1st AutoGrow of TexasJack

Week 3 is starting off busy. Day 14 I finally got some Bone Meal. So, I added 2 more inches on topsoil. 1st I added 1/4 cup of Bat Guano ea., 1/3 cup Bone Meal ea., 2tbsp of Potassium Nitrate and Calcium Nitrate ea. Lightly mixed into top 1" of coco. Then I added 1-1/2" of Canna coco mix (perlite10%, worm casting25%) over top of soil. Then, I topped it of with cedar chips spread over both surfaces. Day 15, 12noon I watered both girls with 1/2Lt of 6.4PH water only. 8pm I decided to LST a couple of umbrella leaves each. Hope it helps with light penetration. There's a bunch of new growth under those two leaves. How does it look so far.... Day 18: Lot of changes... Switched my lights around. The TS-1000 made heat where the Pro2 Epistar 400W didn't. Was just a hunch but as soon as I changed the temp of the room went down 8degrees. The TS-100 was directly under the exhaust fan. Cool... Took the fan out and modified the base to give some more floor room, then added a humidifier. Was going to install a DIY Co2 generator but my silicone must he too old and didn't dry. I'll clean off, fix and install tomorrow. Ladies look great, I removed the LST wires from the two umbrella leaves. 2 days were enough to get the under foliage to grow past them. Watered 1Lt "water only" PH 6.2 each plant. Added some Epson Salt to foliar spray and cleaned off the leaves on each plant.