So langsam werden die Trichome immer reifer. Alles riecht wunderbar im Garten. Bei einer pflanze mußte ich einen Bud entfernen, da sich dazwischen ein bisschen Schimmel gebildet hatte.

This week I noticed that there have been no new pollen balls to pluck. All the new growth/pre-flowers on the herms continue to look 100% female. I am hoping my experiment worked and they have been saved, but we'll see. They will stay secluded to be on the safe side. I transplanted everything into 5 Gallon buckets. I also purchased a new grow kit. It came with a 4(w)*8(L)*6(h) tent, intake fan/exhaust fan/ducting, and 3 LED lights. Two are 2000W and one is 1200W. Hope the babies like their new home! Any thoughts or suggestions for improvement please drop them in the comments!

Showing lots of white hairs on the bud sites it’s alive

She seems to be coming along well. Fed her cal mag once this week 2 ml per liter. The other feeding she only received bloom and grow. Top leaves are discolouring but I'm unsure why.

Week 3 of Flower we focus on Defoilation. This really is going to test the genetics response to extreme stress. Performed a 5 day Schwazze to minimize stress instead of ripping off most leave in one day. Plant seem to have reacted well so far. This technique has really opened the canopy and expose many bud sites. Preparing for a top feed at start of new week.

Сорт мне понравился. Единственное не устойчив к плесени. Если не контролировать вдажность, то плесень обязательно будет. В целом сорт не плохой. Рекомендую новичкам

She’s onto flower. Showing Pistols 48 hours after the flip to an 11 on 13 off light schedule. She is doing great and is the biggest of the three in the tent. As she’s a true Sativa I added the first layer of trellis netting in anticipation of her stretch. 8-9 weeks of flower ahead for this girl.

#1&2: Big Bud Projekt #3: Bonzai 20.10. Claudia legt langsam wieder los nach dem Umtopfen. Rosi hat sich jetzt auch langsam an das Wasser gewöhnt. Bonzai schlummert ;) 22.10. Jetzt gehts looooooos! 23.10. ..erstmal chillen ;)

Thanks for the help everyone looking forward to future grows. Went way better than I imagined my first grow going.

Day 62: time to flush! Flushed her with canna flush once so now for 5-7 days I will just give her plain water with ph- She looks so nice! But way to much nitrogen in her This is the light that I’m using for this grow! Mars hydro SP3000 High PPFD at 2.8 umol/j, average yield at 2.5g/w, increasing your yield 50% or more compared with old blurple and HPS lights, 300 watts output. Dimmer knob added, more convenient to adjust the brightness. Up to 30 lights can be daisy-chained and control together on just one light, or just have one lamp in 120x60 tent is perfect for light. https://www.instagram.com/marshydro_aliexpress2/

one of the plants was eaten by snails 😕☹️ i have a spare of the same strain that hatches in pellets

Feb 1st Plants are stretching out with about 2” growth last week. The root structure is awesome. I will be transplanting to individual pots soon. I am going to try out an autopot system which is still considered hydroponic although I will be using coco/per light medium Started them on 75% strength nutes Feb 3rd Moved the plants over to my new autopot system Feb 4th Plants moved to the new medium coco/perlite with very little shock. With in 18 hrs all 3 were perky again

hello growmies! day 51 finally the pre-flowers begin to appear. I apologize for the few photos but unfortunately they really filled the box and I find it difficult. overall I have to say they look in perfect shape! I will keep you updated thanks for passing by. like and comment! good day and beautiful growth to you 🌳🌱

Hallo Growmies, Von der Mitte der 6 bis 7 Woche habe ich ihr PK13/14 verabreicht. Auch eine aller letzte Entlaubung vor der Ernte habe ich vorgenommen.

Hello friends! Our Poisonous friend moved to live, in more polka dots!) 5 liters .. I hope she will start to grow actively! and will be ready for the next transplant into a 40 liter pot in a couple of weeks .. as I said earlier .. I have big and interesting plans for this girl .. so don't miss the new diary ..

4/13 10AM MONDAY They are looking pretty good. Got the ph stabilized and only running 98W! Using a few DROPS in 18oz to test Purpinator on veggies. 4/14 11am Using a little Purpinator .5ml per gallon and will have to do lots of runoff to prevent burns. Using vegetables to test fro Purpinator burns👍 4/15🚨🚨🚨 Your setup photos are great — thanks for sharing them. The R2-D2 power strip topper is a fun touch (he’s guarding the outlet like a proper astromech droid). Here’s a clear breakdown of what I see and my honest opinion on the power draw/safety. What you’re running • Two Mars Hydro TS1000 lights — These are officially rated at 150W each (real-world draw is usually ~145–150W at full power, sometimes a bit less if dimmed). You mentioned ~100W each, but they’re actually higher — so total for the two lights is roughly 300W. • Plus the two black fan speed controllers (one for each tent’s exhaust/inline fan). • A few small wall warts/adapters plugged into the white smart plugs or directly. • You measured 335W total across tents 1 and 2 on one outlet — that lines up reasonably (lights ~300W + fans/controllers ~20–40W depending on speed + minor losses). Is this safe on one standard outlet/circuit? In most US homes a standard wall outlet is on a 15-amp 120V circuit: • Max theoretical capacity = 15A × 120V = 1,800W. • Safe continuous load rule (National Electrical Code for things running 3+ hours, like grow lights): Stay under 80% = 1,440W max. Your 335W total is very low — only about 23% of the safe limit. That’s comfortably safe. No real risk of overheating the outlet, tripping the breaker, or fire hazard from overload right now. My opinion on the setup: • Good: Everything is neatly plugged in. The white smart plugs (with the green lights and blue indicator) and the labeled ones (9e, 10e, 11e) look like you’re using them for timers or monitoring — smart move for controlling lights/fans independently. R2-D2 adds personality and keeps the wall organized. • Fine for now: Two TS1000s + fans on one outlet/circuit is no problem at these low watts. Many small grows run similar loads without issue. • Long-term suggestions (to keep it safe and reliable as your grows expand): ◦ Don’t daisy-chain too much — You already have multiple adapters and controllers stacked. Avoid adding a lot more (e.g., dehumidifier, heater, or more lights) on the same outlet/circuit. ◦ Check heat — Feel the wall outlet and the power strips after the lights have been running for a few hours. They should be only slightly warm, not hot. If anything feels warm/hot, spread the load. ◦ Dedicated circuit is ideal — For peace of mind, run the lights on their own circuit if possible (or at least separate the fans/controllers if you add more equipment later). ◦ Surge protection — Make sure the main power strip or outlet has good surge protection, especially with grow equipment that can have inrush current when turning on. ◦ Monitor actual draw — Your 335W reading is helpful. If you have a kill-a-watt meter or smart plug that shows real-time watts, keep an eye on it when everything is at full power. The houndstooth shirt hanging on tent 2 is a nice personal touch — makes the grow room feel lived-in and less sterile. Quick safety checklist for your whole setup • All cords are in good shape (no fraying, especially the black ones going to the fans). • Nothing is blocking airflow around the plugs/adapters. • The inline fans and ducting look properly attached (important for heat and smell control). • If you ever add more lights or equipment, recalculate the total watts and stay under ~1,200–1,400W on that circuit. Overall, your power setup looks thoughtful and creative (love the R2-D2 detail). It’s not overloaded at 335W, so you’re good to keep running tents 1 and 2 like this while you sterilize and prep tent 3. 4/16 543am 5ft tent sideways attached to 6ft table that can slide around

they are all thriving, growing exactly as i want them to. sucking up everything i give them and they are on daily feeds. some of the autos are starting to flower, but im gonna stretch out veg for atleast another 4/5days for photoperiods. they are ranging in height between 45 and 75cm. west coast OG auto from fastbuds been the tallest at the mo. dinafem cookie strains showing preflowers now and everything going fine. no problems as of yet in the slightest. daily updates.

Week 7 of flower,room is a bit to cold but they are very close to finishing. 👍🏾

Week 8 Flower Flush flush flush 💦🚽💦🚽💦 It's extremely important to flush for at least 14 days when using synthetic nutes, or any bottled nutes in my opinion. The aim is to make her cannibalize (fade) as much as possible before she's chopped. By doing this, she's using up her stored nutrients, causing the leaves to eventually die. The better the flush the cleaner the smoke 👌💨 even when in an organic set up, the plant needs to be nicely faded before being harvested. Otherwise she's still full of nutrients. I still feel I'll be able to get an even better flush when I eventually make the switch to RO water, as my tap water holds a ppm value of approx 150. It's not too much, but 0 is always better. She was taken down on Day 57 flower, after a 16 Day flush. I didn't want to take her any further as she was quite stressed being so close to the light. So to avoid getting seeds I waited until she had a beautiful fade before giving her the chop ✂️ I always take my girls down about 30mins before the light turns on so there is minimal chlorophyll production in the plant. This is to ensure the best smell, taste and overall burn after drying and curing. A subtle but very sweet-ish tropical fruit skin kind of smell to her. Her buds are super dense and covered in trichomes. I trimmed off all fan leaves and then each branch was hung in my drying box and placed in a cool area. She was dry after 6 days and ready to be dry trimmed and jarred for curing. I'll post those pics with the harvest update! Thanks for following and happy growing! 🐺