Jetzt fängt die Blüten Bildung an also halte ich den Lampenabstand bei 40-50cm und 100% (bei mir 260watt) jetzt einfach alle 3 Tage gießen und ich dünge alle 7Tage noch also einfach einmal die Woche und Joa ab jetzt mache ich nichts mehr außer entlauben für mehr Licht daher die Pflanze klein gewachsen ist

Reifung schreitet voran. Trichome schau ich mir erst Ende der nächsten Woche an.

Its taste is so amazing this round

Getting a little crispy on the tops within 1 inch of the light. But all and all plant is healthy happy and starting to smell wonderful. Looking like a full 9 weeks of flower needed.

Progress from last week some of the pictures/videos are 2 days apart you should see the difference in them all in all a busy week so short and sweet happy flowering

6/13/2023 Week 10- Day 1 of Flower (Day 131 overall) (Day 70 of Flower) Auto Pilot Day 6.. Checked the Trichomes and the bud density and both are looking good.. Definitely needs a little more time for the Trichomes to be where I like, so based on my check I think we are still looking right around the end of the competition 22June to be done and ready for harvest. I do like that the fade is coming in the leaves nicely, so my chart I think is dropping off the Nitrogen exactly like it is supposed to. 6/14/2023 Week 10- Day 2 of Flower (Day 132 overall) Auto Pilot Day 7.. Decided I would take some contrasting pics today with my light up to 100 and my light all the way on Dim. I hope you enjoy the pics. 6/15/2023 Week 10- Day 3 of Flower (Day 133 overall) Auto Pilot Day 8.. Decided to take a look at the Trichome's today and Check to see where they are at and honestly if I might ho ahead and start my flush tomorrow and harvest on Sunday. 6/16/2023 Week 10- Day 4 of Flower (Day 134 overall) (Day 74 of Flower) Today I pulled an Armageddon however instead of darkness they are going to get 48 hours of light. The reason why they are going to get light instead of dark is when I was taking out the netting a lot of the buds were so heavy they fell over and exposed some areas I really want to get some light to... so 48 hours of light at 40% while I watch what should be a beautiful final fade as the plant eats up the last Nutes. If anything goes wrong I can abort take the photos and cut so will pay really close attention to how it is looking over the next 48 hours. Added 30 Gallons of PH only Water. Reduced Lighting to 40% removed program time off. 48 hours of light. 6/17/2023 Week 10- Day 5 of Flower (Day 135 overall) (Day 75 of Flower) I had someone tell me that a few growers had done as I did and Gone Armageddon on the plants. Filling it with PH only and said the plants did not respond well and they were taken out of the comp at the very end because they felt like the pictures just wouldn't come out right. Even though I did go Armageddon, The PPM is at 353PPM with the residue of what was left in the buckets after draining as well as what I am getting from the TAP so I think they are doing good but I am checking them every few hours to see how they seem to be doing and I think they are doing good still and are on track. I also started prepping the area for the pics tomorrow T-24 Hours until Chop 6/18/2023 Week 10- Day 6 of Flower (Day 136 overall) (Day 76 of Flower) (Harvest Day) What a day.. what a day.. what a day.. as I was setting up and trying to figure out how I was going to get my pics #3 stems started breaking, it fell over and other stems broke.. So no really stunning competition photo for her, she had such a nice purple fade.. #2 stayed up in the Tent so that is the one I had to go with to submit for the contest. I wet trimmed them as they went into the tent and they took up three rows hanging in tent. I also decided I wanted to try some so I put a little in the freeze dryer for a 48 hour smoke test.. I will weigh it and add that to my total weight for the plants when it is all done.

Si vous avez la moindre question n'hésitez pas à me contacter. La préparation des boutures est assez simple, il existe plein de guide pour les réaliser, contactez moi si vous rencontrez un problème. Ce qui est important c'est de partir d'une plante saine, ne présentant pas de carences. Si les branches ou feuilles de vos plantes ont un aspect/toucher étrange, il faut vous assurer de régler le problème avant de prélever vos boutures pour vous assurer de la réussite finale. En cas de carence sur vos pieds mères vous pouvez utiliser Revive et B-52 en foliaire et en irrigation pour régler le problème! J'ai donc fais une pulvérisation foliaire le jour précédent les boutures pour m'assurer de leur santé et également une pulvérisation de B-52 sur la plante mère après l'opération de taille! Une fois les bouture réalisé j'ai pulvérisé avec un mélange Voodoo/Tarantula/Piranha pour m'assurer qu'aucune bactérie ou champignon ne puisse venir infecter mes clones. J'ai utilisé des Rockwool Cube et je déconseille. Je trouve que l'enracinement est beaucoup plus difficile qu'avec Root it ou Root Riot de Growth Technology! Le processus dure environ 10 à 15 jours pour l'enracinement et il faut compter encore 5 à 7 jours pour l'enracinement dans le pot 1L. A ce stade les plantes sont enfin enraciner et prêtes à commencer leur croissance!

Venga familia que ya viene la cosecha de estas Tropical Zmoothie de Seedstockers, que ganas que tenia ya de darles machetazo. No veas que pinta que tienen estas plantas. Las flores aparte se ven bien resinosas. a sido una genética con la que disfruté mucho cultivarla, es algo complicada cultivarla pero merece la pena si eres cultivador con experiencia no te será problema cosechar. Agrobeta: https://www.agrobeta.com/agrobetatiendaonline/36-abonos-canamo Mars hydro: Code discount: EL420 https://www.mars-hydro.com/ Hasta aquí es todo , espero que lo disfrutéis, buenos humos 💨💨.

Crushed it this run!🤯🙏

Hi everybody welcome to the gorilla cookies diary she is fat in out very nicely and looking beautiful pH 6.5 with biobiz nutrients . I put the light to 100% after the last week's diary . Thank you for looking at the diary and tune in for next week always remember it's 420 somewhere 🌱👍

A really explosive week of growth. I pushed PPFD up to 310umols. Dimmers are at 60% which is drawing 224w plus 18w of DRRB. I have alos started Emerson effect ... Another The Emerson effect is triggered by the simultaneous exposure of plants to light in the deep red and far-red spectra Deep Red 660 nm /Far-Red 700 nm . A bit of boring science that explains why you need both far red and deep red in order to trigger Emerson. The effect occurs because photosynthesis is driven by two distinct pigment systems working in series:Photosystem II (PSII): Absorbs energy most efficiently at shorter wavelengths (higher frequencies), like 680 nm (441 THz). Photosystem I (PSI): Absorbs energy most efficiently at longer wavelengths (lower frequencies), specifically 700 nm (428 THz). When you provide only the higher frequency (deep red), PSI becomes a bottleneck. When you provide only the lower frequency (far-red), PSII is not sufficiently excited to provide electrons. Providing both frequencies simultaneously allows both systems to work at peak efficiency, resulting in a rate of photosynthesis that is greater than the sum of the two lights used individually. To understand the Emerson Effect, think of photosynthesis not as a single engine, but as a two-stage assembly line. What is the Emerson Effect? Discovered by Robert Emerson in 1957, this phenomenon shows that plants perform photosynthesis much more efficiently when they are hit by two specific types of light at the same time: Deep Red (660 nm) and Far-Red (700+ nm). If you give a plant only Far-Red light, photosynthesis is very slow. If you give it only Deep Red, it's better but still limited. However, when you give it both at once, the total rate of photosynthesis is significantly higher than if you just added the two results together (1+1=3). What is Happening? (The "Assembly Line") Inside the plant's chloroplasts, there are two "workstations" called Photosystem II (PSII) and Photosystem I (PSI). They work in series, meaning the first one must pass "parts" to the second one. PSII (The First Station): This station is tuned to catch Deep Red light (660 nm). It harvests electrons from water. PSI (The Second Station): This station is tuned to catch Far-Red light (700 nm). It takes the electrons from the first station and uses them to create energy (ATP and NADPH). The Problem: If you only provide Deep Red light, the first station works fast, but the second station can't keep up because it isn't being "powered" efficiently by that specific frequency. This creates a traffic jam of electrons. The Solution: By adding Far-Red light, you power up the second station. It now "pulls" the electrons from the first station much faster, clearing the traffic jam and making the whole assembly line run at full speed. The Benefits for The Grow.. Because i am using the Biotabs water-only method, my plants already have a steady supply of organic nutrients. Implementing the Emerson Effect offers several distinct advantages: Increased Biomass: Because the "engine" is running faster, the plant produces more sugars and carbohydrates, leading to heavier fruits or flowers. Faster Finishing: Plants often reach maturity sooner because they have more surplus energy to complete their life cycle. Better Light Penetration: Far-Red light is very good at passing through the upper leaves. This "wakes up" the lower parts of the plant that would otherwise be shaded, allowing the whole plant to contribute to growth. Enhanced Secondary Metabolites: In many crops, this synergistic light can stimulate the production of terpenes and antioxidants, improving the "quality" (smell, taste, and potency) of the final harvest. The "Sunrise/Sunset" Trick I am using 4x Invisible sun Far red/Deep red bars,they use high-quality Samsung LH351H (660nm Deep Red) and specific Far-Red (730nm) diodes for 10–15 minutes at the start or end of the light cycle. This mimics the natural shift in light at sunrise and sunset, "waking up" the photosystems or signaling the plant to go into "sleep mode" faster, which can further optimize the flowering cycle. Enviromentally i am chasing a VPD of about 1,1kpa. My room seem to sit nicely at lights on at 24c with no real drama and a little help from a 220W greenhouse bar radiator. Its using abot 4kw/h a day atm because my room is attached to the side of my house and its been -5c.. I have had to add some humidity as its also very dry atm. Im aiming for RH of 65% with my 24c but it is more around the 62s.. VPD is crucial and is the focus for this grow for me. The autopots and Biotabs make it so easy ican really just focus on perfect enviroment. A VPD of 1.0–1.2 kPa provides enough "atmospheric pull" to move calcium and magnesium up from the roots, which is critical for the rapid cell division happening now.. Plants will be flipped on Saturday which is their week 5 as im a bit behind.. As this happens i will push PPFD upto 4-500umols. by week 2 of flower. Thats the plan anyway..

hard defoliation on day 52 to let air and light get inside and give room for the buds to grow .

Welcome back to another week, finally decided to flip to flower as these girls do grow pretty quickly in DWC. Aiming for some nice quality buds bit also a decent yield of at least 1 gram per watt of light. Nutrient solution has not been changing to complete flower schedule yet but I will be sure to switch it over in a few days. The crucial part now is keeping the EC and pH in a good range to avoid any deficiencies or Nutrient lock out. Let's see what the stretch brings the first few weeks. Stay tuned, and I'll be back for the by the end of the week to report some video feedback. End of the week has ending with a heavy defoliation session. Plants were getting bushy and covering potential tops so that needed to be addressed. For now, it will be selective defoliation once they have recovered, which should be in 2/3 days. Let's watch them bounce back. Stay tuned for week 2. Check out my YouTube and Instagram channel for a closer look. (Link on profile)

These ladies are solid and filled with tons of orange hairs. The smell is like no other of citrus and fresh cut wood. One week then I am going to flush her.

V15, riego con pH 6.1 y EC 1.2, las plantas ya se han recuperado del stress de hace unos días atrás, desde el próximo riego el agua tendrá sus nutrientes completos. Se ajustó el LST en algunas plantas. V17, definitivamente ya se recuperaron del stress por sobre fertilización, están creciendo al ritmo esperado, con bien color y hojas "felices". V18, y bueno, de nuevo surge un imprevisto, intentando hacer LST a un tallo acabo de romperlo, le hice una especie de entablillado esperando que se recupere. Hoy toco riego con pH 6.2 y EC 1.5, las plantas crecen bien.

Green Cure CBD is growing great for a solo cup. She appears to be starting to bulk. She has a nice layer of frosty forming on her full of cbd goodness. Everything is looking great. She is very hungry, and thirsty with the limited root space. I removed some lower bits, but not much. Nothing else to report at the moment. Thank you Medic Grow, and Zamnesia seeds. 🤜🏻🤛🏻🌱🌱🌱 Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. ❄️🌱🍻 Happy Growing 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g

Very nice plant i love this strain already