Recommended
Likes
Comments
Share
Likes
12
Share
Plants rebounded completely, no deficiencies to be seen. Leaves were twisting from excess blowing air. Positioned fan higher, instantly solved the problem.
Likes
Comments
Share
@MrStarOn3
Follow
At the end of week 3 I topped one of the strawberry cough they are all looking good and starting to veg I’m all caught up with the grow diary’s and will add at the end of every week. I’m in Australia and did start a little late into the season but hope to get a decent grow in they will be at my brothers once transplanted and he has a few aswel that I will add into the grow log nothing but sun and water only use a little thrive that’s from Bunnings that I get from my pops shed. They will be in a nicer cleaner soil when transplanted into veggie beds and will have chicken poo as a nutrient source first time ever using chicken poo so see how it goes. Will keep the grow log updated and hopefully everything goes all well for the travel and transplant for the plants in the next few days
Likes
14
Share
@b_deal
Follow
This week was amazing guys. I literally watched the buds getting fat day by day. I am still feeding with a similar program and adding Aptus Regulator once per week to boost silica and some other minerals like molybdenum and boron. I'm flowering my plants in a hot environment with CO2 boost. PPFD is high to support these settings and thankfully my the pots aren't getting hot. No fungus gnats or any other pests, no root rot and bad smell. Everything is perfectly neat and buds are exploding. My expectations from this harvest is really high and I'll keep adding CO2 for another week. Some fellow growers asked for CO2 and PPFD measurements. I am sharing these information on this week's pictures. I got my CO2 meter fixed and I tested the CO2 PPM in different places of the canopy. Typical value for this grow tent with this CO2 setup is around 1100-1350. Temperature is fluctuating between 28-31 and the average PPFD on the bud sites is 1100 micro moles. I'm sharing CO2 measurements right under the fan, where you expect it to show the lowest value. Then I'll also share the CO2 PPM value coming out from the air pipe, which is normally attached to the grill of the fan. Direct output is now around 5500PPM and in the first two days, the meter shows 10000PPM which is the max value that it can reads. This bucket yeast CO2 reactor lasts for four days and I'm refreshing the mixture twice a week. This is huge CO2 with a fairly low cost compared to propane burners or CO2 tubes. Edit: I refreshed the CO2 bucket today and got you guys a video of the direct output. The system is outputting more than 10000PPM of CO2 and the meter can't measure it for the first two days. This CO2 method is a killer one for tent grows. Very low cost for very high CO2 concentrations. Hope these information helps. Happy growing 💪
Likes
9
Share
Day 83 she’s looking beautiful and bulking so fast. The time is coming soon. I can’t wait. She is looking fabulous. Just keeps chugging along. She will begin the ice flushing process soon and she’s so damn heavy she’s being held up.
Likes
Comments
Share
Germination Week: These cuts were taken from the Bay Berry Mac 2nd round growdiary. I waited for the sex to show and took cuts from the bottom four(4) branches. I chose to wait because of the let down from the 1st attempt, which turned out to be male. This is my first time trying to reveg a cutting. As you will see.. There was successful rooting of all four(4) cuts. placed into cloneking and three(3) days later showed first signs of roots. after just a total of five(5) days the cuts were placed in soil. Being in no rush due to space constrains these were kind of justt left. didnt water too often... not too much care... As we get to flower you will see a total of two(2) plants. One plant was placed into flower too soon....that plant was pulled. One plant showed slow growth and did not want to continue with that. Thanks for checking out this grow
Likes
1
Share
@Adm023
Follow
Ojalá pueda revegetarla así hago una buena madre e revegetando muchas pero aveces no me sale tengo varias madres
Likes
24
Share
@MikeyP
Follow
Started the week at 725 ppm which was stronger than I meant to. Remixed on day 38 to 650 ppm. I've been adding the ph up incorrectly. Noticed some calmag deficiency in the last day or two so I'll be upping the calmag to 15 ml. She seems to be doing well. I'm losing the battle against the smell. My whole house smells like dank.she drinks 1 gallon every 24 hours I only add ph'd water between feeds. I cant believe she grew 7 inches this week!
Likes
4
Share
Now we are at exceptional levels. The plant is very florid, healthy with large leaves and large and resistant branches, the trunk is really scary, I hope everything promises super branches. In my opinion the topping is true that slows down the harvest but because it slows down the forging and the plant manages to grow very well when it starts. We are using for the protection of Neem oil + potassium soap at the right doses plus a nutritious foliar Lord Grow that protects, nourishes from from Co2 via leaf.
Likes
90
Share
@AsNoriu
Follow
Day 50. Had big plans, but postponed them to monday/tuesday. Will strip and heavy bend/lst girls, give them 5 days and i think they will be ready for flower. Increased light power output from 50% to 70%. Girls got water with 0.5 ml/l Fish Mix. Overtimes and all weekend at work stops me a bit, but work is work ... Day 54. Girls got heavy training, started it even too late, leaves were too droopy. All went good, while last one was done, first were somewhere "happy" ;))) Pure water. Think to send them to flower this weekend. Day 55. And like nothing happend ;))) All girls are happy and bushy, one or two days, darkness and FLOWER TIME ! ;) Happy Growing !
Likes
60
Share
@m0use
Follow
The time has come! Flowering has been initiated and is off to a good start, The Photoperiod is now running at 11/13 on/off and the intensity of the light has been bumped up to 60% giving me a DLI of aorund 37.5 at 30" hang height in my 2x4. As the plants where topped a bunch I have found in previous grows the stretch will not be as crazy as if I left them on their own, however the increased pot size may negate that effect, only time will tell :D I also gave them a 2nd watering as the last one was leaving the pots a bit to light. This could be their new normal 1gal one week, 2 gal the next separated by a few days. They have all been amended with a 50/50 mix of grow and bloom from Gaia, Also added in some extra Insect Frass, Yeast and Bokashi grains, mixed this all with worm castings and compost for the top dress. added the compost after mixing it into the top layer so it gives it a bit of a blanket. made a little video of it and me watering the plants on a speed run. One thing I need to find is a sprayer head that has a 70-90 degree bend on it. I'm tired of watering from overhead as my wand is straight and does not have a bend. Its made of hard plastic and was thinking I would toss the tip in the oven to soften it up and place a coat hanger though it, then bend it ever so slightly and wait for it to cool, can snip off the wire and pull it out once its all done and have a bent tip. or I can get a 2nd wand attachment for it. Just been so busy have not had time to search for it, the peppers are doing much better as well, after the defoliation from last week they where getting a bit more light but that is all gone now, the plants have taken it back. and they are in shade, the plants seem to like it more. only the one strain likes the intense light of the led's, Fatalii peppers, It might be the hottest ones I'm growing if the goronong don't measure up. The JigSaw peppers are also starting to show some of their variegation in the leaves that make them pretty to grow now they are in the shade more. and its bound to be better then pure purple leaves from the LED"s Butterwort is eating all the gnats as well. so no problem there. Will apply the nematodes later next week to kill em off in the medium. Don't want them getting trapped in the flowers. stupid little fuckers. I left out some of the extras in the water this week as it was its first topdressing, didn't want to stress it out to much, I will be topdressing every week and diving the total ammount of amendments in 4 parts. vs one big feeding at beginning of the month like its been suggested on the label, I find this helps avoid the N burn I normally see and gives them a bit better of a breakdown for flowering period. It worked really well with my G13 Labs Blue Cindy grow so I am repeating the process and will likely make this my new standard. I will also be adding in some Mg into every other water till stretch is done same with a very light feeding of molasses, I know it has been negative in past grows but going to try it out again with much smaller amounts. 1tea/pot, the extra sugars should work wonders on the Bokashi added into the soil and allow it to thrive. Plants are starting to get more of a funk to them as well, So i feel that's what was happening with the gifted plant to my parents smelling up the place, it was just entering flowering as it was not in a tent n the lighting must have been to low. And the little cuttings I did last week are fine, no roots but will soon have a bunch of little clones to go. Just in time for spring. I think that's it. Big shoutout to Medic Grow for sponsoring the lighting in my tent, They have provided me with 2x Mini Sun 2's in the 240w configuration, They use the v1 growing spectrum that is a all purpose seed to harvest spectrum so their is no hassle of switching it mid grow. If you interested in learning more about Medic Grow products please visit the web link below. https://medicgrow.com/ https://growdiaries.com/grower/MedicGrowLED
Processing
Likes
22
Share
@420_TRON
Follow
overall very satisfied with the results and can't wait for the drying and curing to finish so i can lit one up!! the growing process wasn't that hard until she stressed during one of the training sessions and i had to cut off 2 colas during the veg cycle. for my first harvest ever i'm pretty happy with this little beauty:) day 2 of drying: weight dropped by half. total is now 50g and there's some more to loose 🙈 started curing the buds after 4 days of drying- overall 20g of dried buds ------ first taste 👅 (2 weeks curing): man it was worth waiting for an acceptable curing time before digging in, i tried it twice before and i have to say that curing plays a huge role when it comes to flavors, scents and high (so basically all the aspects that matter). wasn't even close to what i'm experiencing right now. great high, the taste is great with yummy fruity aftertastes. also looks like the volume of the buds have decreased by about 30-40% but they got denser will wait some more to see how curing benefits this one! ------- update 11/19/20 i had the trimmed leaves freezes so i decided to make some coconut infused RSO
Likes
21
Share
@gr3g4l
Follow
Semana tranquila, lo único que observo es como algunos de los pistilos o estigmas empiezan a tostarse- Los cogollos siguen engordando. llevo arrastrando de hace un par de semanas algo de sobrefertilizacion , algunas puntas quemaditas y no quiero que vaya a más así que seguiré abonando suavemente sin pasarme con la EC. a una parece afectarle de manera especial la cantidad de luz y muestra albinismo.
Likes
10
Share
@byte_me
Follow
Fellow growers, week 5 of flowering brings fascinating updates. The buds are forming nicely and becoming denser daily. Unfortunately, the plants shot up in height more than expected and I couldn't raise the light further. Our growing space is filling with a delightful, intensifying aroma. Despite the height challenge, I remain hopeful for a successful end. Excited for the week ahead! Happy growing!
Likes
20
Share
Bonjour à tous les padawans et maîtres jedis Franchement cette plante est exceptionnelle elle sent très bon, elle n'a pas de carence et elle va m'offrir un très bon rendement Si le bud principal continue sa croissance il va être énorme Si je suis autant élogieux envers cette plante c'est parce que elle grandit dans un pot de 1.5 litre Pour l'arrosage c'est toujours tout les deux ou trois jours avec un quart du volume du pot j'ajoute 5 millilitres de Hesi bloom 2 millilitres de Hesi boost 2.5 millilitres de Hesi boos ainsi que du supervit par litre d'eau