Thick, smelly dense buds ... They are still drying, some off them allready wet trimmed, some of them still attached to the stem, hanging to dry slower ... So can't come up with any numbers. It's a very nice harvest though 🤠

🌱🌱🌱Continuamos este cultivo, con esta hermosa cepa de FastBuds, Girl Scout Cookies Auto, en las ultimas semanas de Floración .🌱🌱🌱 👨‍🍳👨‍🌾🏻 Nutrición y Bitácora 👨‍🌾🏻👨‍🍳 -Día 50. Se riega con una solución nutritiva NPK de 1.5 Litros con Plagron Alga Bloom (2.6 ml), Plagron Sugar Royal (0.75 ml) y Plagron Green Sensation (0.75 ml). -Día 51. Se riega con 3 litros de una solución nutritiva NPK de Plagron Alga Bloom (6 ml) Plagron Sugar Royal (1.5 ml) y Plagron Green Sensation (1.5 ml). -Día 52. Se deja secar el sustrato, ya se aprecian unas colas gordas llenas de flores y resina, tricomas ámbar comienzan a verse, estamos prontos a la cosecha, quizás por el día 60-70. -Día 53. Se riega con 3 litros de una solución nutritiva NPK de Plagron Alga Bloom (6 ml) Plagron Sugar Royal (1.5 ml) y Plagron Green Sensation (1.5 ml). A los aromas dulces y diesel, se le suma un fuerte olor picante y terroso, cada vez un aroma mas complejo. -Día 54. El engorde de flores no para 💪 -Día 55. Se riega con una solución nutritiva NPK de 3 Litros con Plagron Alga Bloom (6 ml), Plagron Sugar Royal (1.5 ml) y Plagron Green Sensation (1.5 ml). -Día 56. Ultima semana con riego NPK, de ahora en adelante se regara con agua + enzimas . 🚀Equipamiento🚀 Indoor de 60x60x159 cm y una iluminación BlackCob F320, se activa solo 1 modulo (160w) a 45 cm del canopy por el resto del cultivo. Intractor de 135mm, extractor de 135mm, filtro de carbón, ventilador "oscilofan", ventilador "clip fan", este ultimo ventilador se ajusta en la parte baja de la carpa para mejorar la circulación de aire bajo el canopy, 2 termohigrometros y una malla SCROG de kanovi a 15 cm de la maceta. Acompáñenme para ver los resultados de este hermoso desafío, un saludo cultivadores 🔥🔥🔥

Hello everyone week 1 has passed for this Strawberry Banana auto from Fast Buds 😎 this plant is doing very well growing at fast pace and with a beautiful green colour on the leaves. Mars Hydro SP-6500 50% wish you all happy growing!

07/11/25 - Watering 1.5L each daily 😇 08/11/25 - Watered 1L plain Ph5.9

As you can see differenfe between mediums is huge..have to improve my solo grow bcs i think i might be doing something wrong..any tips??

*01/24 - Week 6 (Week 1 Flower) Her flowering has begun and bud sites are starting to become dense - All Veg nutes have been flushed and swapped for Flower nutes* **01/27 - Week 6 ( Mid Week 1 Flower ) Her bud sites are densing up as she flowers - Nute and clean water feeds remain normal - swapping to 12/12 next week*

I feel like this turned out better than it should have. Amazing genetics.

The fastest germination I've seen in 24 hours !!!!!! The Afghani ~ 30 hours 😁 100% success

Foliar fed shogun sumo boost yesterday

Hello growmies 👩‍🌾👨‍🌾🌲🌲, 👋 Here we go my friend, time to harvest 💜🌲✂️🏁🏁 💧 No Water 💡Mars Hydro - FC 3000 50% 13 cm Mars Hydro Fan kit Setting 9 Have a good week and see you next week for the harvest ✂️✂️ Thanks community for follow, likes, comments, always a pleasure 👩‍🌾👨‍🌾❤️🌲 Mars Hydro - Smart FC3000 300W Samsung LM301B LED Grow Light💡💡 https://www.mars-hydro.com/fc-3000-samsung-lm301b-led-grow-light Mars Hydro - 6 Inch Inline Fan And Carbon Filter Combo With Thermostat Controller 💨💨 https://www.mars-hydro.com/6-inch-inline-duct-fan-and-carbon-filter-combo-with-thermostat-controller Fast Buds - Gorilla Cookies FF🌲🌲 https://2fast4buds.com/us/seeds/gorilla-cookies-fast-flowering

Giorno 42 🍋

🧟‍♀️My little monster looks very happy. 🌴2th ScrOG net put on. ✂️🍭Defoliation time. 🌳 More substrate to protect roots. ✌️🎃 Thank you for checking my cultivation.

Everything going great. Smells like sour candies. Legit can smell the cantaloupe origins and it’s already getting blanketed in trichs. Can’t wait to see these girls get dense in the next few weeks.

Following The Grow Boss tips on YouTube "...yield is based on light, quality is based on growers talent" "...number one problem is, too much light, too much water, too many nutrients" Nutrients : (after having issues with nut burns, I decided to use Grow Boss's perfect ppm calculator) Invasion T (Glomus intraradices BEG72 and TRICHODERMA atrovide MUCL45632) 1g / plant Monster X mycorhizes (500 000 propaguls / Kg , made in vitro) 2g / 20cl then complete to make 1l Humic Fulvic Booster (humic and fulvic acids) 1ml / 1l Cannazym 2.5ml / 1l Rhizoponics 0.4ml/1l Lights: 2 x Adjust-A-Wings Avenger 600w HPS Lumatek 90000 Lumens 1000PAR 600w HPS Philips Son-t Green Power 95000 Lumens Soil:Platinium Royal Mix premium quality What is vapor pressure deficit? Often, marijuana growers who have their plants in indoor grow tents or rooms with artificial lighting, take into account parameters such as temperature and relative humidity to maximize plants growth and bloom, thus obtaining abundant harvest with top quality flowers. As we will see later, these factors affect different processes of the plant, such as transpiration or nutrient uptake. However, we usually forget about another important factor that is related to the aforementioned ones: vapor pressure deficit or VPD. Broadly speaking, VPD is the difference between the amount of water vapor that the atmosphere is able to retain (which depends on temperature) and the amount of water vapor contained in it (relative humidity). It is usually measured in kilopascals (kPa). Providing our plants with a correct relationship between temperature and relative moisture will keep us on the right VPD parameters, increasing the plant’s activity and thus improving its growth and showing its full potential during the flowering phase. The ideal would be to adjust both parameters (temperature and humidity) to get the best possible VPD value, so that the development of plants will be amazing.In the chart above you can see the right temperature and moisture values to maximize the development of cannabis plants. The green zone shows you optimal values of VPD, in which it would be ideal to maintain the environment. The orange zone shows correct values, in which plants should not have problems to develop normally. However, red areas show values in which your plants will be very far from hit their full potential, since the relation between temperature and moisture is not optimal. With relatively high values of VPD (between 5 and 12) plants tend to open their stomata and release a considerable amount of water vapor into the environment (increasing their transpiration). This increase in transpiration results in an increase in the plant’s photosynthetic activity, which will need more nutrients and will improve its overall growth, both during growth and bloom. The best range is between 7.5 and 10.5, which we have marked in green. However, we must be careful that VPD is not too high (dark red zone) since the plant would close its stomata to avoid releasing too much water vapor to the environment, which would result in fast dehydration due to excessive transpiration. On the other hand, if VPD is too low (light red zone), the plant will also close its stomata for not releasing more water into the atmosphere, which in this case would be already saturated (it would have reached the maximum water retention capacity in a specific temperature). In this way, reducing transpiration will also reduce photosynthesis, which has a direct impact on the plant’s development and yield. That way, VPD is essential when it comes to offer the best conditions for the development of plants, also to understand its water requirements according to the nutrients used and thus adjust them correctly to meet the grower’s expectations. N/B: SAY NO TO DRUGS -[Day 90] The plants are getting massive, not a lot of space left in the room, each pictures are token back against the wall or on top of a chair. The Super Skunk shall be ready first , the trichomes are visible without using a microscope, the scent is like an amazing candy floss coated with Skunk pee 😅Boerejongens quality @Home 😊 -[Day 93] Switching Buld Lumatek 90000 Lumens 1000PAR to SuperPlant Super Red 85000 Lumens 2000K 1498nm Lightening under the 1500nm wavelength (2000K) just between the NIR and the Microwave length, can't stand in the room too long without getting tears and shining eyes. Buds shall start to blowup like pineapples, increasing yield. -[Day 98] Everything is getting frosty. Starting to decrease RH . -[Day 103] Today the Y Griega started to push on her terpenes, believe it or not that plant smell stronger than the 6 giants Skunks (the Skunk strain is already a very strong smelling plant), she smell like a coffeeshop front door, the fragrance is absolutely amazing and fantastic, I will definitely grow a full crop of that strain ! -[Day 105] 42 days of Blooming folks ! It's getting serious now 😄 If it can helps you to realize, each plants gots 4 side and a middle, each sides gots 4-6 buds and there's 5-6 buds in the middle, there's 11 plants of 1,60m/5.25ft, how many buds does it makes ?? The correct answer will win 1 like 😅😂😅😂 -[Day 106] WEEK 7 of flowering, the end is close my friends, I'm trying to give you the best shots as possible, I wish I'd could share a good smoke from this crop with you guys ....😉

Cindy was a good plant. I dont had luck with the other planned ones, but not everytime gets everything good. I chopped the whole plant and defoliate a little bit. She's in the tent with 20,3°C and 53% Humidity.

Abandoned outside for 10 weeks Survived 2 heatwaves Only water Impressive

It is day 30 and we are finally seeing some growth starting after a few days of being locked out due to what I believe is from nutrient burn. Won’t go as heavy next top dress. I have ordered a soil ph pen which will be arriving tomorrow so that I can’t test my soil ph and the run off. Until then I have ph'd the water to 6.0 to hopefully stimulate more growth before flower. These plants are very short but stacked! I can’t wait to see how big they are at pre flower. After it’s 3rd week stretch. Reach for the skies bitches! Watering less aswell. I believe iam overwatering because I go days without seeing these girls. Exhale c02 bag doing well. Resembles mould at the moment. I want to take a moment to thank everyone who’s visited my diary. I hope to bring you great content! Always open to helpful suggestions. Stay tuned! Day 34 and we are at pre flower. See those hairs comin. Now they all gonna streeeeeetch. Drop a comment, like, or just offer me some advice. We’re all family here ✌️. Doin a little LST now that the space between the nodes are far enough for me to feel comfortable doing so. There was no where to put them no matter how slow I tried haha. Also have each girl in something that resembles the cross face chicken wing from the WWE. Little fan on fan action. It’s like the leaves were meant to stuck together. The knotches in the leaves interlock I mean. I stretch the upper fan leaf to the one directly below it. Opening up both shoots. Hope they made sense lmao.

Just been playing about with a DIY co2 generator with sugar water and yeast considering paying out for a better system and meter but at least I can still monitor to a degree but I don't think this co2 meter is up to much cop...... I've made a co2 bucket with an air pump still using sugar yeast 2x tomatoes and a potatoe puree'd 1x teaspoon active brewers yeast and 2.5 liters of water in a 5l bucket with sealed lid ratchet strapped shut sat on a 20cm square heat mat set on a thermostat at 24c to 27c temps sits about 26c for a prolonged co2 release levels have defo increased spiked quite high then settled approx 1200 to 1500ppm or the meter is wank but either way its adding co2 just for how long though ? I've read up on the fungus method which last 6months so I'll be sorting that soon