Processing
Likes
Comments
Share
Plants are going into flower. I took night time pics so you can see them sleep. They are a all looking great. This girl and her sister at the moment is 24 inches. Very nice branching on all three plants. I should defoleate and remove some of the bottom branches now.
Likes
22
Share
@Selkot
Follow
result for the first one: after 7 days of drying, a cleaning of the last leaves, and by removing the branches, I obtain 51g dry; for a first session in cocot, I hoped 100g with my 2 plants; this one thus made its job. just barely. 😉 2 weeks to go before I know if the other one will do better 👌
Likes
3
Share
Since Dosidos flowered two weeks before all of my other outdoor, it was lacking in size from the veg cycle. Next year I could offset this by having a few more plants or veg inside for a month or two before bringing them out. Other than that this strain had the most resin production compared to everything else! The dried nug looks comparable to quality indoor.
Likes
15
Share
@Sid93
Follow
the plant keeps swelling at a slow pace. looks bigger every day and smells stronger
Likes
21
Share
made some tea out Original Concentrate Nature'🙌s Living Soil add 6 tablespoons to half of 5 gal bucket of spring water stringht out the good old mountain 😷💪🙏👌
Likes
3
Share
Fattening up every day and smelling amazing! Took out calmag supplementation and will start a flush next week. Starting to see a bit of senescence. She finishes at 8.5 weeks max consistently.
Likes
9
Share
All the photos are in the 8x8 now. just a few autos in here now FOR EVERYTHING MARS HYDRO VISIT: www.mars-hydro.com www.marshydroled.ca PROMO CODE: rocknroll VISIT THE ALIEXPRESS STORE: @marshydro_aliexpress Instagram: @marshydropenny Thanks for taking the time to read and check out my diary🤜🤛 TS3000 FEATURES: WIDEBAND SUNLIGHT FULL SPECTRUM LED GROW, Infinite close to natural sun light, suit for all plants whole stages indoor growing, rapid plant response from seed to flower, achieve maximum quality and quantity, much better than traditional HPS grow systems. HIGH REFLECTIVE & NOISE FREE-Fanless LIGHT BOARDS design will make your growing life easy and quiet, quickly heat dispersing material aluminum reducing light lost to aisles and walls, increase the light intensity up to 20%, allowing your plants receive more energy and without burning your plants for maximum headroom. HIGH EFFICIENCY ENERGY SAVING PLANT LIGHT, high-power NEW LED grow, Compares to traditional 3000 watt HPS lamp and other brand led grow light while only 450 watts true output with 1016 LEDs, more scientifically and energy-efficient! Perfect for 5' x 5' veg stage, 4' x 4' bloom stage, higher intensity in a MARS HYDRO grow tent, reflective area, or by crossing over using multiple TS3000. BOOM YIELD LARGE GROW LIGHT, NEWEST SMD LED technology provide highest PAR/LUMEN output(1095.6umol/), makes you get 30% higher yield compare OLD led lights, can get max yield at 2.5g/watt, less pay but get more yield, bring a amazing grow trip to any home grower as it beams huge amounts of light energy to plants below. COMMERCIAL LED GROW LIGHT, Updated easy dimming & daisy chain function, main light controlled, especially come with two waterproof and dimmable Mean Well Drivers, auto sensing power supply works on both 120VAC and 240VAC and 277VAC, suit for Large Rooms and Commercial Setups. Low Energy-Consuming LED Grow Light: Consuming 300w and also mounted with 1016 chips, TS3000 has the ability to replace a 450w HPS light while reducing 40% power intake. High Efficiency LED Grow Light: With overall light output PPF 343umol/S as well as amazing PPE 2.3 umol/j, it's 50% even more photon efficient and can assure a 30% more return than the old HPS/MH lights. Patent Highly-Reflective Hood Shape: The reflector design on TS3000 is patented, which can effectively gather the light dispersed in all directions to enhance its light intensity as well as assist plants in absorbing more light. Full Spectrum Plants Favorite Spectra: By the unique mix of spectra that makes most light in the 400-700nm waveband, incredibly conducive to plant photosynthesis. Adequate IR(730-740nm) is additionally consisted of in the range to generate larger buds. Dimming And Daisy Chain Feature Available: Upon an independent dimming button on the external driver, backing 0-100% settings adaptation and up to 30 LEDs daisy-chained in a group, it supplies different light levels for various plant stages meanwhile saving energy. Safety Certifications And Service Warranty: CE, ETL, RoHS, UKCA security certifications accepted, 50,000 hours durability, 5-year service warranty, and local after-sales repair 5x5 GROW TENT: LOCK ALL LIGHT INSIDE MARS HYDRO Indoor Grow Tent interior is made of diamond mylar which is highly reflective. (Other brand's mylar and reflective rate is as low as 50%, won't provide efficient light. )MARS HYDRO 1680D canvas, being double stitched, it is tear proof and has perfect light locking. Mars Hydro's grow tent keeps 100% lighting beams inside and helps your plant absorb more lights. EXTRA-THICK --No light leaks or rips at all DURABILITY GROW TENT Stable metal corner adapters and poles are the trustful supporters of the tent, standing sturdy, neither rusting nor paint-falling, quick easy tool-free installation. Mars Hydro's heavy-duty metal zippers, with double layer black lining, are the best on the market which create a light-proof seal EASY OBSERVATION FOR YOUR PLANTS. Special observation windows are made by double layers of cloth. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The observation window also serves to dissipate heat and ventilate air AUTOMATIC 6 INCH EXHAUST FAN KIT W/ CONTROLLER: Mars Hydro 6'' Inline Fan uses a mixed-flow design to maintain peak performance in a high static pressure environment. GROW TENT FAN: MARS HYDRO inline fans are designed to ventilate hydroponic grow rooms, transfer heating/cooling, cool AV closets, and exhaust odors. EFFECTIVE VENTILATION: Variable speed controller for easy fan speed adjustment. Optimal ventilation for your planting. LOW NOISE LEVEL: Durable plastic fan housing and blades for extremely low noise(32dB-A); create a truly quiet growth environment. EASY INSTALLATION: Removable duct ends with locking tabs for quick removal and easy maintenance and a cord length of 4.9 feet for hassle-free setup. This grows tent fan with a controller for easy fan speed adjustment. BASIC PARAMETERS: Ventilation exhaust fan size: 6” | Dimensions: 315mm*225mm*210mm. | Weight: 2.7. | Airflow: 402CFM | Noise: 32dB-A | Bearings: Dual Ball. 
Likes
3
Share
@Monketh
Follow
11 hrs of light. 9 weeks of flower fat nuggies up top
Likes
14
Share
i went on holiday and installed an automatic watering pump...seems like it didn't activate as planed...when i got back after 7 days the pots were compleatly dry... i removed alot of dead foliage from beneath...i would have removed it for better airflow soon anyways...so not much harm taken... after a big watering they looked fine again budgrowth didn't seem to be affected by the complete dryout...let's see where this goes...buds look perfectly fine so far
Likes
2
Share
Germinated 10/10 seeds in easy-plugs 1 male, 1 weakling - both discarded - going further with 8 viable plants Looking good 🍌🍊🍍 Can't wait to see them flowers 😎😁
Likes
39
Share
@Mastr
Follow
This week bud still fatten up due my fault witch is plant had nutrients lockout for 2 weeks so I'm 2 or 3 weeks on behind I think next week plants are stop fatten up 1 plant are very very huge buds and she is still flowering have lots white hair on her i think she ready in 2 or 3 weeks but other plant is about finish flowering I think she is ready in 10 days honestly orange sherbat for me too hard to grow but smell is incredible 😉
Likes
5
Share
Привет садоводы началась 2 неделя цветок потихоньку растет и крепнет 13 день растение немного обрыз пес по паре листьев с каждого куста , но вроде не критично
Likes
4
Share
Installed my new suplimental lights. 440 en 660 nm. Harvested the other 2. Hang them all up in tent. Aiming for low 60% humdity and around 19 - 20 C. No oscilating fans active, only 2 exhaust fans on low setting.
Likes
6
Share
another week of great growth check www.sr-organics.com for some topnotch 5 in 1 fertilizer! root, growth, bloom, micro-organisms, enzymes & vitamins all in one! CODE: "Unkraut10" for 10% Discount! 😊
Likes
1
Share
@mauigrown
Follow
As week 5 came to a close and we move into week 6 of flowering, I am having really high hopes for the end result. The buds started to get some light orange hairs which is really nice and they are really starting to thicken up! Towards the end of week 5 the plants started to show early signs of burn on their leaf tips, so I started the week 6 feeding a little early. In week 6 we bring the EC down quite a bit as we get into the late stages of flower. I also recently switch to measuring with EC vs PPM for ease and accuracy. Also at the end of week 5 I did a calibration on my coco for each plant as week 6 nutrients are much lighter. Coco Calibration Method 1. Mix up nutrients. 2. Water plants as normal and measure runoff. 3. If runoff EC is not at or close to the inflow EC a. Water more and keep measuring runoff until the runoff is at or close to the inflow EC 4. Do steps 1-3 for all plants (One at a time) Tips: - I use a shop vacuum that I stick the end in the bottom of the pot saucers and leave it on while I water so it sucks the runoff as soon as it drains out the pots. Then I measure, empty and water again until I hit my targets) For this calibration, I ended up using around 6 gallons of nutrient solution. Watering technique used is to measure runoff at every watering and make sure we are staying as close as possible to the inflow EC. It does not matter how much water you need to put through the pots to get to the desired EC on runoff as that is a benefit of Coco. My main goal is to keep my runoff in check and the plants seem to do better than I have ever grown before! The smell off these ladies are amazing and strong. I don't have a carbon filter and enjoy her smells and aromas all day long as my desk is right next to my tent. There were no issues in Week 5. Plants continue to look amazing and the buds are continuing to bud up and structure very nice! I'm excited to see the end result after the ripening and flush stages. Also the colors that are soon to come! Stay tuned! ______________ We are 5 days into week 6 and the buds continue to grow fatter and fatter on a daily basis. I'm really dialing in my EC and making sure to mix it at 1.1 EC and making sure my runoff is from 1.1-1.4. I started playing with the mix as I am getting used to the grow schedule and how the base nutrients effect the EC. I have found that doing 50% of the low strength calendar hits me right at my target EC and I don't have to dilute my mixture after. The smells continue to be strong and fill my house up. The weight is starting to make the colas lean over which is nice because it's opening up the canopy to get more light in. I'm very excited to see what the buds look like in week 7 and then we are on to ripening stage, flush, and then finally harvest!!
Likes
14
Share
@Quintall
Follow
Grow geht langsam richtung Ende. Leider zu kleine Töpfe benutzt aber was soll man sagen ist mein erster Grow
Likes
4
Share
@SamDo
Follow
🌱 Grow Diary – Week 11 Veg Week 11 of veg, and the plant is finally settling into a steady rhythm again. After last week’s defoliation and topping, she’s been taking her time to bounce back, and this week you can see clear signs of recovery. Growth is coming back with energy, not explosive, but steady and healthy. Right now, there are eight new apex sites forming nicely. I’m considering topping again, but that’s still undecided—I’d rather let her keep pushing forward for a while before making that call. For now, she’s cruising. The main focus this week is on stability. pH has been kept between 5.9 and 6, and that seems to be working well. Temperatures are holding steady at 22–23°C, with relative humidity around 70%. These conditions feel just right for recovery and steady growth heading into autumn. On the branch I taped after it cracked during training, the healing seems to be going fine. I haven’t fully checked under the tape yet, but from the look of things, it should be on track, and I’ll likely remove it next week. It’s a bit frustrating that we lost some valuable time in the early stages, but over the past few weeks the plant has definitely been getting back on track. The color looks healthy, growth is steady, and overall she’s moving in the right direction again. So, Week 11 is about patience, observation, and keeping everything dialed in. No big changes, just letting her recover and stack energy for what’s next.
Likes
11
Share
Week 3 has been great! We topped 2 Pre 98 Bubbas and 2 Dirty Blondes so far , 2 other Pre98 Bubbas will also get the topping but just gotta give them a few more days and they will be ready for it ! Once we have a little time of recovery, we will be topping all these ladies at least 2 or 3 more times so you all keep them eyes peeled! I hope you all enjoy an have an amazing productive week ! Peace love an positive vibes to all my Growmies out there Cheers 😶‍🌫️💨💨💨💨💨🤙🏻If there’s any questions, please ask I’ll be happy to answer ✌️🏻