DAY 31 I MAKE LST & DEFOLIATION.

I’ve began flushing to prep for harvest just about 1 more week and I should be ready

Thanks for all of your replies to my questions. I will be slowly upping the bloombastic 0.1ml every other feed until we get to 1ml. 3rd July. I done a light defoliate around the base of the plant, a few small bud sites removed that were tiny and 6/7 leaves that were dieing from the bottom to free up space around the soil. Day 44, lowered nutrition to nearly half.

Well this lady is starting to look finish 😁 I've bumped down nutes and are still keeping ph at 6.0+-0.2. She had started to crumble under her own weight so I've had to tie her up a bit. Next week I'll flush her and then it's harvest time 👍 A little note the 20/7, i saw today that i got a single little mushroom growing out of the side of my airpot. I've seen a lot of funny things, but never actually mushrooms 😂 didn't know they could thrive in coco at all?

These girls are really starting to go nuts! We have come to the end of week 5 and they are already starting to pack on the bulk. I had a little issue with nute burn earlier in the week. I think it was because I was allowing them to dry out to much. I backed it down from 975 PPM to 700 PPM for 4 days and now I am back up to 800 again and they seem to be happy. I also think that my light is just a few inches to close. Its at about 16 right now and the leaves at the top are just not looking their best. It's a 340W light so backing it up a few inches shouldn't be to big of a deal. I moved it back to 20 inches from the canopy. Hoping this helps a little. The humidity here has been absolutely WILD! Tent fluctuates between 55% and 65% and I can't make it budge without the dehumidifier which raises the temp way to high. Outside the humidity hasn't dipped below 70% in over a week. Very strange, hoping that I can keep the room clean and keep enough air moving through the tent to avoid bud rot. FINGERS CROSSED

Overall this was my second autoflower grow and it turned out a lot better than my first. The plant yielded about 258 g wet so hopefully about half that in dry weight I'll update once I'm done drying. I have more of these on the go outside and have one more seed will definitely Grow again. Thanks for following, stay cool keep growing.

Getting fat. Minor powdery mildew, starting night dehumidifier this week. Still aiming for 3 lbs dry bud. Ww x gdp from last years seed project.

Day 71, 26th of November 2020: Beautiful isn't she? Purple colour appears.... so nice! The other Kaini the normal does not show any sign of purple colour unfortunately. Not much to report. The leaves started getting lighter hopefully they ain't gonna just die so quick. Fertilization is the same like before with exactly the same ratio and mixture above. The lamp is on 11.15 min and off 12.45 min. Last week was 15 min longer light cycle.... So every week 15 min shorter light cycle until the 5th week. So far -45 min. It switches on at 6 am and off at 17.15 pm.

Oggi, lunedì 22/01 ho cambiato una 40 ina di litri di soluzione nuova e fresca...ho notato che verso la fine, l'acqua/soluzione era più "limpida" rispetto alla prima ventina di litri ... credo che la pietra porosa con aggiunta di ossigenatore sia stata utile nel secchio "Sistema" per evitare eventuali depositi sul fondo Il problema maggiore è la temperatura stessa ossigenata... è impossibile tenerla a 19/20° senza l'uso di un raffreddatore(Chiller)...costa un botto! Ora è a 21.3 ma sicuramente salirà....di solito è intorno ai 22° ...La luce led dimmerabile è all'80%... È vero che ci saranno le foglie a fare ombra al vaso....ma non so se al 100% ,che metterò ad inizio fioritura e l'abbassero in altezza a 40 cm dalla cima,cosa accadrà alla temperatura,in generale Per ora andiamo avanti e proviamo a risolvere una cosa la volta 😉 Oggi topping o FiMing, vediamo cosa riesce😂 Crescono ma... credo che abbiano preso il Mosaico del tabacco..una malattia che deforma le foglie,si piegano le punte in su e in giù, alcune foglie appunto presentano una specie di mosaico con macchie giallognolo Sembra bene...oggi 2 febbraio defogliazione e da lunedì si passa alle 12 ore..... credo che farò così...o farò poi fatica a gestire le altezze e l'area...ho notato che le foglie e il tronco sono molto più grossi rispetto la terra con lo stesso periodo di 3 settimane piene...

Semanas finales 🚀

Greetings to all, fellow gardeners! Welcome to Peaky's Enchanted Valley My little girls look great and are already full of glue A prosperous and high quality harvest is expected

She has a delicious candy/sweet perfume! Bud structure is really nice, tight nodes and dense buds, I love this {unknown} strain! 😍

-

Week 6 (6-3 to 12-3) 6-3 Temperature: 27.6 degrees (lights on) 19.4 degrees (lights off) Humidity: 61% (highest) 40% (lowest) Watering: None. 7-3 Temperature: 27.1 degrees (lights on) 19.6 degrees (lights off) Humidity: 52% (highest) 39% (lowest) At the beginning of the day i made a 15L feed and gave both plants a 1.5L topfeed, and i removed some leaves underneath the canopy. Later that day I installed the AutoPot reservoir and attached all hoses to the pots and reservoir. The airpump is connected aswell, and on a 18/6 timer. I added the remaining 9L to the reservoir and turned on the system. At the end of the day i added another 15L to the reservoir. The light is at 80% with an distance of 45/50 cm. LUX: 24.000 / 26.000 8-3 Temperature: 26.1 degrees (lights on) 19.5 degrees (lights off) Humidity: 54% (highest) 40% (lowest) In the midday i turned off the reservoir, and at the end of the day the AutoPots were dry. I installed a SCROG net aswell that i bought a couple of days ago. The holes of the net are too big, so i will order another one with smaller holes, but for now i will use the bigger one. I disconnected the 18/6 timer of the airpump, so now it runs 24/7 on full power. I checked the PH of the reservoir and it went up to 6.3, so thats quite high, i added some PH- to 6.0 Light is at 50 cm. LUX: 23.000 / 24.000 9-3 Temperature: 26.3 degrees (lights on) 19.7 degrees (lights off) Humidity: 50% (highest) 41% (lowest) 10-3 Temperature: 26.7 degrees (lights on) 19.4 degrees (lights off) Humidity: 59% (highest) 43% (lowest) No pictures. The reservoir was getting empty, so i turned it off. 11-3 Temperature: 26.6 degrees (lights on) 19.4 degrees (lights off) Humidity: 58% (highest) 47% (lowest) Added 15L to the reservoir. 12-3 Temperature: 25.9 degrees (lights on) 19.2 degrees (lights off) Humidity: 58% (highest) 46% (lowest) No pictures.

Ladies and gentlemen, today is day 27, and this girl is doing great.. i just gave her a feeding around the rim of the pot .. she's leaning a little bit because my eternity grow plant is taking up all the tent, and this poor little girl is struggling to get light.. She's looking good though she will prevail and I believe end up being a great plant.. Kannabia seeds much appreciated. You guys are great genetics, so far doing great as well.. God bless everybody and happy growing ✌️. P.s i'm unable to upload the maxibloom nutrients in the general hydroponic silica that she's getting as well..

Ultima serata passata all'aperto ad una temperatura di 2/3gradi c°...un buon sbalzo termico.stamattina quando sono andato a tagliare la mia bella bimba mi è sembrata più brillante di quando l'ho tirata fuori dal box...bene bene😂🤣😉😋🤤

Week 6 Day 1 10/28/2023 Water Change Day!! Added: 36 gallons of Water CALMag- .75mil/Gal GH FLoraMicro-4.3mil/Gal GH FlroaGro-4.3mil/Gal GH FLroaBloom-6.5Mil/Gal Liquid KoolBloom 2.5mil/Gal TPS SIGNAL- 4.0mil/Gal ORCA-.5mil/Gal I setup my PH automation system.. I will start it running in 24 hours after the system settles in. Week 6 Day 2 10/29/2023 Going to be interesting.. I left the old monitor in to do a double check behind the new auto PH monitor.. not eh problem is I configured the New one and I am pretty sure that it is more accurate than the previous one I was using but the difference is 5.9 on the new one and 6.19 on the old. So it leaves me to questions if I was always running my PH higher but still just within safe range? or is this one off by that much. Questions, Questions.. But so far it is working I had to make several adjustments to dial in how much of each gets released but right now they are sitting around 5.9 Week 6 Day 3 10/30/2023 Worked on adjusting the auto PH system and I think I will need to change out some of the gear to make it work better.. Right now the suction/ flow rate has to be up to high in order to get the Up or down out of the Containers and the UP kicks on before the Down has a chance to settle.. I would have hoped there is a steady reading for X seconds before it starts the other.. but there isn't it is automatically kicking off the Up even while it is still adjusting from adding Down. Week 6 Day 4 10/31/2023 Today I did nothing but take some pics.. Nice day.. the experiment of the PH auto system is a bust as of right now.. the range is out of what I want.. and it keeps immediately kicking off without giving the water time to balance.. since this is a res system which the water moves.. not the best.. it doesn't have a wait time before release more.. and it keeps releasing even after it starts reading in range.. so it drops it lower than it should.. I could probably dilute the PH up and Down and make it a little more effective.. but not sure what I want to do at this point. Week 6 Day 5 11/01/2023 Today I did nothing but take some pics.. Week 6 Day 6 11/02/2023 Ground Hogs day... Today I did nothing but take some pics.. Week 6 Day 7 11/03/2023 Today I took some pics, I had to empty the dehumidifiers out but that was pretty much it.. She seems to be happy happy and growing well..