Haven't updated due to being really busy , the girls are coming along but have had a huge problem with humidity which has then caused the plants to start getting powder mildew on the leaves, which is not good, I think the tent got to packed with plants , hopefully it doesn't effect the grow to much

Week 8 for the Kongs krush from greenhouse seeds 👌 This week we only gave sugars and sticky fingers from xpert nutrients. Amazing results so far 🤯 This strain exploded in thc, specially 2 of the plants For the rest we have water every 2 days. The plants will be harvest in some days

I dryed them slow. I deleted the original report si i had to make a new one without all the data about watering and so.

War nicht viel los. Die Crit stand im Dunkeln und der Topf war furztrocken.

Very pleased with how these girls are growing. Foilar feed them some coconut water and aloe Vera and they been taking it well. Stay tuned all is growing well

Have her a big defoliating to allow light to the bud sites and to reduce humidity in the tent , she took it well and is growing really fast still. The smell is very old school skunk type smell at this point

Growing well, so far. The added silica shows its effect - the stem is absolutely massive and solid, don't think LST is an option. I want to do either Topping or FIMing, but am not sure yet, which one. The decision will be shown in the pictures that I'll add, once the procedure is done. UPDATE: I decided to top Banana Kush Auto, as seen in the added photos and video.

I had to bring her back inside this week. She was still growing in the greenhouse, but stuck in preflower. She was getting taller and taller with no budlets in sight. Hhmmm i wonder??? You guessed right, SHE IS A PHOTO PERIOD! FXCK! so i had to take my Zkittles that was in preflower outside earlier than i wanted, in order to make room for this huge lemonberry haze that i had to start 12-12 on. Three days of 12-12 is starting to give me pistols....so she IS NOT an auto. She is still GROWING, and the 2 main tops are getting close to the leds. I had to tie her down using pipe cleaners and the tent frame. I sure do hope she doesn't get to much taller. I don't want the leds to burn her up, as i cannot raise them anymore. The LEDS are zip tied directly to the tent support frame and the support lines have been double looped to half their original hanging length. There is not much more i can do but start tying her down to the tent poles. THIS GIRL IS GOING TO BE A MONSTER YALL! Stay tuned! Other than the inconvenience of it being a photo, if i can pull this off with the limited space i have, she should yield HEAVY.

Sooooo this has been an amazing and exciting week! Ive been patient with this last plant and really checking the trichomes i inly wanted a few amber caps on the nugs, was looking for milky on this one! Shes smelling amazing and the color change was such a sight to see! She did so well with the nutrients and loved the 2 week flush i did! I cut her down did a wet trim and have em in the drying rack! Im excited to see how she cures and drys ready for the smoke reveal! Much love and happy growing!!! *check out the examples of the rewards from the traing i did with lst, hst, desolation love seeing this!!* learning this craft and style of growing is a blast! And everyone should try it!

OG 4Q24 Flower Week 7 Orangegasm (Fem) [ IRIE Genetics ] 12/12 @ Bolt (Day 21) Germination: 20 November 2024 #3A Earliest Harvest Date: 9 February 2025 #3B Latest Harvest Date: 19 February 2025 _________________________________________ Start of Week: [Wed Jan 22, 2024 CR2 4Q24 43:F:6:1] End of Week: [Tue Jan 28, 2024 CR2 4Q24 49:F:6:7] OrangeGasm Fertigation: - MAX: EC: [ 2.4, mS] - LightIntensity MAX: [ 850, µMol/m2/s] ______________________________________ __ Wed Jan 22, 2025 OG 4Q24 43:F:6:1 - [x] R&R Each Drip Ring Assembly (Assure NO Fertigation/Bio Build up) Runoff - Amount: [ .5, l] - EC: [ 3.8, mS/cm] - EC∆: [ 1.2, mS/cm] # Danger! Refresh Res (Filtered, pH’d Tap Water) - [x] Amount: [ 2, gal] - [x] Primer A&B: [ 35, ml] - [x] SLF-100: [ 10, ml] __ Thu Jan 23, 2025 OG 4Q24 44:F:6:2 Refresh Res (Distilled Water, pH: 7, EC: 0.0) - [x] Amount: [ 2, gal] - [x] Primer A&B: [ 39, ml] - [x] SLF-100 Runoff - Amount: [ 1.2, gal] - EC: [ 4.3, mS/cm] - EC∆: [ 1.6, mS/cm] # DANGER __ Fri Jan 24, 2025 OG 4Q24 45:F:6:3 Runoff - Amount: [ 0.3, gal] - EC: [ 4.1, mS/cm] - EC∆: [ 1.4, mS/cm] # DANGER  __ Sat Jan 25, 2025 OG 4Q24 46:F:6:4 Dump Res - [x] Remove Chiller and Fertigation Pumps - [x] Dump and CLEAN Reservoir, Note Sediment - [x] Detach Main Feedline - [x] Clean Chiller Pump - [x] Clean Fertigation Pump - [x] Dry ALL Components - [x] REASSEMBLE When Dry - [x] Clean 1/2” Fertigation Mainline Watered In Primer A&B, CalMag Fuel, Silica Skin - Amount: [ 1.9, l] - EC: [ 2.7, mS/cm] Refresh Res w/ Full Hydro (Primer A&B, Silica Skin) - [x] Amount: [ 4, gal] - [x] EC: [ 2.7, mS/cm] - [x] Primer A & B: [ 73.1, ml] - [x] SLF-100: [ 40, ml] Runoff - Amount: [ 0.25, gal] - EC: [ 4.1, mS/cm] - EC∆: [ 1.4, mS/cm] # DANGER __ Sun Jan 26, 2025 OG 4Q24 47:F:6:5 Refresh Reservoir - 2 Gal, EC: 2.7 - [ ] Check, R&R Fertigation Manifold Filter as Needed - [x] SLF-100: [ 10, ml] - [x] Primer A & B: [ 40, ml] Runoff - Amount: [ 1.25, gal] - EC: [ 4.2, mS/cm] - EC∆: [ tbd, mS/cm] __ Mon Jan 27, 2025 OG 4Q24 48:F:6:6  Watered In Primer A&B, CalMag Fuel, Silica Skin - [x] Amount: [ 1.9, l] - [x] EC: [ 2.7, mS/cm] IPM - [x] Spray sides - cover Air holes of Airpot - [x] Spray tops of pots to drench - [x] Dr. Zymes, 28ml/quart @ 85°F - [x] APPLY Mosquito Bits to Top of Containers Runoff - [x] Amount: [ 1.5, gal] - [x] EC: [ 4.9., mS/cm] - [x] EC∆: [ 2.2, mS/cm] # *** Plants Should Be Fried! Need to R&R Pre-Filter again. Fan Flow significantly diminished. __ Tue Jan 28, 2025 OG 4Q24 49:F:6:7  Replace ACI Pre-Filter - [x] Remove Plants - [x] Disconnect Irrigation Emitters - [x] Remove and Rinse Drain Tray - [x] Drop Front of Light - [x] Remove & Replace Pre-Filter - [x] Verify Airflow (Make sure we don’t need to change the carbon in the filter) - [x] Raise front of light to run position - [x] Replace Drain Tray - Reposition Shims - [x] Replace Plants AS THEY WERE - [x] Replace Emitters - [x] Verify Irrigation Runoff - [x] Amount: [ 0.5, gal] - [x] EC: [ 4.8, mS/cm] - [x] EC∆: [ 2.6, mS/cm] # *** Plants Should Be Fried!

FLOWERING First flowering phenomena are visible in the tops of the plants.😜 -------------------------------- GROWTH The plants are still growing rapidly. To keep the size of the plants somewhat at the same height, I use the following techniques: 😷 1. Removal of the side branches (Defoliation) -Small plants: I remove almost all side branches. In this way the small plants do not have to spend energy in the growth of side branches. -Large Plants: I don't remove anything. The plants will put energy into the growth of side branches, so the plants will not grow too fast in height. -Other plants: I remove the side branches in proportion to the size of the plants. In the course of the following days, I gradually remove all low side branches! 2. Tying the branches (Low Stress Training) -The smallest plants grow straight upwards. -The largest plants are tempered in their growth, afterI have tied them to the plant sticks with the help of plastic plant binders. On DAY 5 the plants vary in length between 23 and 41 cm AIR HUMIDITY 😨 When the lights are on, it gets nice and warm in the growing room. To keep the humidity at the desired level, I have two 7.5 liter humidifiers working almost continuously. In less than 24 hours I have to refill them. As long as the plants do not have real buds, I like high humidity so the plants to keep a low VPD. -------------------------------- WATER and NUTRITION 😱 Due to the high humidity, I don't have to give that much water. Every 3 days I give 1.25 liters of water per pot. I add 3 tablets of Easy Grow Booster to 10 liters of water. I divide this mixture between the 8 pots. This week I gave 2 x water.

They are kicking

Starting a new grow Shout out and an a HUGE Thank you to HowWeedGrow and Selfie Seeds for sending me these seeds and making this possible. I'll try my best to make it a good grow. I dropped 2 of the 3 seeds I got in a glass of 6.4ph balanced purified water for 15hours and transferred to paper towel. Updates as they come. details of this crossbreed... https://selfieseeds.com/mother-strains/strain-cross-difference/sweet-slurry-x-sugar-cane-in-house-genetics Feminized Seeds Indica/Sativa 45/55 Hybrid Receiver (Mother): Sweet Slurry Indica/Sativa Hybrid Lineage: (Dosidos X Purple Punch) x (Platinum x Slurricane) Donor (Father): Sugar Cane Indica/Sativa Hybrid Lineage: Platinum x Slurricane - Indica Sativa Hybrid Reversed using STS on a clone of Strain 4 in the video below. Full reversal was documented in this journal. The receiver(mother) was grown in soil using the HWGrow Soil Feed Schedule and the donor(father) was fed the HWGrow Hydro Feed Schedule. Actual data collected from the grows contributed to the final numbers in our feed schedules. The complete harvest on the seeds were documented on my journal on discord which could guide you if you grow this cross. Goal of the Cross: The photo with the buds shows what the final buds harvested from both parents look like after drying and curing(Sweet Slurry on left, Sugar Cane on right). This cross will produce a combination of both of the parents. Sweet Slurry is actually a backcross of Slurricane and Sugar Cane so this would be a 2nd generation Backcross which has the potential to improve frost. It's a crap shoot, but you could get lucky and it could happen. This will ultimately stabilize this cross into a strain and you really cant go wrong with frosty x frosty. This cross is the reverse of SHUGA.

She is also experiencing a general yellowing all over. I contacted Advanced Nutrients support and they consulted me to increase the feeding. Let’s see how it goes. On the other hand, she keeps growing buds. Looks like stunned a little. That’s why I am waiting another 2 days for lollipoping.

Idk

5/3 Week 6 Last day for Grow nuets looks like stretch is stopping. Will confirm in the AM. Also be ending the round of PK tomorrow. Lights at full power and set to @16 inches to start. Leaving the MH bulb in place a couple of weeks Very light defoliation just to keep middle of the plants open, this strain does not need much at all. 5/4 Ending Grow nuets as stretch is playing out so no further need of the Nitrogen, lot in the pot still. Last day for the PK on this go round. Next time we grow this strain going to look at alternate methods of training, FIM is the likely candidate. 5/5 Back down to just Bloom A/B nuets Stretch slowing down as Baba and Sally reach the same height as Athena that started first. Everybody seems happy even the little one 5/6 Moved up the lights, was seeing some light stress on the girls, leaf praying. Bumping up the Bloom nuets for now see how it goes, getting close to next round of PK booster waiting for the cotton balls to develop sufficiently. Gave all a shot of Fish Sh!T this morning 4ml/gal. Pretty much all of it 5/7 Pics Raised lights further still have some praying leaves. Tomorrow should be PK day as the cotton balls should be formed by then. 5/8 Looks like the last the stretch has finally ended on Baba, thought she was going to be a good kind of problem but didnt have to raise the lights today so there is that. Have to be careful with these lights and watch for light stress more diligently than I have so far. HID at 600w is 17 inches above the rear plants, TS at 150W is 18 inches above the tallest front plant(Sally), seems to be working. Added KoolBloom back into the feed, 2ml/gal, the buds have become little cotton balls so its time. Cleaned up the lower end of the plants, was getting snaky down there. 5/9 pics Ending the week by doing a little bending on the tallest branches on Baba, they were a full two inches higher than any other. She is still growing a little but nothing to really notice.

The ICE is almost done; the NL doesn’t even seem close. Interesting since ICE sprouted a day later than the NL.

18.7.2k24 New start maximal flowering with Plagron Green Sensation. Cutting large leaves for maximum air flow..🚁 🌿🌸🌹