The Grow Awards 2026 🏆
Likes
Comments
Share
@Abreuvoir
Follow
12 june 2022 -Second transplantation -Four plants in a single pot -Did some LST -The pictures from day 21 to day 23 show they took the transplantation well -Time lapse video
Likes
11
Share
Here we are at the halfway point, after the first month our photoperiod plants are multiplying their florets and then going into flowering. Jet Fuel has just undergone the topping of 8 florets, you can see the 4 fresh florets just cut. We are therefore at 8 very small branches growing, my plan for photoperiod plants is to get to 16, wait a few days and go into flowering. 16 florets as I see it is the perfect size for the 11 liter pot. Topping is an extremely delicate moment as regards cutting the florets to split them, we always take care not to damage the new growing florets. Topping is also a delicate moment as regards fertilization because the plant slows down and absolutely does not need all that nitrogen that it would normally need and that the producers recommend in their sheets. So you should arrive with the plant green and in perfect shape at this moment and dose the fertilizer very well for growth. Mine came from a slightly deficient veg because I kept it low fearing this over effect during the topping that I know well and now I'm a bit over. Nothing to worry about, of course, but if you do repeated topping my advice is to use preferred soil or prepare the soil with Monster Bud Mix by Zamnesia or Plagron Super Mix, in short, enrich the soil and start and only add nitrogen if necessary, especially during repeated topping. In any case, everything is under control and I will demonstrate it to you during the flowering phase. Wait for the Uncle BreadandBuds and see what it does to you. Remember the cold temperature makes the girls absorb food much more slowly than in summer so be careful to give the right amount and to dry the plant in maximum 2 days or you risk imbalances. We are always using soil, feeding and all the recommended additives from Plagron 100& organic we have only lowered the amount of grow in this topping phase for the reasons given above. ---- Decide on the right soil and calculate your fertilizer card based on the soil on the official website. -- www.plagron.com Try a seed of this strain that drives us crazy... ---- https://www.zamnesia.io/it/11258-zamnesia-seeds-jet-fuel.html Zamnesia Description // Jet Fuel (also known as G6, Jet Fuel OG, and G6 Kush) is a modern hybrid rich in THC and terpenes with a diesel aroma. Originally created in Colorado by crossing Diesel with Aspen OG, this 60% sativa-dominant hybrid is a must-have for any smoker who enjoys an uplifting and energizing high. Now, thanks to the hard work of our breeders, the original Jet Fuel is even easier to grow at home. Order your seeds, plant them in soil, and enjoy their rapid growth. After just 9–10 weeks of flowering, you can expect a generous harvest of premium sativa buds! All the best that mother nature can offer is on —— www.zamnesia.com *Sorry I Don’t know why I dont find the white background photo only for this strain
Likes
56
Share
@Evi1tek9
Follow
I flushed them on day 48 with straight R/O water No more nutes, hoping to get a good 10-14 day flush Swelling more and more each day, getting more and more frosty each day
Likes
2
Share
Vamos familia quinta semana de estás Pink Runtz de RoyalQueenSeeds. Que ganas tengo de ver el progreso de esta variedad, las plantas están sanas, se ven con un color bien verde y espectacular. La cantidad de agua cada 48h entre riegos. Esta semana ya añadimos nutrientes, estas próximas semanas veremos cómo avanzan. Agrobeta: https://www.agrobeta.com/agrobetatiendaonline/36-abonos-canamo Hasta aquí todo, Buenos humos 💨💨💨
Likes
9
Share
@GrowerGaz
Follow
So just been keeping an eye on the ph and ec staying pretty stable. Water temperature is good at 21.3c. ec .03 ppm 277
Likes
144
Share
@roro_204
Follow
I received the clones from An out of province breeder. It reached me after three days of driving on the road with no light. Their future was not certain. I didn’t think I would need that many fans for the clones because they are so tiny, I figured they didn’t need that much maintenance. I was 100% wrong when I’m working with this many plants. I ended up getting mild mildew on top of the soil on the first week because there was barely any air circulation. At this point I didn’t have any Ventilation put up yet. And one fan on the floor. I ended up installing three fans in one room. No issues
Likes
3
Share
Es wurde in einen 3 Liter Transplanter Stofftopf von Gronest umgetopft - Natürlich in die gute Rosenerde von Floragard - Die Wurzeln sind schön weiß und super vital - Gleichzeitig wurde die Lampe auf 12/12 umgestellt. 😎
Processing
Likes
9
Share
Temps are looking to be better the next few weeks and when on a good watering schedule humidity goes above 50%. I've just been bending branches that shoot above the canopy down. I still need to update the measurements of length and distance to plant. Lollipopped on day 11 (Jul 2nd) the amount of lollipopped space down below is about 30 cm(1ft) With this light I think I'll be aiming for a half foot(15cm) to a full foot(30cm) of canopy depth. Getting the top sites as close as I can to 30 cm below the light so I have the top 15 cm of canopy at the most efficient distance for this light. Optic LED recommends a spacing of 30 to 45 cm (1 to 1.5 foot) fixture to tops for flower. anything further away than 45 cm will probably be fluff, but! Anything fluffy will be left on and used for old school bottle pressed hashish. My family, with exception of my girl will have to fight me for that hashish, it's been way, way too long since I had some good hash. Plus there's no way I'm yielding more than a gram or two of hash from larf alone. Plant height is measured from soil level btw, she's about 60+ cm pot included. Moved the light up to 45 cm above the canopy again and I'm already maxing out on vert space, with only about 5-10cm remaining. Switched the light cycle from 14 hours on to 12 hours on to be sure, she's leaning more sativa but she was initiating flower. (Which I'm amazed I could even tell she was initiating bud development) However having her re veg at week 5 would've sucked very much So far the vibes from this run I'm getting is that I'm still nowhere near great or even good. But I am, at least, slowly starting to get there. Recovered from defoliating nicely.
Processing
Likes
27
Share
Likes
31
Share
@Haoss
Follow
I have to dry the buds in the dark, at 20 degrees, 50% humidity
Processing
Likes
12
Share
Likes
8
Share
Almost ready, want to give 1 more week for some brown trichomes. Otherwise it's ready. Tones of super nice dence crystal buds. Great genetics. Last few times watering with raw cane molasses or just water. Very good genetics 💯
Likes
29
Share
@CANNASIM
Follow
—SETUP— .BOSSLED LED 1800W full spectrum, real power consumption is +-250W. .Grow space 60X100X200(a simple shower box. .AN nutes and other simple additives. .Grow medium is 60% peat, 30% perlite, 10% organic correction(worm castings), 5 gallon fabric pots(18l). —BRIEF— Hi there, I have tried already done this genetic outdoors, in poor lighting and a general purpose nute from Neudorff, yielded 25g dry, in 3gallon pots same medium. So this is a good experiment, lets see indoors how she will compare. —GERMINATION— My germination process always start by scarifying the seeds, i created a little tool for that. I just a little container with sandpaper walls. Shake gently for about 60 secs+, this allows for the water to penetrate better in the seed shell, once you soak. Then i soak overnight from 12 to 20 hours max. From there i either plant straight or use the paper towel method to see the tap root before. If you are a bit on the impatient side seen the tap root is advisable so you see some movement before planting. Lol! —ROYAL QUEEN SEEDS . QUICK ONE . INFO — Chose this strain because is basic and I have to travel for a month soon, and someone else is going to take care for this time. :) Quick One is a fast-growing autoflowering strain. This was one of the first autoflowering strains developed. When it was first released, it was one of the quickest growing strains on the planet. THC: 13% CBD: Low Yield Indoor : 275 - 325 gr/m2 Yield Outdoor: 100 - 150 gr/plant Height Indoor: 50 - 60 cm Height Outdoor: 60 - 100 cm Flowering: 5 - 6 Weeks Harvest month: 8-9 weeks after sprouting Genetic Background: Strong Indica x Ruderalis Type: Sa 10% In 60% Ru 30% Effect: Physical Climate: Mild —RQS QUICK ONE GERMINATION UPDATE— My mood said to me to plant straight, so scarify > soak 18 hours +- > plant straight. Seedlings look a bit odd, with a yellow center, let's give her some days in and see what happens next.
Likes
47
Share
@S2340420
Follow
This was a good grow couple of ups and downs weather wise and the moment of devastation when seeing my fattest cola had been affected by bud rot this was a solid happy nug yesterday and today well thenpics tell a tale all other buds were fine and are drying as we speak ye win some ye lose some some are just fkin annoying
Likes
25
Share
Currently checking daily and tying away branches/leaves to give the buds more light and watering when the soil is dry. Currently my plants drink exactly 1,5L a day. I have the feeling that the right plant is lacking a bit of potassium. I'll leave everything as it is for now because the left plant (fresh new soil) is growing well. Since the right plant is quite bushy anyway, I'll defoliate it again later and remove any lower shoots. I started adding the Bio PK booster towards the middle of the first week of flowering, 2ml per liter of water; as the pH value drops too much, I correct it upwards with Biobizz pH up - from pH 5.5 to 6.5 for 3L, I add a total of 39 drops. My water is mixed as follows: 3L osmosis water, plus 6ml CalMag, 6ml BioPK 5-8 and 39 drops of pH + BioBizz.
Likes
1
Share