Another week in the books. She's getting closer to the end.

Week 2

The girls have performed very well this week! The LST began, and there was some great growth in side branching. I also started this week off with introducing them to some nutrients ❤️ Start of week 4, the girls had responded well to transplanting, so I decided to start with some LST. My main method is to use soft wire wraps (dollar store purchase!) I poke one hole in the side of the pot near the top, and then go directly opposite that hole and poke through to make another. The first hole is for a wire wrap to secure the base of the seedling from pulling right out or over too far. The other hole is for the direction you want to bend your plant to. I start by slowly working the stem between my fingers at the point where I want it to bend. Twisting and pinching slowly so not to snap. *wait a day or two after your last water, or it will be easier to snap* once it’s ready to flop, I use the wire tie to hold down the top of the plant as close as I can to the nearest shoots. I’ll usually leave the plant like this for a couple of days, adjusting the ties, and then take them off to let them recover . Watered with a small dose of the full line I will be using for this grow. The girls got about 500 ml at the beginning of the week, but 2 days in I could tell they wanted more. By the end of the week they are taking nearly 1/2 gallon (which will give me 10% runoff) At the end of the week I increased the intensity of the BP2500 to 190 watts at the wall and the girls did show a few wrinkles as they adjusted, but have quickly recovered. I haven’t topped these girls, and I’m not sure if I am going to… thoughts? Happy Gardening 🇨🇦❤️🌱😎💨

03-01-2025 Começando um ciclo com as gostosas das fast buds 🤩 após alguns cultivos e várias sementes diferentes, escolhi estas 7 raças que irão habitar a minha tenda de 5x6, com 21 vasos de 12 litros, com o "nitro power" da bio bizz.

Green Cure CBD Auto is making good progress. Her roots are starting to poke out the bottom. She was trained some more today. She got a little hungry and started to get a little pale looking. Fixed that through obvious solution of feeding more. Everything is doing good. Thank you again Zamnesia seeds, and Medic Grow. 🤜🏻🤛🏻🌱🌱🌱 Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. ❄️🌱🍻 Happy Growing 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g

All good flowers are coming along nicely and getting thicker. 500ml water per day 12/12, fertilization happens on Monday, Wednesday and Friday with the mix above. All good so far I just keep removing the bottom leaves that are yellowish. Fruit Tree will be the quickest to be harvested all of them are nicely maturing needs some more time. Some more weeks and we will see.

Hey fellow green thumbs! 🌿💚 The day has finally come—our Auto Northern Dragon Fuel from Super Sativa Seed Club has been harvested! After an exciting journey, we’re thrilled to share the details of this incredible plant’s final stage. Let’s dive into the harvest report! 🌟 Harvest Details: Day 75: Harvest Day • Harvest Date: Day 75 • Harvest Method: Our beautiful Auto Northern Dragon Fuel was harvested yesterday. After weeks of careful nurturing, the time was right to bring in this amazing plant. 🌿🌼 • Preparation: Before hanging, we meticulously cleaned the plant, removing all leaves without trichomes to ensure a smooth drying process and to enhance the quality of the final product. 🌿✂️ Current Drying Process: • Method: The entire plant is now hanging upside down to dry. This method helps maintain moisture levels within the buds, allowing for a slower and more even drying process. 🌿🔄 • Environment: • Temperature: 18-22°C (65-72°F) • Humidity: 50-60% Maintaining these conditions is crucial for achieving a perfect dry and preserving the plant’s aromatic and flavorful profile. 🌡️💧 🌟 Plant and Bud Characteristics: Auto Northern Dragon Fuel: • Bud Structure: Dense and sticky, with an impressive trichome coverage. The buds are beautifully formed, showcasing the robust genetics of this strain. • Aroma: Even in the drying phase, the rich and potent aroma is unmistakable. Expect a delightful scent that hints at the powerful experience to come. • Trichomes: A thick layer of trichomes covers the buds, promising a potent final product with a great flavor profile. 🌿✨ 🌟 Care Tips: • Drying Process: Patience is key. Allowing the plant to dry slowly will enhance the final quality, preserving both flavor and potency. Ensure good airflow around the hanging plant to prevent mold and mildew. 🌬️💧 • Trimming: Once the drying process is complete (typically 10-14 days), it will be time to trim the buds. This is where we’ll shape the final product and get it ready for curing. ✂️🌿 • Curing: After trimming, curing the buds in jars for at least 2-4 weeks will further enhance the flavor and smoothness. This final step is essential for achieving the best possible smoking experience. 🍁 🌟 Genetics Spotlight: Auto Northern Dragon Fuel: • Characteristics: Known for its robust structure and dense buds, this strain has shown remarkable resilience and impressive bud development throughout the grow. The final product promises to be potent and flavorful, thanks to the thick trichome coverage and rich aroma. • Harvest Expectations: High-quality buds with a strong aroma and potent effects. The slow drying process will ensure the best possible preservation of cannabinoids and terpenes. 🌍🌿 Fun Fact: Did you know? 🌿✨ Drying the entire plant slowly helps retain more terpenes, which are responsible for the plant’s aroma and flavor. This method also helps preserve the potency and quality of the buds, resulting in a smoother and more enjoyable experience. For all the in-depth action and detailed explanations, head over to my YouTube channel! 🎥✨ I’m sharing all the tips, tricks, and step-by-step guides to help you get the best results from your grow. This week’s harvest has been particularly exciting, and there’s so much more to explore and learn together! 👉 Join me on YouTube Link in my profile 👈 🌟 Conclusion: Harvesting Auto Northern Dragon Fuel at Day 75 has been a rewarding experience. With the plant now drying, we’re eagerly awaiting the final product. Stay tuned for updates on the drying, trimming, and curing process, and get ready for a high-quality harvest! Happy growing, and see you next time! 🌿💚✨ #SuperSativaSeedClub #HarvestReport #NorthernDragonFuel #PlantMagic #GardeningJoy #NatureLovers #PlantPower #InspireGrow #YouTubeJourney

Week 3 starting off strong No nuts just yet still letting the Nector of the gods and FF soil just be my main base for nuts. Also I add some cal mag and PH balance the water. I will probably start adding some noots toward the end of the week when I start seeing some more growth. For right now I'm thinking I might let them veg for about 6 weeks depending on the growth in the upcoming two weeks. Hope you all are having a safe and fund grown. Make sure you hit the follow button

Très peu de photos de cette semaine :/

31/07/2025 - Rega A com Ph a 6.7 02/08/2025 - Rega com água mineral livre de cloro com Ph a 6.2

Officially two weeks since I planted the seed. These things have really grown since the flush and nutrients. Will be flushing and fresh water and nutes on Tuesdays. I will also add daily progress pics and updates. 7/1 (Day 14) - Everything is continuing to go pretty well. I feel pretty good and dialed in on my temps, humidity, and VPD. I've just been kinda monitoring everything and its going well. They seem to be doing ok. I definitely made the mistake of planting them two low in the net pots I think. Im not sure if that is going to hurt anything or not, they seem to be doing ok though. Ill try and get some pics of the roots, I felt under one of them to see if they had roots and there was one under that that was pretty damn gnarly and long already though. Will update later with pics if i can. 7/2 (Day 15)- Continuing to see good growth I think. Things continue to run well and everything is in check and staying the same. PH went up to 6.1 and I added a very small amount of PH down and waited about an hour an now we are back at 5.8. 7/3 (Day 16)- Everything continues as normal, got the new humidifier in and hooked up and its made life much easier. Plants continue to grow and seem to be happy. Tomorrow is flush day and new nutes! Ill try and get a video or something if I can remember. 7/4 (Day 17)- Flushed and refreshed everything. Its a long process due to waiting on the RO water. Everything is looking pretty good though. Just going to continue to monitor. Temp and humidity are still 78-79ish and around 65% RH during day and around 72-73 and 58-60%RH at night. PPM after this flush is around 650ppm or EC 0.9 7/5 (Day-18)- Every seems to continue to go pretty well. Temps, humidity, ph, and ec all stable, plants continue to grow! 7/6 (Day 19)- Pretty much same as yesterday, everything is staying steady and running pretty good, they are getting big but not really growing tall, wondering if it will shoot up soon or if i messed up by planting too deep in net pots. 7/7 (Day 20)- Had an issue this morning, woke up to some leaves curling down at the ends. Checked everything, temp 79, humidity 65%, water temp 68, EC is .9 so same as when I mixed, roots look great, 1 inch gap from net pot, airstins and everything is great. Came to conclusion my light was too close. I haven’t raised it and plants have grown a few inches. I think it was too close and burning. Moved the light to about 33 inches from top of plant now. Seem to be recovering slowly. Will monitor. Any tips and recommendations always appreciated. Thanks.

What a fun experience! This was my first time trying a mixed grow style of synthetics and organic. I think I may have found my new go-to strategy. This definitely wasn't a perfect run by any means - as a matter of fact, I botched the feedings earlier in her life. However this grow definitely taught me a lot more about how to treat this strain properly. Now I'm running her clones in the 3x3x6. So the legacy will continue! Let's see how this strain does during the summer months! Cheers everyone! This has been an awesome grow. What I'm lacking in yield, I yet again make up for in quality. And I don't think yield will be an issue with the clones, they're week 6 veg - and quite massive! - RWI out!! 😁 😶‍🌫️🤑

Growing well so far. This week I added some LST to encourage outward growth. Things started to get a little wonky towards the end of the week bit once she starts to stretch out i think she will look a little neater.

Day 78 ☀️☀️🔥☀️ 16-28 degrees, humidity 45-65%. Tropicana and I start into the 12th week with intense autumn colors and an explosion of fragrances. It‘s very hot during the last days but bu the night temperatures fell more than 11 degrees last night. When I check my plants in the early morning, give them water and attention, a cloud of Tropicanas fruity and floral fragrances surrounding me. Night 79 ⚡️🌈 This will be Tropicanas last night. I found a little bud rott in the main flower. Glad that I made a video inside. I just saw a yellow leaf as a sign and remembered what I read last week about this problem connected with high humidity and very dense buds. I didn‘t follow any hygiene rules and humidity on the balcony was very high for too long period. So this could happen unfortunately.

Almost there. Will start flushing tommorow. Smells mental now and plenty of frost. Buds are rock hard even the lower ones. Interesting to see what they yield. The tops are all quite small but so dense. Can’t wait to try it now.

they both got into flowering in the middle of the week, switched to flower lights, no nutrients just pure water, they look happy flappy, cant wait to taste it. Definetly see the benefits with LST now, gonna be some nice tops on that one

I grow in pure coco with organic nutrients

The 3th week of 12/12 is history and flowering has entered the grow room. 😋 I marked day 53 (day 17 of 12/12) as the first day of actual flowering. Everyday I've checked if there were fungus gnats trapped on the yellow sticky traps and I've spotted a few. So not a total infestation. I've also checked for signs of hermies and I haven't seen any. I've had one a few years ago and it pretty much ruined the whole grow. Seeds everywhere. But that was another breeder and strain. Under the screen I did some final pruning and above a minor defoilation. The Runtz are stretching nicely and the screen is filled pretty much like I wanted it to. Gonna leave them alone now, done with bending those shoots under the screen. This weeks temperatures stayed between 20,6°C (69°F) and 24,2 °C (75,5°F) and humidity levels between 44 – 56 % Light pressure was raised from 244 watt at 70cm (27 inch) to 260 watt at 63cm (25 inch). Their diet consisted of ph adjusted tapwater (ph 6,38 – ec 0,49) most of the week. They were barely fed for 1 day. Gonna keep it that way as long as I don't see any signals of shortages or surpluses. Naturally, ec leves will rise next week but one day of feeding seems enough for now. Smell is coming in slightly, but the CAN-lite carbon filter is doing it's job. There's a 600m³ one hanging in the grow room connected to a 550m³ Airfan foam softbox that's dimmed at 40% since the start of this grow. That was the most important info for this week. Up to next week's flowers!✋ Do you want to grow this strain? 👉 https://www.zamnesia.com/6000-zamnesia-seeds-runtz-feminized.html 👈