Sadly had to remove 2 plants due to hermaphroditism.
The remaining plants had 4-5 early stage pollen sacks on the very low branches as well so I removed them super cautiously… since then, I didn’t find new balls so let’s hope that this was it because it would be really disappointing to start all over again.
I am also adding a “starter - dose” of the biotabs bio PK (1-1.5ml per liter of water) and will ramp this up as the plants ripen. Can’t wait to add the compost tea later 😬.
@Biotabs, sadly, I had to remove 2 of them after finding some early stage male pollen sacks 😭. After staying this close, I think they are pollinated as well… found 3 additional balls on the remaining 4 plants . I removed them with clean clippers in slowmo mode. Let’s hope I won’t find more.
I still don’t really get why this happened because I keep everything clean and in check. I removed some bottom foliage as well… pictures will follow on Monday
you are doing good, and catched the right moment when to transplant
it eans you are reading the plant, this is in my eyes the best way to do cultivation. listening to the plants
@Biotabs, thank you so much ! Been using all your products for all the Autos Ive grown before and love them ! Using Biotabs combined with Autoflowers and Autopots in the past was some kind of no - brainer tbh :D super easy. Lets see what i can make out of these photoperiods :D
@Papajon, hey, thanks a lot ! I am using the whole biotabs range. I always do it like this:
1. add startrex and silicium flash to the medium.
2. fill the pot, put the tabs in.
3. add mycotrex to the plant - holes and put the plant in.
4. mix up the bactrex and orgatrex in water and pour it into the pot.
After that, I just follow the strategy but I am using both the PK 5-8 and the compost tea in flower.
My plants looked much better in veg and I stressed them a lot while experimenting with my SANLights :(
I hope this answers your question🏻