Not much change since last week. She did keep getting taller and I had to take my light off of the ratchets to buy 4-5” more space. I think there may have been a little heat/light stress on the taller colas but nothing too bad. I admit I’m pretty skeptical on a big yield at this point in the run. I just don’t see a lot of room for what’s there to really bulk up. There’s also not a ton of resin production yet. I’ve still got 4-5 more weeks to go and a lot can happen so we’ll see how she finishes. See you in a week...
@Gardenofweeden, you may be right, though this particular pheno didn’t have those big fat flowers like many other BD phenos I’ve seen. Looking at some of those other ones, 8 tops seemed like plenty. Ordinarily I would veg longer, but I needed the harvest to be done by a certain time in this case.
Good luck with DWC grow 😀 How is the water temperature? I want to try DWC next time too but I was reading that water temperature is the main issue (too high) and the roots will not grow and RIP.
@grzesiekkuzniak, I think that is the biggest lesson I have learned with this DWC grow. I switched to a sterile approach and since then I’ve had things dialed in. I change my water every week and use UC Roots, and I swap buckets each week with a fresh, clean bucket. After that if you just track pH and ppm and top off accordingly, it’s a stupid simple way to grow and I’m never doing it another way.
@iLoveGoodWeed,,if u change water frequently you can have temps up to 25 C and nothing will rot and no hydroguard needed..................dwc is about keeping it clean and not let water oxidize too much ...................too cold aint good too btw..........💩
@grzesiekkuzniak, I also found some adhesive cable clips that I’m going to attach to my bucket lid so I can more effectively train my plant, while also being able to move the lid and plant from one bucket to another.
@grzesiekkuzniak, early on in the grow I fashioned a little cardboard disc to cover the clay pebbles and keep light out of the reservoir and I wrapped it in tin foil and taped it to the bucket. It’s super janky but it’s working. I found some 1/4” thick neoprene sheeting I’ll use next time that has an adhesive backing and I’ll cut to my specs. Should be much less ridiculous looking.