Final 2 weeks the leaves start to fade on their own, today i stared feeding ripen The buds look weird but frosty The smell is insane

HEAVY 🌲 🍼Greenhouse Feeding BioGrow ⛺️MARSHYDRO The ⛺️ has a small door 🚪 on the sides which is useful for mid section groom room work. 🤩 ☀️ by VIPARSPECTRA (models: P2000 & XS 2000)

Shes very purple

Dear Diary Autos are looking good. Suffering from low RH and im doing all that I can, but winter is a bitch. Plants are healthy and femal, so all is good. These girls will start to rock as the natural RH picks up over the next few weeks xoxo, BudXs

We're halfway through flower, and the girls are trucking along without much help from me. This week's only exciting thing was making compost tea (worm castings, insect frass, kelp, rock dust, basalt, biochar, molasses, and LAB) for the girls (and to kickstart my new veggie soil.) The tent has more color changes, and considering that they are clones, it's fascinating to see the differences between each plant. DLI: 42 UV: 2,5 hours per day

Alles lief gut mit der Shaman bis zum jetzigen Zeitpunkt in der Blüte. Leider beginnt sich an einigen kleinen Stellen etwas Schimmel auszubilden, gar nicht in den Blüten, sondern an den Trieben. Das war mein eigener Fehler, da ich beim Entblättern einige Blätter letzte Woche nicht nach oben ziehend abgezwickt habe, sondern nach unten zur Erde hin gerichtet abgerissen habe. Dadurch habe ich an einigen Stellen das Gewebe am Trieb verletzt, wodurch sich dort Schimmel bilden kann und tut. Ich hoffe es wird sich in Grenzen halten. Es ist jedoch möglich, dass ich durch diesen Fehler zumindest einen der Haupttriebe verlieren kann. Wieder was gelernt. Gibt es irgendwelche Mittel, den Schimmel an den Trieben zu entfernen?Ansonsten bildet sie weiter ihre Buds aus, riecht schon sehr angenehm und entwickelt sich weiter. Es gab ein paar starke Winde und Böen in dieser Woche, dehalb wurde die Shaman vorsichtshalber gegen die Windrichtung angebunden, damit der Topf nicht kippt. Vielen Dank für euren Besuch und passt bei der Entlaubung auf...😫--- Everything was going well with the Shaman until now during flowering. Unfortunately, some mold is starting to form in a few small areas, not on the flowers themselves, but on the shoots. This was my own fault, as I didn't pull some leaves upwards when defoliating last week, but tore them off downwards towards the ground. This damaged the tissue on the shoot in some places, allowing mold to form and grow there. I hope it will be limited. However, it is possible that I may lose at least one of the main shoots as a result of this mistake. Another lesson learned. Is there any way to remove the mold from the shoots? Otherwise, it continues to form buds, smells very pleasant, and continues to develop. There were a few strong winds and gusts this week, so as a precaution, the Shaman was tied against the wind direction to prevent the pot from tipping over. Thank you very much for visiting, and be careful when defoliating...😫

looking very pretty in the tent indeed!! only one liberty haze plant in there but she is looking very plump already with a month or so to go. she gonna be a lovely lady indeed. continually defoiling the odd leaf here and there but overall a bit bushier than last run. not a whole lot to report back this week. fairly smooth sailing and not many changes except plumping up! so until next week my friends 😊

Fall is coming... After finishing stretch last week, the introduction of Hy-Pro Epic Bloom really got the bud production going. Mimosa stem is covered in trichomes, Blueberry is showing beautiful colors and Jack Herer is bulking. Everything is going as planned so far. Not that much to do at this point. Following my Hy-Pro nutrient scheme makes it just super easy, to turn those plants into the most beautiful ones, i ever grew. Just like last week, i fed them the following: Hy-Pro Terra: 4,5ml/l (component nutrients) Hy-Pro Generator: 0.16ml/l Hy-Pro Cal-mag: 4ml/l Hy-Pro Epic Bloom: 0,5ml/l EC: 1,8 VPD: 1,40 PPFD: 930 µmol/m²/s Blueberry and Mimosa Evo are showing some very characteristic colouring. I am very happy, to see this. Can't wait to see them in full colouration. It really is a Joy, to watch them change colours so rapidly, you can see differences every day. Pure plant entertainment. Stay tuned! Grow strong, Friends! 👽

DAY.54 👃🏿🔥🍦🍨🍧

I think she's suffering from some light burn from my LED's, take a look at the pics of the top bud sites. I completely rearranged my tent and got the LED on her side up as far as it can go. I hope that helps. The buds themselves look completely fine but the sugar leaves are turning dark purple and yellow. This is only happening on the upper most bud sites. Any other feedback suggestions are welcome. Please comment away.🙏 I got some Fox Farms Organic Big Bloom this week and added it with Recharge in this weeks feeding. Looking forward to seeing the results. Feb 5, 2018 update: Raised the LED light even more and removed most of the damaged leaves.

AMAZING WEEK! The environment is reading for flowering. Lighting, feeding, watering, air temp and CO2 are all stable and should give my plants a stress free life. Humidity is still high, so I'll need to come up with a plan for dealing with that ASAP. I've introduced CO2 into the grow with my brand new AirBomz unit. It uses a light sensor that releases CO2 when the lights turn on, and then uses a timer to release every 2hrs until the light switch off. I doubt I'll reach the 1200PPM stated by the manufacturer, mainly because I'm running an extraction, but I figure some is better than none. Cool controller also included. After doing some reading I can see there's two things that I need to look out for: A) Switching off the extraction so it doesn't suck away the precious CO2 before the plants have had a chance to absorb it B) Making sure the room doesn't get too hot whilst the extraction is off, causing heat stress My solution is: A) Switch off extraction for 15mins at the AirBomz 2hr interval B) Use the Temp Controller the switch off the circulation fan when temp exceeds 27C C) Controller then switches on the active intake when temp exceeds 28C D) Temp is held at 29C whilst the extraction is off D) Extraction turns back on after 15 mins, temp drops below 27C E) Temp controller switches off active intake... F) ...And switches on the circulation fan G) Repeats every 2hrs NEXT WEEK: Work out how much the girls are drinking! I'll know when I change the reservoir.

15.08.: Die zweite Blütewoche hat begonnen und beide Pflanzen haben sich seit der Umstellung gut entwickelt. Da ich vermute, dass die G41 noch weiter wachsen wird, habe ich ein zweites Netz zur späteren Stabilisierung installiert. Das zweite Netz hängt jetzt auf einer Höhe von 1,30m, sodass die oberen Spitzen der G41 bereits durchgucken. Damit die Pflanzen ihre Energie auf die wichtigen Bereiche konzentriert, habe ich bei beiden Pflanzen ein Lollipopping durchgeführt. Dabei hab ich alle Blätter, Seitentriebe und Blütenansätze unterhalb des ersten Netzes entfernt. Diese Blütenansätze liegen so weit unten, dass hier kaum Licht ankommt und sie am Ende stark unterentwickelt sein werden. Idealerweise hätte ich damit noch ein wenig gewartet, aber da ich die kommenden 9 Tage im Urlaub bin wollte ich es vorher noch erledigt haben, das gleiche gilt für das Netz. Updates werden in der Zeit auch eher schwierig, aber vielleicht bekomme ich ein paar Fotos zugeschickt. 18.08.: Ich habe Fotos zugeschickt bekommen. Anscheinend steckt die G41 immer noch in ihrer Stretchphase, da sie das 2. Netz auch schon ein gutes Stück überwachsen hat. 20.08.: Heute kamen nochmal ein kleines Video und ein Foto von der G41. Der Wachstum wird langsam weniger und man sieht, dass sich der Stretch dem Ende neigt. Am Ende der 2. Blütewoche hat die G41 die PBB in Sachen Höhe komplett abgehängt. So wie ich vermutet hab, war der Stretch von der PBB nicht mehr allzu dolle, sodass sie wesentlich kleiner als die G41 geblieben ist. Das ist eins der Probleme, wenn man kein Monocrop anbaut. Außerdem ist der Wasserbedarf der Pflanzen gesunken, sodass die Bewässerung aktuell 10min läuft, wenn das Licht angeht. Nächste Woche bin ich wieder zuhause, dann überlege ich mir, wie ich das Problem löse, entweder mit einer Zusatzbeleuchtung, einem 3. Netz mit dem ich die G41 noch etwas runterbiege oder beides. Da mein Mitbewohner heute vor Beginn von Blütewoche 3 ebenfalls wegfährt, hat er mir gestern noch die aktuellen Daten der Pflanzen zugeschickt. Daher passt es nicht ganz mit dem Diary, ich denke aber, dass es der beste Kompromiss ist.

Overall very impressed with Ethos line of plants, the Gorilla Glue from Barney's Farm i am not super impressed with, they said on website 63-70 days.

Her aroma is so sweet,all the 5 Black cherry punch have the exact same sweet and floral aroma,her flower are very sticky, she's producing quality resin,she ended up with a smaller size compared to her sisters. Let's see how she performs but I'm loving her so far

Will update with all the in

Day 57. Think returning to good pH finally works, they are damaged a lot, but all first wave and few in this managed to escape almost without harm. Funky colours plants are most pickiest and that was proven again ... I always screw up with them ;))) Last heavy feed of Biobizz and only water. Max 3 weeks till chop and it doesn't matter if some won't be ready. My time to leave has come ... One Strawberry is making my heart sing, I knew SB will be special. I highly recommend her without even smoking ... Added few more photos to prove it. It's a big can and I am tall men, so this cola is NUTS ;) 9 week plant, I will chop her this Tuesday I think .... I have now 1400W in the grow room. Mars Hydro SP150 and SP3000 are in the game too. Hope it will rush girls a bit 😉😉😉😉😉😉 Those two totally frozen, white stem , almost dead girls - RECOVERED !!! Weed is insanely resilient plant. I know that it will be 5-10 g max, but still ... All branches white from frost, I saw such colours only when bud rot was eating them, those btw most probably doomed here too ... Happy Growing !!!

20/02: The plants are overall reacting well to the larger dose of nutrients especially the ignitor - there are lots of bud sites throughout. I was under watering some plants which has resulting in wilting stems and leaves - will move onto 1 litre of water every other day from next week. 1 OG kush and 1 White Widow is lagging behind but we'll get there. Good strong stalks mostly for all the plants. Gave the a hefty defoliation this week also trimming the fan leaves and letting light penetrate the lower branches and bud sites.

NORTHERN THUNDERFUCK AUTO / RQS HARVEST WEEK This lady produces some big dense heavy beautiful 😍 trichome covered buds she's really produces quality flower with a great relaxing smoke! Thank you for stopping by and taking a look during the grow much appreciated!! Thank you ROYAL QUEEN SEEDS!! RQS / NORTHERN THUNDERFUCK AUTO

Vamos familia actualizamos la cosecha de las Purple OG KUSH de Dutchfem . La verdad que el secado muy bien 7 días en Malla y a los botes, 40% humedad y 24 grados es la temperatura ambiental que han tenido en el secado. Por lo demás de miedo os la recomiendo. Gracias a DutchFem, Agrobeta y Mars hydro , sin ellos este proyecto no sería igual 🙏. Agrobeta: https://www.agrobeta.com/agrobetatiendaonline/36-abonos-canamo Mars hydro: Code discount: EL420 https://www.mars-hydro.com/ Buenos humos.

Went away for a week but no massive problems and she's oretty resilient so happy days! Few more weeks hoping for a bit more bulk in the buds.!