Likes
26
Share
@Gzuscamp
Follow
This is my first hydro grow and first time with clones. I have a few semi successful outdoor grows under my belt but the weather (hot AF) and caterpillar apocalypse (lost a beast of a plant and the tops of most others) last year are forcing me inside. Reservoir is an hdx 27 gallon tote with 15 gallons of actual water capacity about 1/4” under net pots. Attached to 1/4 hp active aqua chiller (overkill but got a deal and am in so cal; last years consistent 100+ temps ravaged my outdoor grow and can even make indoor temp regulation difficult) with two 5” and one 4” air stones in main res and one 4” in a 5 gallon top off res (not part of the system until/if I need it) attached to two 15L/minute active aqua air pumps. I wanted to have a bit of a barrier between the ambient temps inside the tent (rest of the room is a/c controlled) and the actual reservoir so I built a base to set the tent sans bottom putting the top of the res at the floor of the tent. This also raises the reservoir off the ground and hoping it will save some back aches once scrog comes into play. This also frees up 16” of vertical space inside tent and although I intend to scrog it should help as a buffer with temps and I won’t have to worry about light distance since plants are at floor level. To keep as much unnecessary heat out of the 4x2 tent the spider farmer light ballast was removed and relocated to outside the tent which I’m glad because during testing the ballast and light are each producing 120 degrees. Half of that is outside the tent allowing the temps inside the tent to stay about around when room temp is about 78 (a/c off but weather is fluctuating) with a small fan at base level and a 6” clip on fan for higher up. Reservoir will be 66-68 at all times thanks to the chiller. For ph management I am going to be using a torus hydro perfect ph (35 gallon). I’m hoping their claims aren’t just hype because they say it removes H+ and OH- ions to allow the ph to maintain 5.8 - 6.2 ph (without any additional buffers). This small fluctuation allows all nutrients to be taken in while a stagnant ph will prevent certain nutrient uptake hence a more complete usage. These are claims among others they made, let’s see if the science is legit. Unfortunately this being my first hydro grow I have no standard to base this off, but if I don’t have to worry about my ph that’s one less worry. Nutrients will be GH flora trio and cal-mag plus hydroguard. Not sure about additional additives, want to keep it pretty basic but suggestions for this nute/strain combo would be appreciated. I was intending on growing wedding cake or venom og but cake was sold out and venom didn’t look great so I ended up coming home with two gelato clones from universal nurseries. I’ve always liked this strain but wanted the cake because I’ve read it’s highly resilient. What I was not expecting was that these would be rooted in neoprene. I’m new to hydro and aside from the research and reading throughout my grows I usually overlooked neoprene. I guess it could be better than the rock wool as it shouldn’t leach and mess with ph? They are surrounded by hydroton and will be hand watered until roots make it to water. Update day 6: I went against my better judgment and initially painted my lid for light leakage. Ended up dumping my entire reservoir two days in because it was full of paint chips (even though it was formulated for plastic it still chipped off in high volume). Used a drill pump from HD, worked well as the intake is a 1/4” pvc tube I could suck up the paint chips and the water, but DO NOT USE to transfer anything but waste water as the output contained grease from the pump! Got a new lid and will just be using panda film for light blockage. Added a small humidifier because rh was in the 30-40 range, now temps and rh are consistently 70 degrees and about 65%. Nutes are 1/4 strength except calimag due likely to stoned math... Plants don’t seem to be minding so I’m not trying to sweat it much. Slight upward drift in ppm and ec as water is taken in or evaporates and ph is slowly swinging in the range torus hydro said it would so that is a success as I have not used any buffers. They claim it is more effective when it can directly interact with a root mass so it seems promising. New growth sprouting all over but no roots have made it out of the net pots. I went with 6” hoping roots will branch laterally exposing move root mass to the air gap once developed. Started noticing slight yellowing of leaves day 4 and some drooping (due to low rh as they perked up after adding humidifier) so I went from 50ml top feed daily to 100ml, also turned light down to 15% and everyone is happy.
Likes
2
Share
These plants are absolutely filling up the 5x5, if they keep it up I may have to remove one. I filled the reservoir with 6 gallons of water at midnight the other night and by noon the next day it was empty. I am putting in 6-7 gallons of water in res at a time and it is typically gone in 12 hours.
Likes
26
Share
@darb35
Follow
Day 22 - 660 ml water (ph 6.5)(22 cm) Day 23 - 660 ml water with Acti+Heaven+Grow+Calmag (ph 6.6)(24 cm) Day 24 - no water(26 cm) Day 25 - 660 ml water (ph 6.6)(28 cm) Day 26 - 660 ml water with Acti+Heaven+Grow, also trimmed a bit of fan leafs, it's getting crowded inside (ph 6.5)(30 cm) Day 27 - 660 ml water (ph 6.6)(33 cm) Day 28 - 1L water (ph 6.5)(35 cm)
Likes
7
Share
Great week. Added some big bud nutrients and defoliated a bit. The buds are swelling nicely, the Advanced Nutrients is doing its job without a bit of burn.
Likes
82
Share
Week 7 Flower We've finally started flush 💦 on Day 43. I still run EM1 at 1ml/ltr as it goes a long way once activated/stretched. It's always going to be a benefit to keep any microbes you can in the coco. You can also use Mammoth P throughout flush, but due to its price I just stick to EM1 in flush. There's plenty of other microbes that can be used too. I flush around twice the pots' volume at 6pH. But before flooding the pot I slowly pour water through the centre of the pot, around the stem, in order to take a true reading of the ppm and pH of the run off. If the ppm/ec reads a lot higher than your average feeding throughout bloom, then there's been issues such as a lockout, incorrect pH, over feeding etc. This wasn't the case, as this girls' was at the right level. If the pH is too high or low, I adjust the pH of the rest of the water that'll be flushed to try to fix it. Again, this wasn't the case with this girl as she had a perfect pH 👌👍 Just before all of the water has gone through the pot, I take one last reading from her last bit of run off. The ppm should be down to no more than 100ppm for the first flush (+starting ppm of water if using tap water). After the first flush the ppm value of the run off will quickly go all the way down to 0, or at least below 50ppm (+tap water ppm). I use tap water that is between 150-190ppm, but I'm looking to switch to RO as soon as I can. I still get a very good flush, but I think using RO water will be the next step in getting a more thorough flush as it won't contain even the small amount of nutrients and metals that tap water contains (along with any harmful chemicals). Always remember to bubble or let the water sit for 24-48hrs before feeding to your plants. That goes for all feedings in every stage of growth if using tap water. Because I keep fairly low temps in the Den she's starting to turn a beautiful dark purple. Her buds are still swelling and smelling like a nice gassy OG, with hints of citrus/tropical fruits. I'm really looking forward to taking this girl down, but after at least another week! Thanks for following and happy growing! 🐺
Likes
2
Share
Oct 5-11 Vegetative steering? Aiming for: leaf Temp -80f CO2 -1250ppm VPD +1.04 (65%/75F) Vegetative Steering 6P1/ 2P2/1P3 Each P1 water event is 15 minutes apart. Seems to far apart. I think i Need More water events, with less time in between events in order to get a strong veg signal? Watering for 2min(110)ml May need 3min waterings(currently not getting runoff) I have to hand water every two days. Day 11 flo 18.5inches tall 12inches from light(moved to 16) 1300ppm Day 18 Defol Sprout chickpea(2days) Soaked 1cup for 4 hours then rinsed. Completely covered then Soaked overnight. Rinsed then poured water out and layed jar on the side for one day. Blended with water(aloe vera and coconut) Day 19&20 foilarspray Alfalfa/Chickpea SST with Kelp,aloe,coconut,silicate,microbes brewed for 1.5 days Day 21 Fed the Tea blend Leaf temp 80 65kluxx Co2 100 Plants look like they responded well to the foilar. The flowers at this stage are my best performance yet .crop steering may be working?
Likes
3
Share
The plants are starting to recover from the N excess 2 weeks ago, this delayed a bit the starting of flower from some plants but im sure that the rest of flowering will be ok, i gave only water this week and applied a small amount of guanokalong nutrients as these are slowly absorbed to ensure the plant continues to receive some nutrients until next 2 weeks when we will start to give some extra PK
Likes
8
Share
Not really packing on as much as hoped, probably because of the genetics, or she'll only start stacking on the final weeks For the rest I didn't really change anything just letting her do her thing She seems happy, thanks for having a look
Likes
5
Share
@EKWCR
Follow
I was happy when i've seen the weight, i expected 70 or 80 grams and it's the double. I'm not sure if i will grow this strain again soon, there is plenty of strain waiting to grow.
Likes
11
Share
@Radagast_
Follow
17.08. Wedding Cake 1# Day 114# The plant was at the end of its 16th week 2 days ago, it has not yet started flowering Wedding Cake 2# Day 108# She was at the end of her 15th week 3 days ago and is very close to blooming The pictures and video are from yesterday. Stay High and Keep Growing!!!
Likes
30
Share
My Critical Purple has not started flowering as of week 9 😱, topped the CP 5-28 ....The Northern Lights is, Growing out and filling in this week ✌️🌱✌️
Likes
40
Share
@GYOweed
Follow
So this one started slow but healthy. She was a sativa that expected much more leg space and warmer humid climate which i fixed later. Needs LsT. I hit it with my concoction to keep her short it worked. Dense nugs especially for sativa hybrid. Not loud but tropical sweet. I needed 11 weeks min for flower could run 12 even though I seeded mine. Tiny sativa seeds like the original ibl bred by jaffa seeds uk and brought to me by Pevseeds. Not bad for under a cheap 120w led quantum and 3 gallon grow bag. I should have went with 5. The roots were amazing dense.
Likes
48
Share
@McBubatz
Follow
14. Woche, P1 fällt morgen, die ist soweit gut denke ich (ca. 20% aufwärts Bernstein Trichome). P2 braucht leider noch ca. 1 woche länger. 93. Tag ist für P1 das Ende, sie wurde heute vorgetrimmt und zum trocknen aufgehängt. Ergebnisse gibt es wenn die P2 auch geerntet wird, denke nächste Woche um die Zeit. Aber eins kann ich euch versichern, is mit Abstand die schwerste die ich ist jetzt hatte😊🍀🍀. Gebt euch auch mal wie viele Trichome die gute produziert hat, Duft is noch sehr pflanzlich, Blüten sind ziemlich fest gewesen hoffe das es nach dem trocknen noch so ist. Alles in allem super Run. Hoffentlich is die gute bei den Top 10 das wäre ein träumchen, wobei ich es wirklich jedem gönne zu gewinnen und bei soviel starker Konkurrenz geht ich wahrscheinlich unter. ABER was ein geiler Contest trotzdem, hier ein dickes fettes Dankeschön an Zamnesia und Plagron für die Möglichkeit hier überhaupt mitmachen zu dürfen 🙏💙💜 98. Tag , werd die gute am Samstag/Sonntag je nachdem wie ich Zeit finde, umlegen und zum trocknen aufhängen.
Likes
4
Share