Likes
Comments
Share
Week 5: A little yellowing on the leaves this week. We believe we have a Mag deficiency. Will adjust when watering. Did a flush due to this as well with Cal/Mag in the water. Defoliation: We took a lot more off this week due to the growth spurt. LST: using paper clips for LST and it is working amazingly. They have really adjusted well to it. Height (inches): GSC1 21.5; GSC2 15.5; GSC3 15; Delight 17 7.19.22: The back left GSC grew 3 inches overnight - crazy!!! Raised the light to accommodate it and placed the other girls on a box to be at her level.
Likes
21
Share
2024-05-09 Directly after the Photoshoot, i topped them. they had a super progress and you can watch them growing big steps every day. All will started Indoors under SANlight Flex 25, and move Outdoors. Only one Plant stays indoors, to see the performance under best Conditions because my Outdoor Garden is hard^^ So i started with letting them soak, and then the seeds will move under a humid Kitchensponge unil i see a sweet Taproot. then they will go into the Final Pot, filled with lovely TerraPreta mj mix the grow will be supported with Biotabs fertiliser Breeder Information Fatso GMO F1 Auto is a feminised hybrid strain that is the result of crossing two autoflowering strains, viz. Fatso Auto and Cotton Candy Auto. This Cali-derived, slightly sativa-leaning, easy to cultivate strain will please growers with its big yield, solid THC content and its sweet, candy and fuel palate. Fatso GMO F1 Auto will grow well both indoors and outdoors. It has an above-average resistance to mould but will still benefit from good ventilation, especially where humidity levels are quite high. Resistance to plant pests and other pathogens is excellent. While plants will remain quite short at around 100cm or less indoors, they can grow a little taller, reaching a height of 130cm, outdoors in open ground. The entire cycle is completed in a maximum of 75 days from germination through to harvest and although yields are said to be average this is still pretty impressive for an autoflowering strain. The combination of high resin production and high terpene levels make Fatso GMO F1 Auto a very good strain from which to make cannabis extracts. The terpene profile is sweet and funky with savoury scents of Skunk with pine and floral notes. The taste is like sweet candy with hints of fuel. THC production is high, reaching 24% while CBD is low. The effect is uplifting and well-balanced.
Likes
Comments
Share
@MnmlMe
Follow
Riecht sehr gut
Likes
Comments
Share
@SGCFarms
Follow
Day 17, and she’s starting to show sugars from the top down. I can’t wait for a smell to develop, but when I did smell something during the first opening of the tent it smells something fruity. She’s drinking at least 4 gallons a day at this point.
Likes
1
Share
35 days in Bloom, the Bruce Banner lady may be a bit smaller, but the buds she’s producing are epic. They’re already completely covered in resin, and a sweet scent of strawberries is starting to emerge. Watering has been kept simple with just dark molasses and microbes. 🌲🍀
Likes
5
Share
@Zeaiache
Follow
Se lograron estabilizar después del transplante, y logran comer bastante, los riegos son cada 2 días, allá purple nos da una distancia internodal mas corta que la 10th, aun así ambas están hermosas
Likes
2
Share
@Enki_Weed
Follow
Dienstag war ein großer Tag für meine Pflanze – sie ist jetzt offiziell im Blüte-Modus! Das bedeutet eine Umstellung auf den 12 Stunden Licht- und 12 Stunden Dunkelheit-Rhythmus. Kurz davor habe ich sie noch entlaubt, um sie auf diese wichtige Phase vorzubereiten. Auch die Wasserzufuhr habe ich angepasst, sie entspricht jetzt den Empfehlungen für die zweite Blütewoche. Zum Glück ist das Problem mit dem pH-Wert endlich Vergangenheit. Das hat mir wirklich Kopfzerbrechen bereitet, aber jetzt scheint alles stabil zu sein. Das aktuelle Sorgenkind ist allerdings die Luftfeuchtigkeit. Sie ist momentan leider viel zu hoch, und ich muss mir überlegen, wie ich das am besten in den Griff bekomme. Das ist jetzt meine nächste große Herausforderung.
Likes
14
Share
Day 50. Switched from maxigro to maxibloom, plant is taking well to it.
Likes
39
Share
All three plants are hermaphrodites, however, plants 1 and 2 are showing minimal signs of male with seeds developing only on lower nodes, while plant 3 looks mostly male with a few pistils only on the very top nodes. I've decided to pluck the seeds from plants 1 & 2 as they develop, and to toss plant 3 to make room for the other 2. It's not ideal and I plan to buy feminized seeds or clones for my next grow, but the bud I got the seeds from was actually really good so I'm going to try to take 1 and 2 to harvest.
Processing
Likes
23
Share
@Grey_Wolf
Follow
FastBuds Sour Diesel Auto 4th week of flowering completed 11th Jan 2020 Another weeks gone by here and not a lot to report other than both the sour diesel girls are smelling quite nice The normal plant looks great and has been very easy to grow and plant number 2 (polyploid) continues to do her thing. Sorry about the lack of picture quality it's because I find it hard to get clear shots in the sunlight. I need to work on my photography skills . 😁
Likes
92
Share
This girl is doing well nice side branches before fiming but find her any way hitting her with the Shogun line up put a vid up of e.c and pH of feed i don't check often as it's always the same roughly just in flower i switch the calmag and silicon for a boost and a pk she's healthy and happy not much to say as she's all good thanks for reading happy growing guys
Likes
9
Share
Will be flushing this week and hopefully harvesting next week. Looking good, strong trichomes production and smell is incredible for both.
Likes
3
Share
@LAShugars
Follow
Doing ok think I have a nutrient deficiency Going to increase the nutrients tomorrow The humidity is out of control. Just finished SuperBoof and will be moving the testers into the 2x4 after it’s sanitiz
Likes
10
Share
Activaron 24hs en un vaso de agua sin cloro. Luego al tupper con papel (rollo de cocina). Luego de 3 / 4 días ya se pasaron a tierra. En los primeros días y luego, en toda la etapa vegetativa vamos a usar un humidificador para tener una humedad entre el 70% y 80%
Likes
12
Share
Day 29 (Second Grow): "Hey everyone! Starting a new week with some exciting plans! 🌿 We've got about one more week before we transition the plants to the flowering phase. Just to recap last week's updates for those following along: We’ve named all the plants in both grows. This makes it easier to identify and keep track of each one, especially if they get moved around. It should also help you all follow along more easily with the pictures we post. We've built a SCROG (Screen of Green) net for the plants. A SCROG net helps train the plants to grow horizontally, which maximizes light exposure to all parts of the plant and promotes more even growth. We're using it to ensure all plants get plenty of light and develop a uniform canopy. We’ve placed a hygrometer among the plants to measure the humidity between the leaves. We've noticed that the humidity sometimes exceeds 70% in those areas. We're considering whether we need more fans, an intake ventilation system, or if a dehumidifier would be a better option. We're leaning towards adding more fans to improve air circulation, but we'd love to hear your thoughts and suggestions! Stay tuned for more updates as we continue to watch both grows progress and prepare for the flowering phase!" Day 33 (Second Grow): "Hey everyone! Exciting news for our second grow: we’ve added a new member to the grow tent – a praying mantis! 🦗 Her species is Timor shield mantis, and she still needs a name. We got her to help with pest control naturally. Praying mantises are excellent predators and can help keep unwanted insects away from our plants. Feel free to suggest a name for her! Any tips or fun facts about keeping a mantis in the grow tent are also welcome!" Day 34 (Second Grow): "Hey everyone! Big update today: we’ve switched the timer to a 12/12 light cycle to initiate the flowering phase! 🌸 Our second batch of plants, just like the first, has developed well and we believe they’re ready to start blooming. This change should encourage them to shift their energy towards producing buds. For those following along, here’s a quick recap: We've implemented a SCROG net to manage the canopy and ensure even light distribution. We've introduced a Timor shield mantis for natural pest control. The plants have responded well to all adjustments and are looking healthy. Now that the flowering phase is starting, we’re excited to see how they develop over the next few weeks. Any tips or advice for optimizing this phase? Let us know in the comments!"
Likes
1
Share
Moved light closer and added a resin boost tea I’ll do it two more times looks like they like it
Likes
7
Share
@darb35
Follow
One of the LCC and the RAK are little runtz, and the other LCC is growing almost twice as tall. They all look pretty healthy, and I am trying hard not to over do it with light intensity. I think in about a week or so they will go into flower.
Likes
3
Share
We’re kicking off week 3 of veg today, and things are looking up. She seems to be bouncing back nicely from that magnesium deficiency—leaves are perking up, color's evening out, and overall growth is picking up again. I topped her at the 5th node and gave her some light LST. After about 3–4 days of recovery, I removed a few lower leaves that were sitting in the dirt and getting in the way during watering. Feeding her 500 PPM at a pH of 5.8
Likes
27
Share
Vamos actualizar la cuarta semana de crecimiento de estas Biscotti de RoyalQueenSeeds. Será la última semana de crecimiento, ya voy a cambiar a 12/12 es un SOG La humedad es perfecta, la temperatura me gustaría tenerla par de grados más abajo pero aún así es pasable. Aplico el flash root de Agrobeta y Blue line A de Agrobeta. Esta semana añadí tucán y gold joker también de Agrobeta. Mars hydro: Code discount: EL420 https://www.mars-hydro.com/ Agrobeta: https://www.agrobeta.com/agrobetatiendaonline/36-abonos-canamo Hasta aquí todo, veremos como progresan pronto. Buenos humos 💨💨💨