Likes
Comments
Share
Likes
12
Share
@DrShotzUK
Follow
All round great strain to grow , responds well to lolly popping technique , produced around 8/9 good main colas ,, covered in resinous terps with a strong earthy smell … I cannot wait to try this one she’s a beautifull looking plant DRSHOTZUK🍀🍀💚💚
Likes
5
Share
CBD Star bud seem to be thickening up despite obvious signs of deficiencies, likely due to a pH induced nutrient lock out. Phosphorus, nitrogen, calcium, manganese, molybdenum? It’s basically the periodic table of deficiencies. Main cola started to turn purple due to molybdenum deficiency? Found a spider mite on Cheese… sprayed the leaves down with a 1:10 alcohol:water solution which seems to have taken care of the mites.
Likes
23
Share
@Wazowskid
Follow
I've stopped giving them fertiliser and did a root flushing 4 days ago. They are looking good, smaller buds of what could have been with the correct equipment and dedication but I can't complain. I don't have a magnifying glass so I'm basing myself on the pistils to know when to harvest. I think I'll give them one more week but everyone is welcome to give me advice, would love to receive feedback from more experienced people.
Likes
13
Share
Both Slushberry Mintz plants are doing exceptionally well. This strain has been performing flawlessly both outdoors and indoors so far, with no issues at all. This week, the indoor plant was defoliated, lollipopped, and topped in preparation for flowering, as I plan to switch it to the flowering stage soon.
Likes
18
Share
Hi guys, this week has been great for plant growth..they are 85cm tall and I think they will grow a little longer. You can see the future buds that will be covered with flowers. From this growth I am learning that the FIM technique is better because the buds will all be at the same height and look much more (as you can see in plant number 4). Pistils begin to appear and in the next week I hope to see more pistils. Stay Tuned 🦍
Likes
64
Share
April 24, day 35, the plant continues to widen with the LST I am performing, and has nice healthy growth. Lots of branching, but the early stages of the flowering stretch is opening the plant up a little. I switched from a transition nutrient profile to an early blooming profile, as there are a few pistils popping out here and there on the plant. My guess is that there will be another week or so of growth/stretch so I am hoping to get the plant significantly larger. April 25, day 36, I raised the light by 5 inches. I should have realized earlier but I was chronically running the light a little too close this run which likely contributed to the stocky tight growth. I figured that if my brightness was not exceeding sunlight and I was not noticing leaf issues it would be fine. However, measuring the ppfd at a 15 inch hang height showed readings of 750+ at the edges and 1000 at the center. This amount is just not helpful for the plants structure even if it is growing vigorously. I raised the lighting to 20 inches which brought the ppfd to 650 at the edges and 850 at the center which is right where I want it. I am not otherwise touching the plant today, but will prune and perform some LST tomorrow. April 26 Day 37, just letting it grow. April 27 Day 38, did some training and pruning of the growth. The Euforia's transition to flowering has been slow, but the growth and vigour of the plant has stayed strong so at least it's giving me the time to fill up the tent. It's taking up just shy of 4sqft of growing space, so by the time time the flowering stretch finishes I am hoping to have growth close to all corners of the tent. So far I have been successful keeping the growth low, as this tent is very tight in its height. April 29, day 40, just letting it grow. April 30, day 41, switched watering to 3x daily 20 second intervals. The leaf tips are not showing any signs of burn, so so far so good. Took a few leaves off to expose the preflowers as needed.
Likes
5
Share
@cr0baron
Follow
The buds foxtailed a lot partly due to light stress but also due to genetics. This made it a bastard to trim. Unfortunately when drying the buds I noticed some mould had infected a few of the large buds which was a great shame but I'm still pleased with the yield.
Likes
11
Share
Likes
9
Share
those nugs are getting bigger and bigger each day. They‘re just soaking up the fertilzers. We have to water them every second day 2l per plant
Likes
Comments
Share
Tuesday, August 4th: This is the first time I've ever had a pH problem in living soil. Soil pH was waayyyyy too high (7.9, so I flushed it out with 5.5pH-6.1pH dolomite lime water, yesterday. Today, after I post this (9am), she'll be getting another flush of just 5.5pH purified water. Then, I'll top her off with a couple gallons of pHed BuildaBloom and Dolomite Lime water. Hopefully, this will take care of the problem. You'll see the signs of pH problems and cal/mag deficiencies in some leaves throughout the video. Anyway. As you can see, she was bent in half during a very bad storm. So, I just kind of half-assed propping her up. I still need to actually tie her up well before those nugs get any bigger.
Likes
3
Share
@dwotTV
Follow
Chopped one before vacation and off to dry while I'm in Ireland and the UK, leaving the other one to keep going and chopped on return.
Likes
5
Share
@Bak2Blk
Follow
They're getting so big. I'm hoping this week I'll start to see some flowers starting to form. Gave them a ph'ed watering only today. I'll be giving them water with calmag on Wednesday. 7/27 - They're finally budding up. YIPEE! This is my best grow batch yet! GDP1 and BK are about 11 weeks old and GDP2 is about 9 weeks old.
Likes
18
Share
@Stonyways
Follow
relaxing and enjoying the show almost at max watts SPIDER FARMER SF2000 is now maxed out at 207w , 16"-18" from the plants and I will need to keep up with pruning to allow more air flow and more light to penetrate deeper into the plant. 2, 6" oscillating fans on 100%, may be on low or just one stationary but at this point in the grow air flow is a MUST, specially for the thick, dense vegetation of the OG Kush. trying my hardest to stick with the 4" ventalation til the end of the grow. Right now I have to replace the exhaust ducting due to tiny pin holes leaking more than a bit of light.
Likes
97
Share
@Wastent91
Follow
Ehi ragazzi è già passata una settimana e neanche me ne sono reso conto! Si vede che l erba che sto fumando è bella potente per farmi rimanere in uno spazio/tempo non ben definito! Apparte questo divagamento, posso dire che i nutrienti stanno facendo effetto! La ragazza sembra che stia crescendo davvero bene , ogni settimana raddoppia le dimensioni circa , ora siamo già al quarto paio di foglie laterali e ho intenzione probabilmente in settimana di mettere la rete per iniziare a direzionare le piante,in modo da avere più cime possibilmente uniformi, ma soprattutto, avendo il problema dell altezza, cercherò di fare in modo che rimangano più basse possibile , dovrò studiare un metodo per farlo senza stressarle troppo e senza utilizzare tagli e toppature che in un autofiorente,necessiterebbero di troppo tempo per recuperare dal taglio e quindi la resa sarebbe minore,... Bene siamo solo all inizio e non vedo l ora di vedere come cresceranno queste ragazze magiche ! La luce FC E 300l è davvero impressionante! La sto usando al 50 % della potenza e devo dire che stanno crescendo in modo molto rigoglioso tutte le ragazze in modo uniforme anche ai lati, la luce è molto ben distribuita rispetto alla TS 1000 che avevo in precedenza , che nonostante tutto ha fatto il suo dovere e lo continuerà a fare in modo più che egregio! Buon 420 a tutti alla prossima settimana! 💪👊😉
Likes
16
Share
Correct weeknumbers are difficult in a perpetual grow lol🙃 Little update with all the strains. Runtz XL(more xxxx small lol) was drowned as can be seen, no hole in that pot>drilled them today. As small as she is she is the second plant that entered flowering stage. Red Gorilla girl XL was in my vertical garden system, didnt respond well its leaves started to wilt, the pot got replaced somewhere a little more temperate. The lsd-25 seems to be okay in the vertical wall. The Purple punch is well into flower ready to develop nugs in next 2 weeks Happy growing peeps
Likes
13
Share
My second girl is really having a rough time coping with hot temperatures. Summer is really hot where I'm from. It's about 40 outside.. and it's gonna get worse with heatwaves soon.I had been turning on my AC lately but ones I turn it off temp goes up in 10 minutes.. I tried putting ice buckets next to the opening vents in my tent.. but it didn't seem too make a big difference. I added another small fan inside the tent and big fan outside in the room for more cool air circulation. I just hope I can make my girl survive till the end. The buds are still getting bigger and the smell increases with days. Leafs started to die off tho and some started lose colour or get crispy. There's so much leafs that I can't even defoliatiate them all and don't want to touch the buds a lot to ruin them.LOOK AT HER THO SHE IS A BEAST! 🖤🖤👽 I've heard that with heat your pH goes down even if you gave her the correct one. So I think I've got that problem because I calibrate my pH meter every time I use it to avoid problems with pH. Will see in the future...she've got another 2 weeks I'm assuming. Gonna check trichomes in a few days, last time I checked they just started to get milky. I hate summer and heat 😭 it was doing all well before it got soo hot 👿👿🙏💪💪👀👀 oh well Cya next week with an update.