This was the final week. I had no choice to harvest early because pm was starting to settle on a lot of stuff in my garden. The UV light worked for like a day or two and it came back. It's just not worth it. It turned a lot of the buds hairs brown and the leaves did suffer a little damage. Part of that was the peroxide solution. I mixed a little too strong, and it didn't seem like it hurt the plants, but after a few days, they showed the damage. It just seem to burn the leaves a little not really the bud so that's good. There was three days of rain coming, so I wanted to get it cut down.I didn't intend on harvesting so early, and I have no place to dry this because other plants drying so I was forced into freezing it. I cut down branches and wet trimmed it into a bin and ran to the freezer every 10 minutes to get it frozen right away. I maybe could've dried it and had some decent flower but I figured this would be a good opportunity to learn about making bubble hash. I decided I wanted a stainless steel mixing vessel and found this beer brewer for a good price. I think it's gonna be solid. It has a nice drain at the bottom. Then I bought some 5 gallon buckets for spacers for my 5 gallon bubble bags I use the heat gun to peel the stickers off and to heat the bottoms up to make it a little easier to cut them out with the utility knife. I used the heat gun again to soften the edges a little bit so I don't damage my bags. I can't do my washes until I'm done trimming my flowers, but I got a 2 Inkbird temperature controllers to bring my studio down to bubble hash temperatures with my ac unit. I could wait a little longer until it gets colder but I'm not sure how cold it's really gonna get and I wanna get this done soon as I can. I'm gonna have to try it without a freeze dryer so that should be fun and I'm not going to micro plane it at all costs. I got 25 µm screens for drying that I will use a towel to wear most of the moisture out then see if it on to some parchment and I should be able to get my studio really cold and dry to get it dried relatively quickly. I'm seeing it recommended to be 30 to 40% humidity and 50° or so for about a week and it should be dry enough to press some rosin. I'm gonna try to separate out the full melt hash, but honestly I think I'm just gonna get a wide spectrum pool on this hash and just press it into rosin to make it easier to deal with. I kind of was trying to find the cheapest bags it's still decent and wasn't paying attention when I bought it really cause there's no 45 µm and my set and I'm saying that to be the lowest recommended the pool but also seeing a lot of people pulling some nice 25 µm so I think with my early harvest I might have some smaller truck head so I might not be a bad thing to have that bag as my lowest. I'm going to catch everything under 160 to 25.