch zur Ruhe und Mann sieht der Pflanze an, das sie sich jetzt auf die Blütenbildung konzentriert. Die Trichome fangen an zu sprießen und ein säuerlicher Geruch sticht langsam hervor, so wie es gewünscht ist. Auch die Blattform wird an den oberen Trieben immer schlanker. Die Blütentriebe bilden sich immer stärker aus und die Stigmen fangen richtig an zu sprießen. Bei diesem Genotypen, ist das Wuchsverhalten weitgehend ähnlich, nur die Hauptwuchsphase war mit etwas kürzeren Internioden abständen geprägt. Der Stängelabrieb duftet schon stark nach säuerlichen, dieselartigen Nuancen, mit einen etwas GMO typischen Aroma. Die Wachstumsbedingungen im Growzelt sind aktuell wieder super! ——————— 🌞 Temp: 22°C 🌚 Temp: 20 °C 💨 RH: 53% VPD: 0,91 kPa 😎PPFD: 830 mqm ——————— Stay Tuned! 💚
Likes
17
Share
This week in my grow room has been full of developments. First, I added additional lights because I couldn't get the relative humidity (RH) under control. I ordered a dehumidifier, but it will take a few weeks to arrive, so I had to find a temporary solution. I also emptied the reservoir and refilled it with fresh water and nutrients. I secured the net to ensure it stays in place under tension. In two days, I plan to switch the light schedule to 12/12, hoping the plants will stretch a bit during the switch to avoid having overly large buds that aren't evenly spread. Seventeen hours later, I decided to keep the lights on a 16/8 schedule for a few more days. The plants are starting to show signs of something happening, so I want to see how they develop. I will keep you updated on the progress. Then, I received a message from my supplier that the dehumidifier would arrive today. Great news—time to spice things up! On June 2nd, the dehumidifier arrived, and I managed to get my Vapor Pressure Deficit (VPD) to 1.17! This is fantastic news, and I'm very curious how this will affect water usage. The dehumidifier seems pretty powerful, with water literally dripping out of the hose, so I'm no longer worried about high humidity levels. It's a shame it doesn't have a range setting, but I couldn't expect more for the price. I'm considering ordering the Dimlux Auxbox to set a working range and separate day/night settings. Thankfully, the dehumidifier has an auto-restart function after a power loss. On June 3rd, the night is over, and while my values are now more stable, I haven't noticed any significant differences in water absorption. What I do notice is that the pots seem much drier. The difference in leaf temperature compared to the room temperature has increased slightly, now about a 2˚C difference, indicating that evaporation has increased somewhat. Despite the dehumidifier cooling the air, the room temperature has risen. This is explainable since dry air heats up faster than humid air. The CO2 heater is also running significantly longer. So, although there are no immediately visible differences, there are indeed some changes. Today is the last short night of 8 hours, and tomorrow will be the first night of 12 hours. I am contemplating doing a 10-hour night first and will decide later tonight. After closely reviewing the video footage, I noticed some divergent colors on the leaves. My pH is currently 6.4, which I had adjusted to compensate for the low pH last week—a foolish decision in coco, I know. I plan to make videos of each individual plant for my records to investigate further. The light is too intense to inspect them up close, so the videos will help me get a better look.
Likes
2
Share
Likes
56
Share
Bonjour à tous les padawans et les maîtres jedis La semaine 4 est déjà là! Décidément cette plante est vraiment exceptionnelle! Elle représente la force et j'en suis fier 😍 Je me donne pour defi que durant mon LST je fasse faire au tronc un tour sur lui meme. Ma plante est saine le LST ce passe relativement bien je l'ajuste tout les jour je le combine avec la technique du pincage d'Apex cela me permettra d'avoir une canopé plus homogène donc une meilleure pénétration lumineuse et par conséquent un meilleur rendement. Le pinçage est une pratique courante en horticulture. Beaucoup de cultivateurs l'utilisent pour améliorer le rendement de leurs plantations cannabiques ou autres. Il est souvent question de 'taille' des bourgeons apicaux. Cette taille se pratique également mais il n'est plus alors, à proprement parler, question de pinçage. A l'instar d'une taille, le pinçage va permettre de stimuler le développement des ramifications tout en préservant les sommités en vue de la floraison. Il est très utile pour uniformiser une canopée. Pour réaliser le pinçage, il vous suffit de presser 'fermement' la tige [entre le pouce et l'index] aux environs de l'apex jusqu'à sentir un léger 'crAck'. Cela aura pour résultat d'endommager les vaisseaux impliqués dans la circulation de la sève [situés dans le pourtour de la tige], la tige conserve toutefois une certaine rigidité. Pour obtenir le même résultat, il est également possible de vriller légèrement la tige sur elle-même. L'interruption du circuit d'alimentation entre le ou les apex et le reste du plant va provoquer un déséquilibre hormonal qui aura pour conséquence le développement des ramifications antérieures au point de pinçage. Jour 25 j'arrose mon pot normalement avec un quart de son volume en eau toujours avec un PH de 6.3 à cette eau j'ajoute 0.7 gramme de greenhouse feeding enhancer pour favoriser son développement racinaire. Par la suite je n'aurai plus qu'à ajuster mon LST jusqu'au stretch et surveiller mon arrosage, Je pincerai mes apex suivant la pousse de la plante pour uniformiser la canopé. Jour 26 à force de patience et de délicatesse j'ai réussi le défi que je me suis fixé en faisant faire au tronc un tour sur lui meme (photo jour 26) ce défi ma permis d'améliorer grandement la technique du LST. Au-delà de ça cela ma permis de donné au tronc une structure en forme de colonne vertébrale ce qui a pour conséquence une meilleure pénétration lumineuse et une belle canopé homogène. Que la force soit avec vous 💪
Likes
175
Share
the stretch has begun. in just 9 days the flowers are gonna start to form. i've been trying to give the plants more support. i placed a bunch of Bamboo through the cages to support the branches and placed a net on the smallest plant. ( the net's holes were too small, so i cut it up. only problem, since i can't reach the other plants that well i can't do the same for them. yet.) i'm working on it, i haven't had that much of time lately to work on the plants and the weather isn't helping either. most of the plants reached the height of 180 centimeters and maybe 190 before flowering. curious how big they will become when it all starts.
Likes
14
Share
July 31: Another week of warm sunny weather coupled with thunderstorms bringing a decent amount of rain. Flowers are stacking and resin coming on thick developing complex odor. Harvest coming in a couple of weeks.
Likes
12
Share
Big week here. The girls got moved into the tent and also into the Autopot system. I'm excited to see how the Autopot performs! There appeared some burns, I had been busy with xmas, so I didn't had that much time to attend them. I believe they will get back on track now. The biggest challenge is to keep the PH stable in the water tank.
Likes
27
Share
Harvest day 68 since time switch to 12 / 12 h Hey guys :-) Finally it's time 💚 The lady is done the large leaves have been removed and hung upside down to dry in the dark drying room. You can now stay there for 13-15 days at a temperature of 18-20 degrees and 55-62% humidity. After 13-15 days it is neatly trimmed by hand and placed in jars with boveda packs 62. After 4 weeks Boveda 58% come in and are ready for testing ;-). After everything has been cut cleanly, the last update comes with the smoke report and the finished pictures. Let's get to the plant 💚. First of all I would like to compliment Green House for this genetics. Unfortunately, the rating system at Growdiaries is a bit strange because I have to give the stars before the Smoke Report and in the end it might have led to more stars in terms of taste. Unfortunately, this phenotype is nothing special, which is very annoying given the price :-( The smell is ok, but nothing great, but the high is good, which is less important to me. Have fun and stay healthy 💚🙏🏻 👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼 ‘Powered by GreenHouse Feeding’ Copy the link for 10% off all Nutrients 👇🏼 http://shop.greenhousefeeding.com/ affiliate/madelngermany_passiongrower/ 👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼👇🏼 Water 💧 💧💧 Osmosis water mixed with Cal/Mag (24 hours stale that the chlorine evaporates) to 290 ppm and Ph with Ph- to 5.8 - 6.4 MadeInGermany
Likes
3
Share
Likes
30
Share
@PapasGrow
Follow
Kosher Haze fem 🚀 50/50 Hybrid (Kosher Kush x Karel's Haze) From Super Sativa Seed Club 💎 And seedbank.ge 🌱 Flowering with Mars Hydro FC 3000 🚀🚀 Also added some UV leds for finishing up. Flowering week 8, super frosty flowers, almost ready. Flushing... 💦 Day 60 trichome check video. Not ready yet, about 5 days away from harvest. ✂️
Likes
3
Share
Daily feeding, Heavy flushing this week to balance PH and EC. Recalibrated PH and EC Meters.(Found PH meter of by .3 lower than meter showing, and EC was .3 Higher than what meter was reading.) Working the smaller side of the tent to the scrog net and planning to flip to flower in the next 2-4 Days about 2 weeks behind schedule due to Slower growth on the left side of the tent. Flip at end of week.
Likes
8
Share
I like how the buds get bigger and bigger. Its a very special strain, need to grow the banana purple punch more.
Processing
Likes
6
Share
growing happily along, platinum yeti stretching more then sour 76. defoliate day 21 . smell starting to come on, stopped using foliar feed this week, been on top of hitting compost teas every single off watering (1 feed heavy 16 nutes, 1 compost tea when coco dries. repeat).