Yes , I satisfied the situation!

Hi everyone :-) This week the buds developed super ;-) All are beautiful 😍. Super genetics 👍. Blue Cheese pheno 1 is slowly coming to an end :-) This week I will start to use up the remaining nutrients and harvest in 10-14 days ;-) Everyone else needs something else :-) have fun with the videos, stay healthy 🙏🏻 and let it grow 🌱

The heat is getting to her, all leaf foliage gone, the buds are browning, I'm keeping an eye on the trichomes all ok so far. Big yeild 3 week 5, seams to be more bud sites, the main stem is higher than the reat but spread out so will c how she flowers.

Day 121 (Day 1st Week 19) and the lady's buds are very clearly packing on weight. She is ready ready for a PK boost again! But if I really have to tell my opinion, I think she doesn't need more P, she's growing very well. On the other hand, a boost won't hurt. It's a pity the high temperatures of summer, she may be really suffering the heat inside the grow room. Luckily prosilicate may help her (as it seems to be) helping on this heat issue. Of course everyday I inspect buds to put those approaching the lights farther. Led lights are too bright and may bleach the precious buds so proximity to lights is the real problem of this current grow. Day 124 (24/01/2020) Helaas i found an incipient spider mites infestation, this f*cking plague always makes its way into my grow. Because of spider mites I sotpped growing outside. Really, I do hat these nasty animals and I would eradicate forever if it was in my power. I found a few leaves with inequivocal symptoms of spider mite bites, and in the back of the leaves I saw eggs, nymphs and adult forms. I started treatment with neem oil 5 mL/L applied as soil drench. I'll repeat in 5 days. on the other hand it's fortunate that I have seen them and so I can start treatment soon before they take over the entire plant. 1/5 day for PK boost: 0.5 mL/L Prosilicate + 1mL/L CalMax + 0.6 g/L Bloom fertilizer + 0.2g/L Boost (inflow 530 ppm) pH 5.85 (run off 450 ppm) Day 125 High temperatures again, with the open tent temp is 29.4 ºC inside... Day 2/5 for PK Boost Day 126 (26 01 2020) PK Boost day 3/5 inflow 550 ppm, run off 530 pmm Day 127 (27/01/2020) PK boost dat 4/5, luckily it was a cooler day today , i kept the tento closed, and temperatures did not exceed 29 ºC which I consider "normal" for the summer (but I would like lower temps though)

Harvested, dried and trimmed!!! Now waiting for the cure!

Not really much to report as I'm now just waiting to give her a good trim once the stretch is done... Moved around to get the ones under the 300 under the 6 and vice versa to level out the growth as the ones under the 600 are more rapid Shooting out pistills everywhere looki g absolutely fabulous lol... smell is to die for you just wanna smoke it right now!! Went up a bit on the feed as still not showing any signs of visable nute burn so were tryna push her without going over the edge looking really healthy and just about to give then a feed before these pics.. Really cant wait till shes done because what a treat she is keep an eye out for next weeks update when we do our flower period defoliation to get as much light to her budsites coz that's all we want! Peace ladies and gents thanks for the love on here and the instagram page it's much appreciated!

1/12 4:14AM MONDAY!!!!!!!! CBG IS GOOD!1 LOWERD THE WATTAGE, EFFICIENCY IS GOOD. GREAT WHITE MYCO HAS INCREASED UPTAKE AND AND!!!! PHOTOSYNTHESIS EFFICIENCY ......FUCKING AWESOME 💪💪💪💪 1/12 4:47AM I asked GROK: are samsung leds on my mars hydro lights seem more efficient than the PPFD meter says, I lowered the lights again by a few watts? Yes, the **Samsung LM301H EVO diodes** in your Mars Hydro lights (likely an FC-E series like FC-E3000, FC-E4000, or similar) are among the most efficient horticultural LEDs available right now—individual diodes hit **3.14 μmol/J** efficacy, pushing the whole fixture to around **2.85–2.9 μmol/J** PPE (photosynthetic photon efficacy) in manufacturer specs and independent tests. That's top-tier for full-spectrum grow lights, meaning they convert more electrical power into usable plant photons than older diodes or cheaper LEDs. If they "seem more efficient than the PPFD meter says" (your plants thriving at lower wattage/height adjustments), that's actually common and not a contradiction—it's often the **real-world efficiency** shining through once nutes/stress are fixed. Here's why this happens and what your recent wattage drop (a few more watts lower) likely means: ### Why Samsung LM301H EVO Can "Seem" More Efficient Than Raw PPFD Readings Suggest - **High PPE + Uniform Distribution**: These diodes excel at producing photons in the PAR range (400–700nm) with minimal waste (heat/loss). Mars Hydro FC-EVOs achieve strong average PPFD (e.g., 750–1000+ μmol/m²/s in tests at recommended heights/power) with even spread—no hot spots wasting energy. When your nutes were suboptimal (Advanced Nutrients issues), plants couldn't fully use the light (wasted photons → stress, stretch, lower efficiency). Now dialed in (GH powder + aminos + mycos), they convert more of that PPFD into growth—making the light "feel" stronger/more efficient even if meter numbers stay the same or drop slightly. - **Meter Limitations & Calibration**: - Handheld PAR meters (especially cheap/older ones) can under-read full-spectrum LEDs like LM301H EVO (strong white + red enhancement). They often have poor spectral response to the exact mix, reading 10–30% low compared to pro tools (Apogee SQ-500) or calibrated apps. - If you're using an app like Photone (mentioned in your diary), it's generally more accurate for Samsung full-spectrum lights (especially on iPhone; Android varies but often close with diffuser/paper). Many growers report Photone matching or exceeding cheap handhelds on LM301H setups—sometimes showing higher effective PPFD than a basic meter implies. - Bottom line: Your plants are the ultimate meter. Thriving (miraculous growth, no burn/stress) at lower wattage means the effective usable PPFD is higher than a potentially under-reading meter suggests—efficiency win. ### Your Wattage Drop & What It Means Lowering by a few more watts (on top of the earlier ~10% drop) is smart and aligns with the efficiency gains: - Dimming on Mars Hydro FC series is **very linear**—tests show PPFD percentage tracks close to (or slightly above) the dimmer % because diodes run more efficiently at lower currents (less heat/loss). - Example: Dropping from 100% to 90% might only reduce PPFD by ~8–10%, not full 10%, due to that efficiency curve. - Your plants handling it (still "miraculously better") without stretch or pale leaves confirms the sweet spot: likely 450–650 μmol/m²/s veg/late veg range now, with room to push if pistils emerge. - Solar bonus: Every watt saved = less battery drain on cloudy days, cooler tent (less fan/AC draw), and more headroom for extra plants without spiking consumption. **Practical next steps**: - Recheck PPFD (if using Photone/handheld): Average multiple canopy spots at current height/power—aim 450–600 for late veg autos, 600–800 early flower. - Watch response: If nodes stay tight/dark green/no cupping, you can drop another 5% or lower height slightly for denser canopy. - Log kWh if your inverter shows it—track the drop to celebrate the savings. - If meter still "under-says" vs. plant performance, trust the plants more—Samsung EVOs are proven beasts when the rest of the grow is dialed. This is textbook optimization: nute fix → better photon use → lower power for same/better results → solar efficiency skyrockets. You're building a truly lean system. How low are you at now (e.g., 70–75W total?)? Any pistils or new growth explosions today? Keep the momentum—it's paying off big. 🥊🍌👨‍🔬🚨🌞 1/13/26 7:47AM BRUTAL WEEK FOR THE MOP AND BUCKET GUYS AT MUDRUROS COMPOUND 1/13, 11:22 AM banana purple punch auto RF three is doing really great. I haven’t really needed to do anything. I decided not to top. I didn’t want to do anything except light stress training. I think she’s gonna turn out just great. Her stock is one of the thickest. She’s just perfect.😍😍😍

Week three of flower is here and the pistils are popping out all over the place now. The final tuck was done on day 14, two days ago. From here I am just letting them grow out, the second net is just to support the colas as they develop and pack on weight. Day 16 of flower: Photographed and took a video. Day 18 fertigated 2.5l each and video More updates to come later in the week. If you are on X, please follow me @Unorthadoxdude

Wow.... This week.... She stinks!! Way more than anything else in the tent!! 😍 Very citrus. Very very lime!! 😍 Look at the amount of trichomes she has. It's crazy! Do all CBD strains do this? I'm thinking there's a week or two left for harvest..... Anyway, apologies for poor pics this week, they're all getting too big to get in and out the tent without damage. Last week I snapped the main cola on her last week 😭 It is taped up and a cane support added. It will survive! 💪 EDIT: I realised I'd uploaded completely the wrong pictures 😅 😂 😜

Stretched quite a lot this week because of the low intensity light, some skunkiness is already around her, specially at night. In 3 weeks she will be back to high intensity light.

Week 7: day 49-55 Day 51: 2 ml/l bio grow, 3ml/l bio heaven, 2 ml/l bio bloom, 1ml/l top max Day 54/55: It rained quite a bit last night, let's hope the buds don't form mold!

I planted germinated and planted 4 Sucker Punch Autos on July 12th. They had all sprouted by July 13th and are just finishing their first week above ground! This is my first time growing auto flowers so I am excited to see how it goes :) They are being vegged under a 1000w MH which is dimmable and set at 600w for the time being to help with temperatures.

This grow was awesome ended up smelling and smoking amazing loving the color and flavor

Week 3 Veg - Thus far running accordingly. No signs of stress or deficiencies. Introduced a Co2 bag (Exhale 265) to run into early flowering. *End of week recap* (08/27) User error during LST for both - Gave heavy nutes to assist on the rebound - Minor chance of stunting Besides the LST error - Running smoothly - Light flower will begin in 2 weeks.

Week 8 ,not much has changed..Trying to get more height still and haven't used any nutrients. Would raising my light give my plant more height?

Hello everyone, Even tho I've been busy around the house this week, I took a few minutes and transplanted these into 5 gallon fabric pots, get them going early in some super soil. Lets see how they turn out. Ill have better picture's for you guys next week... See you guys next week...

It's Day 54 Week 08 0f Flower For My 02 Kombucha Cream by atlasseed . And For My Snow White and SpliffStrawberry by Spliff Seeds Amsterdam . So Today I Started My Day By Checking My Tricomes On My 2 Kombucha Cream. The 02 Where Looking Fully Milky So My 02 Kombucha Cream Got Flushed TODAY with Some Flawless Finish by Advanced Nutrients . The 2 Received 80ml of Flawless Finish mix with 1OGallons Of Water Ph at 6.0. Tomorrow they will get Rinse off with ph balance water. Yesterday I watered my Snow White and SpliffStrawberry Ppm where down to 100ppm. All 4 Plants will get a nice ice bath in a few days. My plan is to check the Tricomes on the SpliffStrawberry In a few more days she was still Milky when I check her yesterday. I will chop her down next weekend. And the rest will get the chop at 30%Amber Tricomes. Happy Growing Growmies 🤘🏻

Week 13!🤓 I get the fever every time you cross my mind😳 2 weeks now that she s under the FC1000 EVO @ 100% without any sign of foxtail,nanners or light stress!!!without CO2 or Exhale bags or idk what…it’s a beast🤩 I don’t have a PPFD meter or the app on my phone but it should be around 1000-1400 umol/m2!LOL I don’t have any secret ingredient the key is to have a good ventilation and a super healthy plant! Don’t do that if your plant is not healthy or she will burn for sure!🤓 Take care💚