Likes
Comments
Share
Decided to add another two a week later Just to complicate things a bit 😂. This will run beside diary 1. Germination was fast. this will be first RQS grow experience. never had a bad seed from PEV yet. alone.
Likes
9
Share
Zwei Wochen in der Blütephase sind nun vergangen, und die Pflanze wurde sowohl gescrogt als auch gelollipopt. Durch das Scrogging wurde die Pflanze weiter flach und gleichmäßig verteilt, sodass das Licht auch die unteren Bereiche gut erreicht. Zusätzlich habe ich durch das Lollipopping die unteren Blätter und schwächeren Triebe entfernt, um die Energie auf die Haupttriebe und Blütenansätze zu konzentrieren. Diese Maßnahmen fördern eine bessere Luftzirkulation und Lichtverteilung, was die Entwicklung gesunder, kräftiger Blüten begünstigt. Die Pflanze sieht jetzt schon vielversprechend aus, und ich bin gespannt, wie sie sich in den kommenden Wochen weiterentwickelt.
Likes
2
Share
@xTaps
Follow
26.05 While one run is still in full bloom, the next grow is already knocking – so here we go again. Plan: Germination will take place in a glass of water. Once cracked, the seed will be placed into an Eazy Plug, which is already sitting in the final 19L fabric pot. She'll veg for about 5 weeks in a 40×40×120 cm tent under a Sansi BR30 36W LED, while the main bloom tent is still occupied. After that, she'll move into the 70×70×160 cm tent under the Mars Hydro FC 1500 Evo 150W LED. Setup: 40×40×120 cm tent by Melko for Vegetation 70×70×160 cm tent by Mars Hydro for Flower Sansi BR30 36W LED @ 24/0 light cycle Mars Hydro FC 1500 Evo 150W LED @ 18/6 light cycle Mars Hydro 4-Inch exhaust system with app control Circulation fans: Mars Hydro & Taifun Mars Hydro 25×52 cm seedling heat mat with digital thermostat Nutrients: Organic: Biocanna Rhizotonic Biocanna Bio Vega Biocanna Bio Flores Biocanna Bio Boost Mineral: Terra Aquatica Calcium Magnesium Supplement Canna PK 13/14 The heat mat is set to 24 °C for germination. The water glass with the seed is currently sitting in the propagator. 27.05 Barely 24 hours later: the first white dot of the taproot is visible, the seed is still floating on the surface, a quick nudge was enough to make it sink. 28.05. 48 hours later, it's almost time. 30.05 96 hours after the start of germination, the seed was placed into an Eazyplug. For preparation, 100 ml of water were mixed with 0.1 ml of Biocanna Rhizotonic. The plug was briefly soaked in this solution (using a shot glass) until fully saturated, then gently squeezed to remove excess moisture. The remaining Rhizo mix was used to pre-moisten the surrounding soil in the final pot. The heat mat was set to 25 °C. The LED light was positioned near its highest point to provide gentle warmth and light for early development. 01.06 She needed a little bit help but did it. Welcome on earth, little seedling.
Likes
14
Share
@Terpyboyz
Follow
Alrighty growmies 👌🏻 so I’ve had a bit of a week set back due to issues, but back on track, the heat wave has definitely given a few girls a bit of a hard time not being able to attend but none the less, lifted the light again, trying to get on top of this PH fluctuating I’m having again using these stupid PH drops as my PH pen also keep jumping. Besides that I’ve managed to make a new home for the clones and got them under a couple UFO LEDs so that will house them for a few more weeks and al bring out the 600w HPS for them, but these runtz since being repotted have not taking nicely to it at all even using dynomyco so again hopefully by Friday they should be past that stage if not on flowering either way going to be a bomb scare when these taller plants start to stretch might have to bring out the net for sure 🤣🤙🏻 if all goes wrong at least I have my clones for back ups, keep eyes open for the incoming fire thou 🔥
Likes
6
Share
Likes
5
Share
@DBoogie
Follow
Hello Fellow Growers, 👻 Boogie on to week 2 with exceptional amount growth. Both of these girls are coming off strong. Not sure if its going well or not for my plants, but hey for the looks of it they seem to be doing just fine. Started my first LST after it grew a couple sets of leaves. I was really scared attempting the LST on the Tangerine Dream. I thought I did more of HST than LST. Keep the advice coming dudes! I haven't reached week 4 yet so I am going to continue on with the normal feed of Cali-Mag, Wholly Mack, & Big Bloom. I noticed with the Wholly Mack, it lowers my PH content down to 5.0. Is this normal with this kind of product?
Likes
31
Share
@Reaper
Follow
Very interesting week now. the buds start to swell up here, as u can see the stem is insane lol this is a freakin autoflower wtf the yield will be insane. shes drinking 3 liters every 2 days with 1ml/l greens sensation 1ml/l calmag and 1000ppm basic nutrient (4-6-6) Npk all under 1 400watt HPS bulb.
Likes
30
Share
@PPFDaddy
Follow
Hey everyone! This week I harvested another one of the girls, the one that looked the most ready in my opinion, at least judging by the trichomes. She still had quite a few white pistils, so it was a slightly cautious call, but I felt she was ready to come down. That leaves only two plants in the box, and one of them is honestly doing the work of four. Every time I open the tent, I’m still shocked by how much this Sticky has exploded. I may have found the magic seed. 😄 She is also the only one that has kept her buds truly huge and dense. The resin hasn’t spread heavily onto the leaves, but the flowers themselves are absolutely covered. I’ve already taken a couple of tops that were blocking light from each other, and I honestly can’t wait to try them. For the coming week, I’ll keep fertigating while lowering the EC by another 0.2 points. That’s all for now. As always, critiques and advice are more than welcome. Happy growing everyone! 🙌
Likes
14
Share
Hermoso progreso de esta nena, comiendo volumen y aumentando considerablemente la producción de resina. Me encanta la forma en que se desarrolló la estructura que soportará densos cogollos como puede verse. Es todo por ahora, Buenos Humos!
Likes
13
Share
@GYOweed
Follow
2 of 3. 3rd one cracked in same paper cloth for testing but was a dud. 1 jack knifed like a long trailer truck so i had to dig it up and bend it twice in one day lol. 1 looking nice n hairy. Hope to get a more sativa fast growing structure than zkittzy mutant. *update* making this 1/3 canceled the craplato due slow growth.
Likes
5
Share
At first glance she looks pretty unfinished. Checked a tester bud under the scope and the trichomes were fully cloudy. Never seen that before... trichomes that far along while almost all the hairs are still white 😅😇
Likes
18
Share
Both girls are frosty but only 1 is showing the reds.. Funny how that is with these autos 😂😂😒 .. I still love how they are structured. Enjoy the video.. And thanks for checking her out!
Likes
8
Share
@Lazuli
Follow
Week 8 flower, i flushed her now its the final week
Likes
26
Share
I gotta say this seed is very strong once the roots are established and healthy I’ve been hurting her since day 1 still she fought back like a true legend. But hey enough hurting her time to give her 2 weeks of getting fat. 😂💚
Likes
11
Share
7. Juni 6l Wasser 9. Juni 1,4l Wasser von unten, 3l von oben Nemabest Würmer per Torfmullen in die Erde verarbeitet. 11. Juni 4l Wasser Lampe ausgetauscht. 200w kommen nun von der sanlight evo 3
Likes
97
Share
She really growing excellent.. Buds forming nicely slight smell . pretty soon some frost should show up 😃..thanks todd for giving a seed so i can try the genetics👍🏆.. Thank you to all my GrowMies where would be without each other.. Thank you
Likes
10
Share
Nutes, watering: We're flushing this week 4L water + 4l water pH ~6.4 Training: No training Environment: RH this week is between 40-45% lights ~45-50 DLI Growth: Almost no changes this week. Except the higher leaves are gettin' yellow and a bit purple. Trichomes look almost done. I'm waiting until i see just a slight touch of ambers on the flowers themselves.
Likes
8
Share