Easy Bud first grow in 3D printer box

growbo420 First days the seed was outdoor. Nearly nothing happened.

growbo420 Switched to indoor. With a better light the growing started slowly

growbo420 I was growing in a 3D printer tent. With just 80cm height, it became easily to warm.

growbo420 Fourth week. The autoflower finally gets some mass. Small but bushy. At this point I was afraid, if the plant is not to small for this stadium.

growbo420 And suddenly there IT was: with the flowering the stretch started. The plant exploded

growbo420 The plant got pretty big in a few days. Nice :)

growbo420 There it is. A huuuuuge stretch

growbo420 Since i was using a smal tent, I had to tie the plant down. I was ascending the lamp

growbo420 The stamps and buds where forming

growbo420 I did break the stem by using lst. But the plant survived.

growbo420 Everything ist just getting fatter

growbo420 Last week. The trichomes were 10% brownish. I tasted a fresh Bud with a vapeizer an were satisfied. Surely the plant could take another week. But nearly every trichome was milkish and I was very happy with the result.

growbo420 I did not use flushing or darkness, since I watched some videos of Dr. Bugbee. 214g wet. 67g dry. Very proud of the result. I used a smal 3D printing tent without much space, and it was my first grow.