Mexican airlines in da hooood

SlySo_GD Day 1 The nuts were soaked using the following method: the min seedlings are first soaked in pure osmosis, then transferred to a measuring cup with osmosis and bio root solution, each plug is thoroughly soaked, squeezed with my fingers, and carefully placed the seed just above the center of the plug, then into a ziplock and with a cheerful "breath" we create the necessary atmosphere and close it up, putting it in a dark cupboard for 3 days. So far, with this notorious technique, all my nuts have sprouted. Let's see in 3 days how these do. Day 4 The grow is summer and the plan was for a split system, but unfortunately, it showed its complete inability to handle the summer +25 + heat from 2 MH 400 lamps. Open windows and drafts managed the temperature better, so the grow didn't turn into an experiment with a CO2 can and a closed system but became a tough summer challenge. It was decided to try growing for the first time in 100% coco fiber instead of DWC systems, my first experience with coco soil from biobizz.

SlySo_GD It's hot, as you can see the plant isn't in a hurry to grow vegetative mass, however, the plant planted in a 30-liter pot is actively developing roots, which I assist with by adding root stimulator with every watering. A humidifier is working inside the tent. The Philips HPI T PLUS 400W (MH) lamp in a closed fixture is cooled by a Soler&Palau silent 250 at reduced power through a separate ventilation circuit. The direct exhaust from the grow box is a Soler&Palau silent 500, also at reduced power while the box isn't running at full capacity.

SlySo_GD The humidity has dropped due to external weather conditions, and the humidifier isn't helping because I have to push a lot of air through the box to keep the temperature below critical.

SlySo_GD Drainage PPM (0.5 conversion) - 540 pH 7.2 (alkaline layer of expanded clay drainage at the bottom of the pot) Input pH is always monitored and is around 6.0-5.5. PPM of the irrigation solution is 300, source water osmosis PPM 30

SlySo_GD The plant has finally started to actively develop vegetatively, and the growth rate is optimistic. In the photo album, the first photos are from the beginning of the week and the last photos are from the end.

SlySo_GD The drainage showed a slight nutrient deficiency, drainage 400, pH 7.0

SlySo_GD —

SlySo_GD —

SlySo_GD Drainage indicators are normalized to ppm 870, pH 6.3.

SlySo_GD A week of crazy growth of the "meat." Just the magic of growth! ))) Conditions behind the bar are a hot, humid summer, plants are lit by 1 600W dimmable HPS lamp down to 400W + two Apollo 8 Chinese-made lights with 3W diodes, a decent spectral mix leaning towards red 660 nm, + of course some blue and a bit of full-spectrum diodes + far-red diodes. Feeding in the last days: Day 64 Watering 5 liters per day Flora Nova Bloom at 0.7 ml (Flora Coco ran out, so I've been feeding Nova Bloom for about 10 days) per 1 liter of ppm watering solution 500 + Bio Bloom + Enzymes. Drainage ppm Mexica 980 6.2 - maximum.

SlySo_GD Translated to ripen on day 70, I started adding Flora Klean 5 days before harvest. The climate during this time is terrible - it's either hot or rainy, with constant fluctuations in temperature and humidity. For the last week, it was already alone under two LEDs and a 300W HPS. It has gained weight normally during this time.

SlySo_GD I recommend it to everyone, a lifesaving auto, well, you can see for yourself)