I wish it was easier to upload media here. That's why is taking me so long. Stretching everywhere, she went from 3 feet to 6 feet in a heartbeat. She is running into the light. I raised the ppm because I'm going to turn 600 watts on. They look healthy, but too much legs.

Harvest completed for Glueberry OG! Round 2 of this strains grow was majorly different from round 1. Buds are very dense and insanely sticky! Will update in 7-14 days with dry weight and smoke report. Thanks for checking out my grow 👽🌳🔥 09/01 dry weight of 96 grams. Primarily taste of fuel with a hint of berries. Nice balanced high! Output was better with round 2, taste/aroma is also better this round.

Bushing out nicely! I probably should have adjusted the LST to allow them to grow taller but they were responding nicely so I kept them pinned and adjusted every few days. Finally started ph’ing the water to around 6. Water is tap, not measuring TDS or adding liquid nutes at this point. The soils transplant was done with 50/50 mix of Natures Living Soil and soil, botto 1/3 of pot and remaining 2/3 soil.

Good harvest especially the one under the HPS 400w 👹

Plants are doing well, The 84" inch tent is a must if your not training or topping. I removed all the sacks that appeared last week and I haven't seen anymore show up so fingers cross, I check daily. Bigger tent also helps with heat control as the air has more room to rise. Hope you all like the pictures, I started to take videos as they provide more detail with less work.

4° Semana- Aeroponía - Mejoría apreciable, las raíces están 100% sanas y la velocidad de crecimiento comienza a ser mayor, además el área de las hojas que realizan fotosíntesis es mayor. Se aumenta concentración de nutrientes. --------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- 4th Week- Aeroponics - Appreciable improvement, the roots are 100% healthy and the speed of growth begins to be greater, in addition the area of ​​the leaves that carry out photosynthesis is greater. Also increasing the concentration of nutrients.

Привет Садоводы и огорники !!!

Light-Zeus (Samsung LM301B) 40 cm away. 220 W right now. 110W each Little K overdose.

She is a stinky, sticky beauty! Not doing much other than watering ✌️🏻💚🤣💨

Due premature sono state tagliate a 48f giorni Appiccicosissima puzza di limone

3/28/23 After drying the last two they’ve been trimmed and into jars Barnyard looks like it’s ready to cut the trichs are visibly amber. But I’m just not ready I want to run this long so I’m gonna leave it for another week at least and let the buds swell as much as possible. No rush on it!

So they still have more ripping to do. I only harvested the main colas on 3 plants still a lot more bud to go at least the same amount I'll update total weight etc. When it's all finished cant wait to test it out.

Variedad con una floración corta, entre 8/9 semanas. Procedente del original Exodus Clon (UK). Predominancia indica con un nivel de thc superior al 16% . Es muy fácil de cultivar y la alimentación la acepta muy bien en general . Cada etapa cumplió con mis expectativas y por ello aparte del sabor el colocon ... en cuanto a todas sus etapas le doy 9/10 . CEPA BRUTAL enserio.

Started from seed this lady's have 17 days under half load 4 X 50W Cree CXB3590 CRI 80 3000K custom build led. 7days in rockwool cube under a dome , 10 days in 750ml pot. Freshly transplanted into to final pot. They have received 250ml of fertilizer solution and transplation soil was moisted with 6.5PH water. Led now running on full load. This project have some custom/extra gadget, a prototype growing controler. Hardware Specs: Raspberry PI 4 4Go Ram + SSD 120Go Phat sparkfun qwiic i2c hub + i2c sensor for : temperature,humidity, co2, tvoc, air pressure and distance measurement(plant height) Linked with one custom wifi power bar for schedule and countdown. One sonoff pw r2 for energy monitoring. Both using ESP8266 chip and running on Tasmota alternative firmware. Linked to the controler using normal wifi AP. From Wall|----Sonoff-----Powerbar---: Led, Extraction Fan, Mouvement Fan, and the Rpi4 Software: Exploitation System: Custom Linux Buster Lite OpenHab : Open source domotic software for visualition and automation. Mosquito MQTT +TLS server : Used to publish and receive message/data from sensor etc. InfluxDB : DataBase for data retention Chronograph: Visualisation and transformation panel to analyse our data. Custom python code for running the sensor and publishing result into mqtt channel Chronograph have monitoring panel for now The growroom Sensor AkA spaceship The system sensor and hardware/computer monitoring : Memory, Disk space, CPU load and temperature. In/Out etc. Network etc The database: request per db ,memory heap, disk usage, http request etc. Working : Co2, humidty,temperature, Tvoc, Current,Voltage, Power, Daily/yesterday/Total energy consumption on kWh and $ Planned in version 1.0 : Mesuring plants height using ultrsonic sensor. Adding remote On/Off function on sensor using openhab. Adding power schedule in openhab. Adding basic automatic watering/dosing system, Planned In version 2: Adding relay and dimmer on the custom led to control/dim each cob. Adding custom small emerson effect led based on 3W led. Adding , automatic, PH, PPM and temperature monitoring for water/fertilizer. Adding PAR sensor for light monitoring. Adding soil moisture and PH sensor. ============================================ 2020-05-07 ============================================ Added security cam for streaming with rtsp, working on http conversion for addition in openhab Added snapshot. CO2 sensor down, some resoldering needed. =============================== ================================= 2020-05-08 =============================== Good: Updating fertilizer quantity from 250ml/day to 500ml. Watering planned for the end of the day. 2 days ago i've pinched the head of each plant Internode are booming. Started LST training s to help the lower internode. Bad: Noted some physiological/Nonparasitic leaf Roll on one plant ; humidify level is too low; Humidificator filter is broken, need to be replaced. Monitoring #4 for couples of days.

My girls are doing fabulous in their new tent. I'm so excited about this grow, man... 6/20: So I topped GDP2... she's just entering her 4th week. She's growing so much faster than GDP1 and BK at this point. I was having watering issues during this point with them 2. I'm thinking I am just going to top 2 more times and not LST. Honestly I just don't feel like adding another LST lololol 😅😆😆 6/23: So I learned that I accidentally fimmed Lil GDP2 when attempting to top. Had my question answered pretty quickly and he was very helpful. So instead of creating 2 new colas, looks like I created 3... #winning 😊😊 It's only been 3 days since I topped GDP2 and her 3 additional colas are already growing in really well.

Plant was transplanted in to 5.5 L pot

Decided to take it outside.... 'till june 21st light hours outdoor expand..now it is 14hrs and rising... will germ indoor a few days and then will let it have all day sun later on the grow expecting much of this