The Grow Awards 2026 🏆
Likes
Comments
Share
@Naujas
Follow
Day 84!!!! I came back from vacation and immediately started harvesting, this girl is no exception, she is ready for it :) so in general, spring and summer gave the girl everything... a lot of rain, strong wind, cold temperatures, hot temperatures.... well, nature didn't mess around:) but knowing that she grew on my balcony on the north side, this is a really good result:) I admired her on my balcony for 3 months:) her flowers are very stiff and strong, there will be an update when the harvest dries:) good luck to everyone:).
Likes
7
Share
@Athos_GD
Follow
D8 Top right plant is getting some heat stress from the heat lamp. Will try not using the heat and see how low temps get at lights out. Watering once a day. Still haven’t set up my irrigation. PPFD 400. VPD could be better. D9 Lights off temp got down to 66. Plants seem happy still. D10 turned heat lamp back on and adjusted heat temp. Getting really cold. D11 Watering once a day by hand. Still waiting on Athena nutrients before I set up hydro halos. Increased PPFD to 500. D12 pistils starting to show. D13 EC 1.8 PH 5.8 D14 I can’t believe how much these plants have grown since the last defoliation. Tent is getting crowded. Thought about getting rid of the plant with the twisted stem. (Bottom Right)
Likes
64
Share
@ClubRiot
Follow
The weight of these buds is unknown, but the Masters of this site will be visually approximate. I have all the confidence in their knowledge in elementary physics.
Likes
6
Share
Likes
13
Share
@Mastr
Follow
This week I done Lst no more stress for now I just feed her today with 1 L nuts Day 20 and lady's growing lovely I wait 10 more days then switch it to flowering Day 23 and I'm.so please with lady's I decide to top from each branches (bit going crazy)to only try didn't see anyone do it so I give it try
Likes
47
Share
@KA_LE
Follow
- Not much to report this week. Shes still stretching like crazy. - Lowered the pot down in the bucket a few Centimetres because she reached the top of the led strips already. Now shes reached them again, hopefully she doesn't stretch much more because i'm quickly running out of space. In the worst case scenario, ill have to move her outside. - Finally some pre-buds started forming towards the end of this week. - Its drinking a lot as well, giving her a good soaking of about 2 litres every 2-3 days.
Likes
36
Share
@starke
Follow
I don't know where to start and I must admit I'm completely overwhelmed by this beautiful beautiful plant ❤️❤️❤️ Aaaaaaaaaaaaaaaaaaaaaaaaaaah, I'm so happy 😍😍😍 She is a blessing! Excuse the outburst, but she is magical ☀️ I applaud you guys at Humboldt for creating such a wonderful strain 🙌 Some details upfront, before I rave some more: - 134 Days in total: 70 Days in Veg, 64 Days in Flower with 128W LED in a 60x60x160cm tent - 7 Days Drying regularly, 9 Days Drying in the Fridge - 432g - Wet weight with stems - 103g of those for Fresh Harvest Infused Oil - 190ml Olive oil with 30mg/ml THC & CBD - approx. 20g dry (for dry weight calc.) - 87g for the DrZiggy's Low And Slow Drying in the fridge - 20g dry - 242g for regular Drying @50% RH and 22°C - 55g dry - 30g dried sticky trim in the freezer Summary of my growing experience with this strain: She takes well to massive training and a little neglect in the beginning, meaning she recovers well, which is what I want 😊 I didn't experience any major deficiencies. She had a little nitrogen deficiency during the later veg phase, which she showed with lighter green leaves. I blame this on my long veg time and my pot size of only 11l. She consumed all her soil and nutes by the end of veg. I will keep that in mind for my next grow. Since I increased my nitrogen levels so close to flowering phase, I overdid it a little on the nitrogen which showed a little bit during later flowering phase with downwards clawing leaves. So I will be more careful with nitrogen especially while transitioning into Flower. I did not flush this plant and she smokes already beautifully mild after only a couple of days of curing. Drying her took 7 days in the tent and 9 days in the fridge. She crusted up with lots of stickiness while drying and gave off a good bit of scissor hash & kief when trimming. Smoking her is a great and different experience to me. It's my first time with a 1:1 strain and I can definitely notice the CBD content. She shows in a very well balanced body high with a slight and gentle knock on the THC door. The first couple of days I felt a craving for higher THC which settled down after only a couple of days. Very interesting and definitely worth growing. So you guessed right, I totally recommend growing this beauty. Especially if you are interested in exploring a 1:1 THC:CBD strain with all its magical medicinal values 🙏 Why I grew this strain: Like @Experimentgreen on here, I grew this strain for my Mama ❤️ She is open minded to trying to solve some of her health issues with these beautiful plants and the magic they bring but she also likes to have a bit of fun, she doesn't mind. So a 1:1 strain was quite handy. She suffers from neuropathic pain, arthritis in her joints, restless legs and insomnia. All very relatable issues and perfectly suitable to be introduced to some good CBD and THC content. She already has a little tolerance, since she is treating her restless legs with gummi bears I made with a strength of 1.5mg/gummi bear. This small dose already helps her on a daily for her restless legs. Beautiful 😍 So with this special mission in mind, I wanted to process the plant with only the very best options and create Cannabis Oil (Capsules) for my Mom to take. I chose a method called "Fresh Harvest Infused Cannabis oil" by the wonderful member SweetSue over at 420magazine: https://www.420magazine.com/community/threads/fresh-harvest-infused-cannabis-oil.363371/ I hope it's ok to relink, no need to duplicate already existing and well researched content, right? I will not go into detail and def. recommend reading through the whole thread. I only document the short version here, but feel free to ask me, I'm happy to share my experience. The oil I made has 30mg/ml of THC and CBD. That's a good value. I calculated the strength the following: 75g fresh Flower in 200ml Olive Oil - with 10% CBD&THC 85% extraction efficiency with the infusion method 85% * 10% THC&CBD = 0.0850 0.0850 * 75g = 6.375 gram of available THC & CBD 6.375gram * 1000 = 6375mg/THC 6375mg/CBD 6375mg/200ml = 31.875mg/ml CBD & THC I created capsules with 3mg per capsule. We are currently trying to find the right dose for her. She started taking one capsule 60-90min before bed for 3 days now and will increase by 1 capsule tonight. We continue until a max dose of 15mg/day but always re-evaluate how she feels. She's documenting her experience quite cute. Very heartwarming and powerful. So far she sleeps better and she falls asleep faster, which she hadn't done in a long while. Onset is pretty precisely between 60 and 90 minutes. She has not had any restless legs so far. I'm excited for her and can't wait to see where this takes us. I also made her a salve/creme she uses as a topical on her joints. When she uses it early enough, before the big pain hits, she feels it helps. Of course this is not a science study and everything is purely based on personal experience. I thought I share, in case anyone is interested, also I want to give back a little, since I consume so much knowledge from all over the internet, including here, so thanks 🙏
Likes
12
Share
This girl was a fast finisher harvested on day 46 of flower, nearly 7 full weeks.
Likes
6
Share
@Joshaee1
Follow
Cut a few of the colas off to dry,alot of the tops are done and now just focusing on the bottom buds to ripen and turn amber :) Had a smoke today of the tallest cola,smokes great and haven't been this high in a long time so impressed with her !
Likes
2
Share
This plant way outgrew my expectations!!! She was trimmed back to nothing, and still could've used a better trimming.
Likes
12
Share
25/01 Still having problems with the heat, I've build a exaust with 2 120mm computer fan, this week has arrived the humidity controller and I noticed that is to low for the temperature. Now I waiting for a mist maker to build a DIY humidifier(using a simple water spray for now) I belive this will be the solution to get a better VPD and control this fucking heat inside the tent 😎 30/01 The temperature is reaching more suitable levels, between 25-27°C. Even with the rainy days and higher humidity outside, the grow is stabilizing well at around 65% humidity.
Likes
13
Share
se mantiene alimentación base de vegetación por los primeros 10 días del cambio fotoperiodico, aplique ultima vez preventivo, parámetros de cultivo alineados
Likes
6
Share
I did the unboxing before Christmas and I’m excited to start this next journey with the Sticky Broccoli.I enjoyed the Zamnesia Runtz in the 2025 Grow Cup and I know this Plagron really packs a punch mid to end flowering stage.Ill start this grow in a few short weeks and have some beautiful flowers for spring :)
Likes
2
Share
Absolutely zero issues. The pheno continues to impress me over and over. The structure on these clones are just unreal and I'm beyond excited. Took a few leaves here and there to expose new grow and to optimize energy
Likes
3
Share
@PalmaGrow
Follow
5 - 11 octubre terminando séptima semana de floración
Likes
16
Share
Likes
35
Share
March 11th. All Seedlings are stable, Looking good Working on Leafset 4 Rooting job is done, now the allover development can Start Plants are sitting in 3l Pots, filled with my Soilmix Watering with Beneficals Spraying with Foliar Feed " Fast Plants Spray" March 13th. Iam done with setting up Now i have another Babytent. and Inside the New Viparspectra XS-1000 and the other Stuff to run the Envoirement I already ca see a difference between both Tents. If you stand outside and just look with Eyesight the Viparspectra seems to be brighter// has another color of Light. I made a Unboxing Video for more informations. Amazon: http://url-9.cn/0y9i Amazon US: https://amzn.to/3e0P2bk Amazon CA: https://amzn.to/3bTnEJC Amazon discount Code: it10mlarimar XS1000 10% it15mlarimar XS1500 5% it20mlarimar XS2000 5% it40mlarimar XS4000 5%
Likes
17
Share
@AmokNewb
Follow
So where to begin I got 108.83 ounces wet from two plants in a 2.3x2.3 on my first attempt not including larf. I can’t complain about that. Took me 14 hours to trim the last plant and boy that was a marathon. I will update this once I get some dry weights and everything goes into curing.