Everything was fine. So I started to bath each pot by using a fermentation nutrient by using beneficial bacteria, mycobacteria, some Orgatrex, different mycorrhiza's as 36 hours fermented potions with 2 liters/pot. Oh I forget to tell You, as You can see in the Video the water drops 💦 on the surfaces of their leafs @ day 23 I used Boom Boom Spray too for preparing the next stage of powerful photosynthesis by raising up my SanLights @ 300 µmol/m² s. Second video was @ day 26. I raised up a little natural CO2 from 450 ppm to 550 ppm. So they were prepared for more powerful photosynthesis coming up the next days… Critical Orange Punch and Amnesia Zkittlez showed some typical nutritional sensitivities some phenotypes of Sativa dominated strains can show @ the way to powering up the system. Light tops on the head of the leaf area. But again: “Don’t panic, it’s organic.” Also @ day 26 I started with my preferred technique of LST by mainly just pull down a little, the biggest fan leafs, so the little Life-hungry drives were able to came through and got enough homogeneous ppfd for uniform growth rate too.

I'll do final height and all that after it's done.. One is really tall and the other one is short and Bushy. Chopped the shorter Bushy La Diva 6-20-2020 down today 😁💚

Day 29 of Veg Watered once in the past week Defoliated large leaves Plant 1 = 8 inches Plant 2 = 10 inches Plant 3 = 8 inches

Florganics is a living soil starting fertiliser the earth is this time plagron light mix the lamp is at the start at 25 watts and 20cm above canopy i will start to remove water from the system by placeing a spongecloth on the waterslide i think the earth is a bit on the wet side Also want to add nutrients at some point and fresh nematodes to make sure i dont get the damn flies again i move the controller to the other side to make sure the sensor for temp and humidity is close to the plants I had to change the soil mid week as it was too hot. It was made from last year's FLO Florganics and too bad... It switched to biotabs NL And put ZK 1 and ZK 2 in the fridgegrow system. I removed ZK 3... WHATEVER FLO Florganics is actually a great product and as soon as it is available again we will use it again... There was trouble with the factory and Flo learnt a lot. Now the fertilizer gets tested in and independent lab.... END of week all looks great the plants are growing the one that had too many nutirents for a while is now ... bigger of course

Plants are really blowing up! Forgot what day I flipped these girls exactly but I’m guessing there just under 2 weeks into flower now. Cheers 💨

This week went very well! One will be getting cut an hung to dry while the rest finish up with one more week of flush ! These ladies are smelling so lovely I hope you all enjoy! Stay tuned for next week! Cheers 😤💨💨💨💨💨

Hi growers! The kushes are buding nice!Bubba kush started to coloring a litle.Dutch kush have such a nice smell.Loove the smell that is coming from the tent! Stay green!🌱

**Encontrarás la traducción a español al final de la descripción** If you like this week, please hit a like, it costs you nothing! 👊. Thanks in advance 😉! From/Desde: 19/08/19 || To/Hasta: 25/08/19 From day/Desde día: 28 || To day/Hasta día: 34 -----IMAGES & VIDEOS----- P5 - I'm loving this photo, is the first complete cool photo of the AK i've taken. With the structure, the fixing rods with the same length as the diameter of the AirPot, and those beauty rubbered green cables 😍. P8 - I'm feeling that those branches looks too weak, and slim for what's coming. From next week i will use Rinho Skin to see if it can help them to get fat in upcoming weeks and before flora time. I'm also minding to create some branch supports with the 3d printer that will be placed on the LST structure, I need to twist my mind a bit with it. -----WEEK SUMMARY----- Another super heat week. While at home i'm at 34~36º in the street things are worse :(. Also humidity fluctuate from 50~65º. At last I removed those ugly & dangerous cables from the branches and used a rubber covered one. For now i only need to fix her in 4 points, 1 per each main branch, as you can see, at about 13 cm of the main branch. Later i will fix her with another 2 points per branch, one in the border of the pot from inside, and the last one also in the pot's border but outside. This week i removed the first horizontal internode on each main branch, and also removed the branch that grows vertically down from the second internode leaving in place the one that grows totally up. At the end of the week i will fix the SCROG mesh, but it's not going to be permanent until later, or maybe not at all due to dark photography, as if i place the mesh i will not be able to move the plant (i need to think about it). For now, I just need it 3 or 4 days to test it as i never placed this 60x60 mesh before, and also i had to cut the central rods for the mesh. About Alice K. she's growing beauty and healthy, some week ago i found a little white spider that i killed, @time (week 7) I didn't noticed any insect signs more. Also remark that she's standing well those temperatures and some days of very low humidity some hours 35% inside the tent. And also the equitative distribution she's developing. As i said on previous week, i will kill those clones at mid week as i'm going to plant 4 more seeds in a week, and all is going to be too much work 😞to compatibilize it well with my job. -----WATERING CALENDAR----- 23/08/19 (Day 32) - 3,000 ml with all week nutrients @ 1.1 E.C. PH5.8 *****ESPAÑOL***** Por favor, si te gusta esta semana dale un like, no te cuesta nada 👊. ¡Gracias por adelantado 😉! -----IMÁGENES & VÍDEOS----- P5 - Me encanta esta foto, es la primera foto completa guay que hago de la AK. Con la estructura, las barras de aluminio de la medida del tiesto y esos cables cubiertos de goma verde, me empieza a encantar el aspecto de la planta 😍 P8 - Tengo la impresión de que las ramas son demasiado endebles y finas para lo que está por venir. A partir de la semana que viene, usaré Rinho Skin para ver si las puedo ayudar con el engorde antes de que llegue el tiempo de floración. También estoy pensando en crear unos soportes para las ramas con al impresora 3D que irían enganchados a la estructura para LST, necesito darle unas cuantas vueltas a esto último. -----SUMARIO SEMANAL----- Otra semana super calurosa. Mientras que en casa estoy entre los 34~36º en las calles la cosa es mucho peor. También la humedad está un poco loca ya que a diario me fluctua en casa del 50~65º. Al final he quitado esos cables feos y peligrosos de las ramas y he usado un cable con goma en condiciones. Por el momento sólo he tenido que atar la planta a 4 puntos, 1 en cada rama que he dejado, como se puede ver a unos 13 cm del tallo principal. Más adelante usaré otros dos puntos de fijado en el borde del tiesto, uno de ellos en la parte interior y otro por fuera del tiesto. Esta semana he quitado el primer nodo de cada rama y también la rama que crece hacia abajo del segundo nodo, dejando la rama que crece totalmente hacia arriba. Al final de la semana colocaré la malla de SCROG, pero no va a ser de manera permanente, por lo menos hasta más adelante. Voy a empezar a hacer fotografías de fondo oscuro, y el tener la red me va a imposibilitar la tarea ya que debo sacar la planta del armario para las sesiones (necesito pensar en ello). De momento la quiero montar 3 o 4 días para probarla ya que nunca la había montado antes y también tenía que cortar las barras horizontales para la malla. Sobre Alice K. está creciendo super bonita y sana, hace un par de semanas encontré y maté una arañita blanca (Requiescat In Pace), a día de hoy (semana 7) no he visto más signos de insectos. También debo remarcar lo equitativamente que está creciendo y lo bien que soporta las altas temperaturas y la escasa humedad, hay alguna vez que he mirado el higrómetro y estaba al 35% dentro del armario. Como dije en la semana anterior, mataré los clones a media semana, voy a plantar otras 4 semillas la semana que viene y va a ser demasiado curro 😞para compatibilizarlo con mi trabajo. -----CALENDARIO DE RIEGO----- 23/08/19 (Day 32) - 3.000 ml con todos los nutrientes semanales @ 1.1 E.C. PH5.8

Ok next week is just water and the chop. I am done with these plants, they did well and I'm happy with that. Got some real fade and issues all through out the run of this grow but the buds on the plant are looking fantastic. Can't say I am disappointed in them as I legit did not give a fuck about them and they produced. so that's a massive bonus. I will be drying them indoors for the same period as the other plants I was harvesting. give them a little cure and see what they are like.

fresh water 580ppm ph 6.2 i decided to go a bit lower in ppm as this is an autoflower stretch starts, there isnt much time left before flower maybe 1 week. i started counting “day 1” as when the seed popped open thats why it looks like this plant is 1 week behind day 40: little defoliation

The plant grows at fast speed with no issues. I keep defoliating once/twice a week and the foliage is always fast in growing back and branches too. I adapt LST daily to make sure light reaches all of the buds that are now clearly visible and more and less evenly distributed. I could not have the main one at the same height because it is too close to the border of the vase. I am not sure why the ph of the soil is around 7/7.5 while before watering i always regulate the ph to be 6.4/6.5 and the soil itself is 6.5 by default. What are the factors that increase the ph?

Drunken Bitch Slap is doing really good. She has stretched a lot. So much her leaves get clipped by the fan on accident when I am working on her. My photoperiods room is looking pretty packed, and flowering nicely. I am really glad to be back to healthy grows. I do have a slight fungus nat issue. They are not super bad. I see one once in a while. So hopefully she developed some nice dense colas. She has been eating, and drinking like a champ. Its looking really good under the Hortibloom Solux 350. Thank you Hortibloom, and Aeque Genetics. 🤜🏻🤛🏻🌱🌱🌱 Thank you grow diaries community for the 👇likes👇, follows, comments, and subscriptions on my YouTube channel👇. ❄️🌱🍻 Happy Growing 🌱🌱🌱 https://youtube.com/channel/UCAhN7yRzWLpcaRHhMIQ7X4g

11/17 As of tonight she is under the 400w (MH), in the next couple weeks I’ll be pumping her up and pushing that growth into the Scrog. 11/18 Nothing to report on today, today is the beginning of week 5. I’m expecting to begin flower at the end of week 6. 11/20 LST has begun! She’s been a bit deficient in Cal-Mag, I’ll be feeding her along and letting her veg for another week/ half pumping her up for the main event.

This week I started feeding my plant with an ec between 0.6-0.8. I also lowered my lamp so they get more light and I topped the plants and started lst.

5/11 - 5/17: I have her in full LST submission..sprawling nicely.👌 I watered her once really well at the start of the week with endoboost, humic acid, silica, cal-mag, molasses, and big bloom...and a little bit of grow big. I foliar fed with boom boom spray one day, and a solution of fulvic acid, cal-mag, big bloom, sweet & sticky, and silica a few days. It rained really heavy on the night of the 15th, so I won't be watering again anytime soon. All her topped shoots are growing out now. I'll have enough soil for a few plants in 3 gallon pots, and from what everybody says, I'd be very happy with some more jars of #7. I spent all 3 seeds to grow this one plant, so I'll try rooting some clones of her soon...👈 This week I received my new portable outdoor misting fan and hoses and got it set up on a timer with just airflow while the lights are on, and once the temps reach about 95f regularly, I'll have my hose timer let 10 minutes of water every 2 hours get misted across the canopy. It should lower the "real feel" by about 25-30 degrees and increase RH considerably. Also hoping that the constant airflow will make them stronger and keep insects off of them somewhat. It will also enable me to easily give them a blow dry if it rains in late flower. But wait...that's not all....it's also gonna be very much more enjoyable for me to sit in the garden and do my thang. 👍 I found a waterproof 200w 3000k light that has two panels that can be independently aimed in different directions. It covers a 3' x 4' area very well. It gets hot as hell, but..it's outdoors, so.... All total, that's 470w watts in 24 sq ft that i'm supplementing with. I've got very vigorous growth, so it seems to be doing the trick,

Hola familia, siento la ausencia estos últimos 8 días, pero estoy de vuelta, estás misty gorilla auto de Zambezaseeds, están fenómeno, ya empiezan a desprender aromas, y eso es agradable, espero que engorden más estas flores por lo demás va bien, entonces la temperatura la mantenemos por debajo de 26 la humedad por debajo del 40% , sigo alimentando las con Agrobeta, por supuesto, os voy adelantando que va a ver muchos cambios cara al futuro y para bien, os iré diciendo poco a poco. Un saludo fumetillas y buenos humos.

Things moving along nicely, aside from the humidity. My ac is a bit underpowered it seems and having trouble keeping up with the transpiration caused by so many leaves. Looking forward to a second heavy defoliation in 3 days. All healthy, all good. Autos get the chop within 14 days, taking much longer than I anticipated

Week 7 was on auto pilot until I realized it was 1 more plant to transplant. Since I got to transplant(work), every plant went to the hair salon(LST, Defoli, Fiming). My first time and I must admit I regret it. 😅 my plants look naked, I felt bad so I added Kelp into the NUTE line up....... I have no idea what I'm doing but I'm doing it at 150mph.