Plant was transplanted in to 5.5 L pot.

Vegetation: To keep temperature and moisture on optimal levels at around 23°C / 65% I'm using two mechanical timers. - 24/7 on: Fans and water pumps (+Ventilation after 3.11.) - Timer 1: Lights and Humidifier 18h on / 6h off - Timer 2 (BROKEN 3.11.): Ventilation 18h (15min on / 15min off) / 6h off NOTES: Everything looks good and the roots have appeared from almost every (11/13) rock-wool cube. From now on I'll mostly water the plants from bottom by adding the wanted amount of nutrient solution on a plate, and then placing the plant on top of for ~15seconds This week I'm also starting to prepare the hydroponic systems (2x NFT-GT90, and 1x EBB-flow I think) and stronger nutrient solution since my plants are becoming ready to be transferred. Spreader-mat is the base of my plants when I have transferred them in to the hydroponic systems. DO NOT place more than one layer of the spreader-mat as it is not meant to be used like that! As you're cutting the mat for NFT's, be aware to have some extra for your peace to reach nutrient solution below the tray. That way you won't get noise from water dropping when systems are turned on. Day 15 (1.11.) Day 16 (2.11.) First watering with a bit stronger nutrient-solution (~ EC 0,6 / pH 5,9) than before, starting with 50ml/plant and watering once from above. Slowly increasing EC to 0,8. I cleaned and assembled 2 out of 3 hydroponic-systems which I'm going to use. I'll do the same also to the last system, but it currently has my plants on top of it so I'm going to do it later. I want to make sure that my plants have built healthy and big enough root system before transplanting to hydroponics. I'm waiting for the rock-wool cubes to be bursting of roots so they won't drown on their first day in hydro. Also, as the plants are bigger before the transplant, I'm able to fill my nutrient-solution tanks full with correct strength nutrient-solution for Mid-Vegetation from the start, therefore no need for that much adjusting later on. Day 17 (3.11.) I noticed my other timer which controls the lights had stopped working... The lights were on when they shouldn't have been, I noticed it an hour after they were supposed to turn off. I think I caught up to it early, but it may have been on for maximum of 2 days straight. No worries there since on vegetation-phase the plants don't necessarily need any sleep (Even though you should avoid quick changes like that!). Roots have appeared from the bottom of every cube and plants are looking pretty healthy. I think they are almost ready for hydroponics. Day 18 (4.11.) Few plants are showing symptoms of nutrient deficiences or some sort of sickness, not certain what exactly. I'll be keeping an eye on it. I'll be transferring in to hydroponic systems in maybe a week, so I don't want to stress my plants more than what's necessary. Increased my solution strength to 0,9 EC with a bit more Cal-Mag than before, and watered the plants for 50-150ml each plant depending on weight and size. I'll be slowly increasing the strength by around 50% during upcoming week. Thanks for tips! Day 19 (5.11.) Day 20 (6.11.) Plants are recovering well from deficiences and I just transferred all of them to hydroponics. I don't have the water pumps on for 24/7 just yet, at this point I water them a couple times a day by keeping the pumps on for somewhere around 15min at a time. Lights are now set to 60% and I also added a tower fan to circulate the air and shake the plants. Day 21 (7.11.) Lights are now set to 70% since the Led's and plants are spreaded wider in the tent than before. Distance to plants stays the same at 75cm.

Week 2 of Flower (Day 56 since sprouted) Just maintaining temps and adjusting light distance. Fed with 1/2 gallon of feed water PH 6.5 -TPS CalMag 1 mil -General Hydroponics Trio -TPS Signal 5 mil per 1 gallon Light defoliating

Week 2 of Flower (Day 56 since sprouted) Just maintaining temps and adjusting light distance. Fed with 1/2 gallon of feed water PH 6.5 -TPS CalMag 1 mil -General Hydroponics Trio -TPS Signal 5 mil per 1 gallon Light defoliating

Taste like Sweets and Blueberry. 10/10 - Did cut early as well.

She strong little thing this the 2nd seed I planted of this strain the 1st one didn't pop for me idk why. Only spray and bottle watering her for right now she is in a 5 gallon pot don’t want to over water the pot and cause nat or mold issues. Today is the 1st day of the 2nd week. Dome came off the past few days also.

She strong little thing this the 2nd seed I planted of this strain the 1st one didn't pop for me idk why. Only spray and bottle watering her for right now she is in a 5 gallon pot don’t want to over water the pot and cause nat or mold issues. Today is the 1st day of the 2nd week. Dome came off the past few days also.

Plant was transplanted in to 5.5 L pot

Plant was transplanted in to 5.5 L pot

Hello growmies 👩‍🌾👨‍🌾🌲🌲, 👋 Plant keep growind a bit, and buds keep coming along and frosty 💡 💡I've removed 2 hours this week, in 2 times, 1 hour start week, 1 more hour removed mid week, because I'll have soon some photoperiod in the tent, ⏰️ 20/24 On 💪 Not too much work, just removed some leaves. 💧 Give water each 2/3 day 1.5 l Water + Roots + Bloom 1.5 l Water + Roots + Bloom + Sugar Royal 1.5 l Water + Roots + Bloom PH @6 RQS - Easy Bloom Booster Tabs 1 tabs/5 l RQS - Easy Grow Booster Tabs 1 tabs/5 l RQS - Easy Micronutrients Plus 1 tabs/5 l (1 watering each 10 days.) 💡Mars Hydro - FC 3000 50% 46 cm. Mars Hydro Fan kit Setting 6 Have a good week and see you next week 👋 Thanks community for follow, likes, comments, always a pleasure 👩‍🌾👨‍🌾❤️🌲 Mars Hydro - Smart FC3000 300W Samsung LM301B LED Grow Light💡💡 https://www.mars-hydro.com/fc-3000-samsung-lm301b-led-grow-light Mars Hydro - 6 Inch Inline Fan And Carbon Filter Combo With Thermostat Controller 💨💨 https://www.mars-hydro.com/6-inch-inline-duct-fan-and-carbon-filter-combo-with-thermostat-controller RQS - Titan F1🌲🌲 https://www.royalqueenseeds.com/f1-hybrid-cannabis-seeds/624-titan-f1.html

Plant was transplanted in to 5.5 L pot

Plant was transplanted in to 5.5 L pot

Plant was transplanted in to 5.5 L pot

Plant was transplanted in to 5.5 L pot

Plant was transplamted in to 5.5L pot.

All 3 plants are looking healthy and occasionally even look happy when I'm not stretching their limbs out all over the place 😒 Not alot of progress on their height but they look like they're doing alright so I'm not gonna worry too much yet, I could really do with these being nice and short so I don't have to mess about raising the shelf up 🙄 That's all for the moment, just watering and moving the branches out, it's nearly flowering time 🎄 Happy growing everyone, take it easy 😎🌿 30th October All 3 plants are doing well and responding nicely to the lst, every day I move a bud site away more and new ones just keep popping up all over the place 🌿 not alot of vertical growth which is fine by me just don't know if that'll negatively impact my yield 😕 but they're more than likely getting ready to shoot up 🌱

Second week of flowering starts! ☀️01.11.2023 Nearly all is going like it should. 'Nearly', because of lidht signs of magnesium deficiency on the few leafes of one 'Special Queen' plant. I'll try to give them a drop of 'CalMag' before it'll be too late. Therefore, I have a great garden, - it's lovely looking and the budz are forming well. The trichomes developong have started. I'm spraying it with 'Bio Bloom' solution every day. ☀️03.11.2023 Watered two of them today. 'Bio Bloom' spraiyng also. ☀️05.11.2023 'Bio Bloom' spraying only. ☀️07.11.2023 Watering with 50% consentration 'TA Tripart' + 100% 'Bio Bizz CalMag'. Spraying with 'TA Pro Bloom' solution. Week ends.

This was the last week of veg. I switched from organic nutrients to synthetic. For the pipes of the autopot. I will therefore also flush them for 2 weeks. In the first week of flowering there will be a dehumidifier in the tent to get around 50% humidity