The Grow Awards 2026 🏆
Likes
Comments
Share
@Roberts
Follow
Casey's Rollex OG has been growing good. This week though she fox tailed on just the tips if a few colas. She isn't close to the light, nor are the temperatures getting too high. I think this was genetic. I have no issue with it. Just she was forming some really nice thick colas. Then a fox tail tip. Shit happens. She is loaded with frost and the smell is a fruity earthy aroma. Hard to pin point exactly. She will likely be harvested in 2 weeks. Starting ph water in less than week for the fading flush. Next update is actually gonna be the harvest. Thank you DutchFem Seeds, and Spider Farmer. 🤜🏻🤛🏻🌱❄️🌱 Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. Thank you Happy Growing 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g
Likes
20
Share
@MMSC16
Follow
Day 84 - June 25 June 25 - 09.30AM Trichomes still not ready at 50/50 milky to cloudy. Soil is still moist. Will water either late this evening or tomorrow morning. I suspect this will be the second or last watering before chop. June 25 - 09.00PM Removed a dead leaf - I want to remove some of the dying leaves on the colas, as underside of plant has a beautiful purple hue to the leaves. June 26 - 08.45AM Trichomes are starting to turn milky, with 60/40 milky to cloudy ratio. Will water this evening as pot is getting lighter + soil isn't as moist. June 26 - 01.20PM Purple is here. I think it's time to chop tomorrow as I'm seeing more ambers. I'm noticing some bright green growth which I hope isn't the start of nanners. June 26 - 01.20PM Watered 3L. Chop tomorrow. June 27 - 00.00AM CHOPPED (Day 86). . June 27 - 00.00AM Inspected detached calyx with strange (I suspect pistil) growth. Many amber trichomes found. Strange, given colas I inspected were all cloudy with no amber, but this calyx (located at centre of plant) had plenty of amber trichomes. Perhaps this is due to recieving a higher than expected DLI at hotspot of light. . June 27 - 00.00AM Underside of Buds are underdeveloped in comparison - easily due to light blockage. I aimed not to defoliate as she entered flower, but perhaps with better LST and leaf tucking I could've produced more even yield. . June 27 - 00.00AM Trimmed Fan leaves and mostly necrotic foliage - want to avoid bud-rot at all costs, but I may have over-defoliated. . June 27 - 00.00AM Drying hanging upside down with oscilating fan above (2/10) and one beneath driving air toward a wall of the tent. There's also an extraction fan at the top of the tent. . June 27 - 00.00AM Humidity 60-62% & Temperature 64-66F. . June 27 - 02.45PM Temperature is rising in the tent to 69F, inside a sealed bathroom room. Sealed Bathroom offers no light leakage, but I might need to open the door and allow light + cool air in. . June 27 - 03.45PM Moved tent out of bathroom to get cooler air. Tent temperature was just under 70F. I've likely lost some flavour over a few hours - but now that it's in a cooler environment (with slight light leakage) - things should improve. . June 27 - 03.45PM Temperature & Humidity are 66F and 60% respectively. . June 27 - 04.00PM (16 hours since chop) . June 27 - 04.05PM Added portable cooling unit to intake, this should drop temperature by a degree or two hopefully. Ensured Fans weren't directly in path of buds. . June 27 - 04.30PM Humidity is 66%, I've increased oscilating fan speed to 5/10 to combat this. . June 27 - 08.50PM Humidity is 60%. Temperature is 66F . July 1 - 09.00PM Branches still bend - not snap. Will trim and start cure process tomorrow. Leaves shrivelled up. . July 2 - 10.00AM Rough Trim, and placed into cure jars. 58% RH and 60% RH Probably should have harvested last night. Will maintain RH in jars via burping. Roughly 2oz (56g) of bud harvested.
Likes
8
Share
@WeeDay420
Follow
All its okkk Thankn you stay like for me like4like check my insta also weeday420 :p see you next week good luck 🤙💨🤤💚‼️🤟🥇🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥🔥
Likes
13
Share
@XanHalen
Follow
Apr 20: They hanging out at 65% rh and 65F.. Going for 7-10 day dry… No wet trim, cut plants in half and hung… Very happy with density and resin production… Can’t wait to jar and test in 2-3 weeks… I feel comfortable with this strain, I think it’s time to move on… Really wanna run some Mephisto seeds….
Likes
361
Share
@Ju_Bps
Follow
Hello my friendly growmies 👩‍🌾👨‍🌾🌲🌲, We start to be really close to the harvest 🌲✂️, trichromes not yet ready but soon, I like a few percentage of amber, they are almost totally milky, so probably ready in end next week 🙂🙂 Smeel fruity/diesel 💦 1 watering this week 2.75l/plant Water + flash clean Lamp @100% and start to be really close to the plant, but not burning sign for the moment. Thanks community for follow, likes, comments, always a pleasure 👩‍🌾👨‍🌾❤️🌲 Have a nice end years 2022 💜👨‍🌾👩‍🌾🎅 See you new year 🍻🥂🥃🥃💨💨 Mars Hydro - TS1000 💡💡 https://www.mars-hydro.com/ts-1000-led-grow-light Mars Hydro - FC3000 💡💡 https://www.mars-hydro.com/fc-3000-samsung-lm301b-led-grow-light RQS - Fat Banana Auto 🍌🍌🌲🌲 https://www.royalqueenseeds.com/autoflowering-cannabis-seeds/487-fat-banana-automatic.html
Likes
2
Share
@Ninjabuds
Follow
My Strawberry Gorilla seedling is coming along nicely. It's got these really unique, long, skinny leaves that are quite different from my other plants. I'm thinking it might have a similar leaf structure to my Pound Cake, which is pretty cool. It'll be interesting to see how it develops! Okay, This past week has been absolutely fantastic! The weather has been incredible, and I've been able to keep the windows open almost the entire time. My plants are thriving in the humidity, and the VPD has been perfect. Everything just feels so balanced and in check.
Likes
10
Share
01/11 - Week 6 flower - continued micro-dose feeds - added supps (Light brown Sugar) dropped light intensity to 45% with temps at 71 (F) humidity (62%)
Processing
Likes
14
Share
This little orange sherbet was topped on day 10 and is growing well. I ran out of calimagic due to a shipping issue. I was hoping that tap water would give them enough cal mag but the plants started showing rusty spots symptoms of calcium deficiency. The only cal mag that I could find locally is Gringo Rasta from fox farm. I gave her a dose of it but it is too early to tell if it is going to work. I am skeptical about any organics in my system from past experiences but the pH is holding steady after a couple days so hopefully it will work out. Other than that they are still getting 24 hour light and I am starting to think that I might have to figure out a way to spread the plants further apart. A couple of them are getting pretty big.
Processing
Likes
18
Share
The way she grows is very nice I like it the leaves are broad and the smell from her already is just so dam good skunky. The plant being transplanted helped and now she has just took off. I'm starting to do LST and bending her over very hard it's going good so far. The plant can take a lot and I'm loving the genetics can't wait to see how she goes next week ...cheer canna fam
Likes
6
Share
5.27.25. What’s up growers! So plant is growing but was stressed out way to much so plant is definitely well under performing. 4th week of flower started on 5.26.25. I got about 5-6 weeks left of flower so hopefully she turns out ok. Thanks for checking out grow!
Likes
105
Share
_____📅 Week 8 | 📅 Day 50 - 56 | 17.06 - 23.06 ____________________________________ 🌼🌸🌺Pre-flower🌼🌸🌺 23.06.25 | Day 56🌞💧 🔸This week I wanted to stress my sweetys as little as possible, so only a few photos from the tent. They are standing perfectly straight and I didn't want to break or snap anything off. They are doing great. 🔸I tried out my additional light this week and connected it to my controller. As soon as the flowering starts I will switch it on. I'll have to see how much distance I use this time, the lamps were too close to the plants during the last grow “Runtz” and that didn't look nice. 🔸Next week I will start giving her Big Bud as soon as the first buds appear. 🔸Poison Envy: Would say the stretch is not over yet, very slight hairs on the nodes can be seen...it's definitely all ladies :D She is now over 35 Cm so in a week she will be 10 CM stretch, let's see when she is ready. _________________________________________________________________________________________ current conditions: 🌡️🔆= 24° 🌡️🌜= 18-19° 💨 Hum. = 65% 🔦 PPFD = 600 umol 12/12 🔦⌚DLI = ~ 25 _________________________________________________________________________________________ equipment to use: 💡 Light: 2 x Sanlight Evo 4- 120 on 60% ⛺ 120 x120 x 180 🍯 Pots: 18 liter pot 🌱 Soil: Bio-Bizz light mix 💊 Nutrients: Advanced Nutrients 💧 Water: Tap Water 0,5 EC _________________________________________________________________________________________
Likes
2
Share
This week the Epsilon F1 is showing what true modern F1 genetics can do vigorous growth, perfect uniformity, and resin production on another level. The structure has filled out beautifully: strong central cola supported by multiple side branches, each one stacked with dense, symmetrical buds. The plant has remained compact yet incredibly efficient under my 220W LED, proving that these F1s know how to use light and nutrients perfectly. Trichome development has gone wild this week the buds are now completely covered in frost, from the main tops down to the lower nodes. Most trichomes are still clear to milky, which means we’re right in the middle of the ideal bulking phase. The pistils have started to darken and curl inward, while the calyxes are swelling fast, gaining weight each day. The Overdrive and CO₂ bag combo seem to have given an extra boost in density and terpene formation. Aroma-wise, the tent is filled with a complex mix of citrus, pine, and herbal notes, slightly spicy but still fresh. It’s a very refined and balanced scent not overpowering, but clearly high in terpene content. Every time I check the buds, the stickiness is unreal the resin literally glues your fingers together. This week I kept the feeding stable, using the full Advanced Nutrients line with Big Bud as the main bloom booster, and next week I’ll gradually transition toward Overdrive as we approach the ripening stage. The leaves remain healthy and green with slight fading at the bottom exactly what I want to see at this point. Overall, the Epsilon F1 is performing like a true next generation autoflower: fast, strong, consistent, and extremely frosty. If the swelling continues at this pace, it’s shaping up to be one of the heaviest yielders of this run, combining efficiency with top tier resin quality.
Likes
121
Share
@ctm_dzagi
Follow
Dried with working ventilation until the moment when the weight stopped falling harvesting a dried bush took about one and a half hours, because tried to keep the branches intact A picture taken from below is the quintessence of all my experience. That option which in my opinion should be considered the "golden recipe" of microgrow. No temporary loss, ease, flexibility and ease of scaling to fit any size. With the final weight, an awkward situation, although the branches began to break, and everything is very dry. It turned out too much to be believed even by myself. I evacuated bumps in four containers of 0.8 liters each (I had to tamp it down). 00000
Likes
290
Share
@Ferenc
Follow
Wao.... weather is shit but she grew a lot. Not flowering yet it was because of the rainy days. It is just wind and rain now. Very bad.... Well, she is okay 💪
Likes
16
Share
Hei hei,the lady enjoyed some sunny days and is doing just fine.Her flowers are starting to look nice and thicking up slowly but surely.No nutes this week. See ya next week.Happy growing.
Likes
6
Share
Week 4 flower went fine with all three humming along nicely in living soil. Watered to saturation after applying a 1" top dressing of worm castings, compost, and Langbeinite from Down to Earth. No need for further plant training, defoliation, or pruning. Now, just sit back and let these girls finish their run.
Likes
34
Share
@PapaNugs
Follow
Everything went well over vacation! The girls are doing okay overall. They needed bigger pots and it's starting to show overall. Another reason not to use autos cause I can't lollipop. But the watering process is going well. The purple lemonade is hard to judge due to the colors. She's short and stout. She's doing okay but hopefully starts to look better. I'm considering using synthetic nutrients in this grow to start giving for power. Dimmed to 80% Here are the lights details: Medic Grow Mini Sun-2 150W LED Model: MN150-022 Spectrum mode: V1 Efficacy: 2.8 umol/J Thanks for stopping by! You can find the light on Grow Diaries: https://growdiaries.com/grow-lights/medic-grow/mini-sun-2-150-watts You can find the light on Medic Grow's website: https://medicgrow.com/