ernest_twwg Tuesday, August 4th:
This is the first time I've ever had a pH problem in living soil. Soil pH was waayyyyy too high (7.9, so I flushed it out with 5.5pH-6.1pH dolomite lime water, yesterday. Today, after I post this (9am), she'll be getting another flush of just 5.5pH purified water. Then, I'll top her off with a couple gallons of pHed BuildaBloom and Dolomite Lime water.
Hopefully, this will take care of the problem. You'll see the signs of pH problems and cal/mag deficiencies in some leaves throughout the video.
Anyway.
As you can see, she was bent in half during a very bad storm. So, I just kind of half-assed propping her up. I still need to actually tie her up well before those nugs get any bigger.
1 like
comments
Share
Used techniques
LST
Technique
4
Week 4. Flowering
5d ago
1/12
213.36 cm
Height
13 hrs
Light Schedule
27 °C
Day Air Temp
6.2
pH
Weak
Smell
951 PPM
TDS
60 %
Air Humidity
24 °C
Solution Temp
26 °C
Substrate Temp
17 °C
Night Air Temp
102.21 l
Pot Size
9.46 l
Watering Volume
400 PPM
CO₂ Level
Nutrients 2
CaMg
1.3 mll
BuildABloom
1.95 mll
ernest_twwg August 11th:
Soil runoff says the soil is good to go.
Leaves are darkening up again. Much less new necrosis going on now, as well.
I started adding calmag at the recommended amount to each gallon. I'm still seeing some new spots pop up here and there, so if it continues after a few feedings, I'm going to up the dose.
Now that I'm absolutely sure the stretch is over, I'm going to up the dose of BuildABloom to 2tsp/gallon for the next few weeks.
Very light defoliation. I just plucked off yellow leaves that came off with a light pull.