Sensi Seeds//Skunk #1//NFT

Right I get that.. but when they develop them, they usually test on all models. And if it’s not up to par - no pun intended- they will not release it for said device. I didn’t develop it and I’m not a mobile phone camera expert.. but it’s not likely sophisticated technology.. it’s likely taking just a few parameters from the hundreds possible to calculate the PPFD.. Anyways, yes you should take It with a grain of salt but again at 1% of the cost of a super reliable light meter.. it’s good for getting an idea of what your plant is receiving

If you sorted your issues, then yes, you can take damaged leaves because they are not so efficient and you have a lot, but if you still on the way ... Better leave them, they will eat all remaining stress ... All the best !

Your Sensi Bloom feed has a descent amount of iron in it. I don't think that's a problem for you. Your idea of calmg could work, I notice the TDS is on the higher side but if they are feeding well with it no problem. an ec drop of .2 daily. a small change in EC daily is good indication they are doing well, but a larger one is a sign they need more food. I did notice some yellowing in the leaf tips in your diary photos suggesting magnesium but I don't see them in the photos you picked for this question. I was wondering if your lighting height is ok or if its to close. When the plants are getting to much light they show small yellow tips on the top growth and will not green up as fast. at 17.5" it feels a bit close but I don't know your lights manufacture. Or how to calculate the ones hanging off the sides in addition to the ones above the canopy. Last week it was at 65cm, previous week 70cm. Dropping it down to 45cm might have been to big of a change. I think your plan of giving some extra calmg wont hurt them if you keep it on the lower dose side of thing. But it may not solve the problem your looking for. Give it a shot and see how they react, maybe they will green up. Keep an eye on the EC and PPM levels and watch for some nutrient burn issues. I'd also double check your lights height as that may also be the reason for the leaves not greening up. Best Of Luck and Happy Growing!

Also PH flux can happen from gunk in the reservoir as well. All that bio film eats and creates its own things. If its co2, that will dissolve into the water forming carbonic acid and lowering the PH as well.

The room outside the tent would also need to be free of light or pitch black for it to work and not "wake up" the plants. I've read about green lights but did not pursue it any further. I'd aim to get all the work done when lights are on vs using green light, But if that's not possible then it maybe its your best option. From what I did read it has to be a true green light. Can't remember if now bright it is will also be a factor. There was also some information about how a low enough lux ".3 or lower" light will not disturb them, in the same way as how the moon works. but its was not discussed as hard facts, and would depend heavily on the spectrum of moons light. Best Of Luck!

They will be just fine and grow and flower as though noting has happened. No need to do anything either, just let the breaks air dry and the plant will heal itself. Tape can cause fungal problems, which will kill the affected branch. Try and keep the breaks as dry as possible and definitely do not spray them with water, this can cause fungus to grow. Hope this helps, Organoman.

Yes, not all seeds will be ready at the time of the suggested manufacture time. 8 week can turn into 11 or 15. Their more of a suggestion then a fact, This one appears to be way off from what they say and thats ok too. It is what it is. just go with the flow. I'd wait another week or two before using that product. Keep an eye on your trichomes. your buds looks like they will fatten up some more. Good Luck!

the length of the light pollution during dark hours is the concern... interrupting darkness is a problem... a momentary flash is no big deal but prolonged exposure to light is definitely a concern for screwing with hormonal balance required for bloom phase. this sounds like the lights didn't turn on and it got extra hours of darkness? If so, that is no big deal.. definitely won't cause hermies... it may have slowed down development but only slightly.. 1 day our of many and only a few hours at that is not a major loss of energy relative to the total. uninterrupted darkness is a key... it is related to a hormonal feedback loop that signals when to switch to growing flowers instead of stems and leaves. it is a "switch' in the plant... interruptions late into flower are less of a problem than early on. if early, you are at higher risk the plant starts to Re-vege or pop nanners later. realize that if somethign does cause nanners, it will take weeks from the cause of the problem to see them -- it takes time to grow, they don't pop out overnight. That's probably why you get a certain portion that simply don't believe light pollution is a problem.. these ppl are simply wrong. this is old and thoroughly proven knowledge .. nothng new. certainly isn't relegated to marijuana plants. many work this same exact way.. also, it's 10+ hours that will generally flower a plant. "12" is to cover for any oddball genetics. even 13on/11off is perfectly safe to use. i'd avoid the "10hour" for previously listed reason. by using 13/11 you need about 8% fewer photons to provide same DLI.

You may have precipitated something? I dunno. I’ll say tho I’ve had similar shit show up after adding great white to my res. Absolutely coated the roots with shit like this. I try to keep it simple in hydro

Personally, I don’t do a hard flush where I just feed water for a week or so like a lot of folks do. I’m usually in soilless or DWC- so about 5-7 days from anticipated chop I’ll slowly taper the EC down. If I’m at 1.5 that first day, I’ll feed 1.2 EC, then 1.0, all the way down to 0.5 or so.. for a couple days and hope I’m seeing the fade I want around that point and then I’ll chop. If you’re just gonna feed straight water id only do it for 3-5 days in a hydro set up like you have. But you should easily be able to get down to getting the same EC from the water you’re putting in as you get out - within those 3 days. I guess it depends what kind of feed schedule you have tho. Hope this helped!

Don't place the fan directly on tbe buds and make sure to have long branch length on the colas. These 2 things will prevent the buds from drying too quick.