Likes
17
Share
Sono contento e difficilmente sono contento. Cinque piante identiche e sembra di fumare la vera gorilla glue con note dolci quasi a ricordare delle caramelle. Una pianta invece ricorda di più la zkittlez. Davvero contento di aver scelto questa casa 😊
Likes
39
Share
A pesar de lo lento que se han desarrollado, vamos avanzando bien. Se viene el trasplante y corte de las hojas más bajas y se rellenará con sustrato hasta el nodo más cercano. Seguimos ...
Likes
2
Share
@Iurius
Follow
По Моему уже Начела Моя Девочка Цветить.. Жду не Дождусь 🙂 А Так В общем Я правда Потресён её Выносливостью. Думаю Что Одна Из Самых Уникальных Стрейнав От @PyramidSeeds ❤️🌱
Likes
1
Share
@JLaser
Follow
Not much has changed since last week. Sugar leaves are developing more than the buds are.
Likes
1
Share
Muy caros los productos, efectivos pero me sigen pareciendo caros, probaré nuevas gamas! Un saludo
Likes
3
Share
Likes
8
Share
@Arachnia
Follow
I've moved lights towards them, so now the lights are 15 cm above them. I've moved a fan a little bit higher, so the wind is not too strong for them now. Hope she will be well now.
Likes
8
Share
Gonna start flush this week….everything looking great…no problems this run I love it when they grow themselves practically
Likes
2
Share
15.02.2026 Auch die dritte Woche verlief unspektakulär. Die Pflanzen wachsen sehr gut, bilden sehr kleine Nodienabstände und sehen allgemein gesund und vital aus. Die Pflanzen bekommen aktuell ca 300ml Wasser mit 2,8ml/L Calmag. Die „Mexican Airlines“ , die aktuell ganz rechts unter der Spiderfarmer Lampe steht, zeigt leicht krauses Blattwerk. Ich hab nun die Pflanzen mal umgestellt, um Stress durch die unterschiedliche Beleuchtung auszuschließen. Falls das so bleibt, wird’s wohl die Genetik sein. Falls nicht, wird durchgewechselt.
Likes
17
Share
@Hashy
Follow
Week 1 Light cycle=24/0 Light Power=73w 30% Extractor controller settings High temp= 23c Low temp= c Temp step=0c High Rh= 70% Low Rh= % Rh step=0% Speed max=5 Speed min=1 Smart controller settings (during lights on). Lights on=am Radiator on= not in use. Radiator off= not in use. Humidifier on= below 63% Humidifier off= above 68% Dehumidifier on= not in use. Dehumidifier off= not in use. Smart controller settings (during lights off). Lights off=pm Radiator on= not in use. Radiator off= not in use. Humidifier on= not in use. Humidifier off= not in use. Dehumidifier on= not in use. Dehumidifier off= not in use. VPD aim=0.4-0.8 DLI aim=15-18 EC aim=0.4 PH aim=6.2 Fri 22/12/23 #1 (Day 1) 📋 5.00pm Leaves open and working on its 1st set of true leaves. 💧💧💧💧💧💧💧💧💧💧💧💧💧💧💧💧 Method= manual Neutralise=0.1ml/L Roots=5ml/L Feed=nutes Volume=100ml Easy Ph down=0 drops/L Ec=0.36PH=6.3/6.0 Time=10.00pm Runoff. Total runoff=10ml Ec=2.85 PH=5.7 💧💧💧💧💧💧💧💧💧💧💧💧💧💧💧💧 📋 Calibrated ph pens in ph 4/7 solution. Older pen read 6.8 Newer pen read 7.1 Sat 23/12/23 #1 (Day 2) 📋 Looks ok. Root has hit the bottom of the pot. H=5cm D=82cm DLI=15.8 Sun 24/12/23 (Christmas eve) #1 (Day 3) 📋 Still working on its 1st set of true leaves. Mon 25/12/23 (Christmas Day) #1 (Day 4) 📋 Merry Christmas everyone. 10.30pm This tester looks good, 1st true set of leaves are developing fine. Started developing 2nd set of leaves. Tue 26/12/23 (Boxing Day) #1 (Day 5) 📋 💧💧💧💧💧💧💧💧💧💧💧💧💧💧💧💧 Method= manual Neutralise=0.1ml/L Roots=5ml/L Feed=nutes Volume=150ml Easy Ph down=0 drops/L Ec=0.28PH=6.2/6.2 Time=7.00pm Runoff. Total runoff=20ml Ec=2.91 PH=5.6 💧💧💧💧💧💧💧💧💧💧💧💧💧💧💧💧 Wednesday 27/12/23 #1 (Day 6) 📋 She has got a massive lean on her, probably through watering yesterday. 9.30pm decided to stake her as she's nearly touching the soil. Before changes. H=8cm D=80cmDLI=14.8 After changes. H=8cm D=77cm DLI=18.3 10.00pm Light cycle=22/2 Light power was=73w=30% Light power now=86w=36% Lowered light by 3cm. Extractor controller settings High temp= 24c Low temp= c Temp step=0c High Rh= 70% Low Rh= % Rh step=0% Speed max=5 Speed min=1 Smart controller settings (during lights on). Lights on= 02.00am Radiator on= below 19c Radiator off= above 20c Humidifier on= below 64% Humidifier off= above 67% Dehumidifier on= not in use. Dehumidifier off= not in use. Smart controller settings (during lights off). Lights off=00.00am Radiator on= below 16c Radiator off= above 18c Humidifier on= not in use. Humidifier off= not in use. Dehumidifier on= not in use. Dehumidifier off= not in use. Thursday 28/12/23 #1 (Day 7) 📋 H=8cm D=77cm DLI=18.3 She will probably only need the support for a few more days, the lean was from over watering. So this week she has developed her single fingered true leaves and is working on the next set of 3 fingered leaves. Conditions for the week have been good. Back soon. Take it easy.
Likes
2
Share
Everything is not as accurate as I would like to say, but I wanted you guys to see what I can do
Processing
Likes
Comments
Share
Likes
6
Share
After you found some good sector and clone it you let the mycelium grow and fill almost all the petri dish like I did last week. So now you're ready to move forward. Making grain spawn!🍄🍄 For grain you can use Organic Rye Berries, but you can also get away with wheat berries, or brown rice or even corn kernels(which I used myself) ! And you'll need some mason jars or honestly I used some jars that I had home just clean them very well and sterilise before using Making a grain spawn can be broken down into 6 easy steps. 🍄Hydrate Grain By Soaking 🍄Make Specialized Lids 🍄Simmer, Drain and Dry The Grain 🍄Sterilize 🍄Put your agar in the jar 🍄Colonize 🍄Soak the grain by placing it in a bucket, covering in water, and leaving it for 12 -24 hours. Easy. 🍄Drill 1 hole on top of the lid. Right in the center and cover with a small dab of high temperature silicone sealant, and leave it overnight to dry. And your jars are done. There other diff types for different methods like liquid culture etc. But I'm just going roughly through what Ive done. 🍄The next step is to simmer the grains on the stove. This will thoroughly hydrate the grains, and will soften them to make them easier for the mushroom mycelium to consume. Cook soaked grain on the stove for about 15 minutes. You don’t want to cook it too long, because eventually all the grain will crack and you’ll get some mushy grain spawn. We don't want that. 🧐After the grains have simmered on a low boil, you’ll need to drain them off. What I did is I drop them in the sink with the drain cover on. The grains will drain over an hour or so, after which you can go ahead and fill your jars. 🍄Once your jars are filled, they need to be sterilised.This kills off all the other nasty contaminants in the grain cover the lids in tinfoil (to prevent water dripping into the lid) and then just pressure sterilise them for about 90 minutes at 15 psi. 🍄After that let them cool down. Get your SAB, wipe down the walls with some alcohol wipes and place the jars inside. And wait untill they will be warm to the touch... not hot and painful 😤patience is key. Bring in your plates that had been stored by you in a dark place. And what u have to do is sterilise your scalpel and just accurately and efficiently decide your mycelium into about 10 pieces and quickly place them in your jar. And complete for every jar u make. You have to be very quick. The more you keep you're jar and your agar plates lids open the more cans they will get contaminated. There certain technics you can see online.. 🍄Ones you're done close all your jars lids tight and Jake your jar so the mycelium pieces will mix around the jar and place them in the dark place to colonize. And just keep waiting... 😅 Untill the mycelium will conquer your grain. Keep your eyes on the jars, any weird smells or colour during the waiting time.. because that would mean you got a contamination going on. Oh yeah and when about 55% of your jar is filled with mycilium shake the sh*t out of it so it will break the mycilium inside and make spread more faster.
Likes
28
Share
The wicked genetics plants are by far the most potent ones i grew and the most dank smelling like the gary payton x boston kreme pie (gary payton x wedding cake x thin mint cookies) is so dang potent this shit is an indica monster, I can't take more than 3 hits or I'm catatonic 🤣🤣🤣🤣 the gary payton x sour headband is still drying but I tried a little bit and that one is a sativa monster super nice heady high perfect for daytime smoke but both will rock your world if you take more than 2 or 3 hits I've never grown outdoor like this ever before I always grew local strains or clones but after harvesting these 2 plants I have decided that ill be growing nothing but wicked genetics for a long freakin time..the next line up im germinating are all special and will be my biggest challenge yet growing 8 different strains I have never grown and most of them being chem,sour or og kush crosses along with some more gary payton crosses (gp x king Louie og,gp x unicorn poop) highway og,evil og and kings og and triple threat and triple crown and lemon smoothie(lemon skunk x chemsicle) very excited I love growing fire strains I have never tried before these gp crosses impressed me beyond belief and I'm telling you guys go check out wicked genetics on his discord server or on IG or his website www.wickedgenetics.net, he gives tons of freebies if you buy from his discord and has regular and fem seeds if there's one person who's work needs to be admired it's Joshua's man hes doing some special work with og kush's,chemdawg,skunks,and sour strains it's insane how many fire strains I have from him and only really spent a couple hundered dollars where I was spending 0 with rqs and getting 10 northern lights autos seeds that I won't grow and the strains were never anything special not compared to wicked genetics the best bud I grew from royal queen seeds indoor isn't nearly as good tasting or as potent as the gary payton x boston kreem or gp x shb pie I grew outdoors I've never seen that
Likes
79
Share
Mexican Airlines is just awesome!!! Tons of bud sites all developing nicely. My only concern is my Alien vs Triangle hermied on me and I just hope I yanked her before she dropped any pollen on my Mexican Airlines. I think I caught it early enough and should be fine, but I guess there's a chance of some seeds. If so, I'm calling them Mexican Aliens! 😃
Likes
216
Share
@Ju_Bps
Follow
Hello growmies 👩‍🌾👨‍🌾🌲🌲, 👋 Hmm this one lost all his leaves, look ready to harvest, Buds didn't bump... I've started flush this end week Will harvest this one next week after one week without watering 💧 Give water each 2/3 days. 1,5l Water + Sugar Royal 1,5l Water + Flash Cleaner PH @6 💡Mars Hydro - SP 3000 80% 44 cm. 🔥 Thanks community for follow, likes, comments, always a pleasure 👩‍🌾👨‍🌾💚🌲. Mars Hydro - SP 3000 💡💡 https://www.mars-hydro.com/sp-3000-samsung-lm301b-greenhouse-led-grow-light Zamnesia - Gelato Auto🌲🌲 Discount code -20% with GROWITGD code 🔥🔥 https://www.zamnesia.com/7688-zamnesia-seeds-gelato-automatic.html
Likes
10
Share
started this week off by changing it to 12/12 lighting once i see her start to bud i will change bulbs... will keep updated
Likes
8
Share
@GrowerOG
Follow
Hello everybody, the pictures show a split situation: the buds looks good but the rest of the plant scream to overfeeding. Infact at the third day of the week i find an extra water in the saucer so i control the EC and i see 3.5 mS/cm. This value is clearly too high and i try to recover the plants by watering everyday with 1 L demineralized water adjust with pH-down. I just hope to see a better situation in a week. 🙏