This week I planted them in their final 11L pots! For the feeding I feed after the chart from advanced nutrients „Master Grower for COCO“

Blazing hot week spent mostly trimming/harvesting. Even broke a pair of scissors :) Smooth trim from start to finish - plants were flushed in the last week

Plant was chugging in the last couple days as seen in raising EC and lowering PH but I found a single bud with mold in it so I removed it and and harvested on day 76 from sprout. One of the reasons I prefer longer stretched plants compared to small stubby ones is the bud size, they were grown so much in to one another that air flow was very restricted. Values are average of the day. DATE - EC(µS/cm) 20250503 2002 20250504 2004 20250505 2062 20250506 2098 20250507 2149 20250508 2198 DATE - PH 20250503 5.59 20250504 5.71 20250505 5.65 20250506 5.57 20250507 5.49 20250508 5.42 DATE - ORP (mV) 20250503 104 20250504 90 20250505 75 20250506 70 20250507 68 20250508 67 DATE - °C - RH% (Tent Temp/RH) 20250503 24.2 53 20250504 22.6 55 20250505 22.2 56 20250506 22.6 57 20250507 22.3 55 20250508 22.1 52 DATE - °C (Reservoir) 20250503 22.2 20250504 20.8 20250505 20.0 20250506 20.4 20250507 20.3 20250508 20.0 DATE - CF 20250503 20.05 20250504 20.07 20250505 20.67 20250506 21.01 20250507 21.53 20250508 22.01

Day 30 Wed PH 5.7 EC 0.6 DLI 18h PPFD Water 24c Day 31 Thu Add Ph Up PH 5.3 - 5.9 EC 0.6 DLI 18h PPFD Water 21 Day 32 Fri Add water Ph Up PH 5.5 - 5.7 EC 0.6. - 0.6 DLI 18h PPFD Water 22c

La canopée est couverte a 90%

Questa settimana ho notato un piccolo stress alle foglie della cima centrale (questo stress credo sia dovuto alle temperature elevate )

Grow Sponsored by MARSHYDRO HIGH EFFICIENCY WHITE LED LIGHT: Newest SMD LED technology provide highest PAR/LUMEN output(743umol@18"), designed to replace a single-ended 250watt HPS; MARS HYDRO TS 1000W Plants Growing lamp makes you get 30% higher yield compare OLD blurple led lights, Max 2.0g yield per wattage (power draw) LOW ENERGY CONSUMPTION GROW LIGHTING : Consuming only 150W with 342 LEDS! It saves up to 50% energy than other led grow lights. Perfect for 2.5x2.5ft,Max coverage 3x3ft. Over 90% light energy can be absorbed by plants; higher intensity and more even coverage in a MARS HYDRO grow tent, reflective area, or by crossing over using multiple TS1000 SUNLIKE FULL SPECTRUM LED INDOOR GROWING: 660-665nm Red IR/3200-4200Knm/5200-6800Knm, infinite close to natural light, best for all plants all stages growing, rapid plant response from seed to flower and increase yield & crop quality‎ HIGH REFLECTIVE & NOISE FREE-Fanless LED GROW SYSTEM design will make your growing life easy and quiet, quickly heat dispersing material aluminum reducing light lost to aisles and walls, increase the light intensity up to 20%, allowing your plants receive more energy and without burning your plants for maximum headroom Get your own at https://www.amazon.de/dp/B07ZVFBR34

D67 removed ScrOG and repeated LST on left plant so lower buds will get more light. There is not enough space in tent to do the same with the right plant.

The Auto AK is loving life, handling a slightly over eager first time grower well! The West Coast OG is a little behind, seems a bit more sensitive to pH imbalance and has also suffered from a touch of nute burn 😕 rookie error! Did feed both with some seaweed and 6.0-6.5 pH water. They can't grow quick enough 😂

Hello growmies! Welcome to week six of An Epsilon Adventure! Massive thanks to both Shogun and Royal Queen Seeds for sponsoring this grow! So here we are at week six and every one of these girls are at a slightly different stage, it is quite fascinating to watch them develop one after the other. Today I made the last adjustment to the light possible. I removed the adjustable hangers and affixed a carabiner which I tightly tied to the top of the tent bar. There is about 1.5 inches of space between the top of the shade and the tallest part of the roof of the tent. Plant 1 is already taller than this, and it looks like plant 6 and maybe even plant 5 are going to join it. It's a madness. I am sure you have already looked at the photos but just in case you do what I do and read the diary first... Here is my assessment at the beginning of week 6: Plant 1: Height: 1st (137cm) - what can I say about this ridiculous plant? Day 36... 137cm tall. I have had to raise the light to as high as it is physically possibly to raise it and it's still not high enough. She is done stretching now, she may add 3-5cm over the next week or so but I don't expect more than that, so her top of her main cola going to have to develop above the level of the light. Nothing I can really do, nothing wise anyway. What a monster plant. Maturation: 4th - early into flower - bud sites developing, pistils just starting to explode. Plant 2: Height: 4th (111cm) - this plant has been there or there abouts as the tallest plant for most of the grow, but she has topped out at 111cm. She will gain some during flower but not much more than a few centimetres. Very impressive plant, loads of bud sites, really big strong secondary branches. This one is going to be colas galore. Maturation: 3rd - well into flower - all white pistils Plant 3: Height: 6th (95cm) For some brief days the tallest plant in the room, she peaked early and is now the "shortest" at "only" 95cm for this "50-70cm" strain. She is utterly dwarfed by four of her five sisters in just about every department, being quite a bit smaller even than plant 4 (although I have removed the most lower nodes from this plant). Compared with her sisters she is almost a runt... except that she is 25cm taller than the strain top-end average and matches the maximal height of the previous tallest Epsilon F1 plant I am aware of. It's not that she is small, actually she's pretty big for an Epsilon F1, it's just that the rest of the girls are on another level altogether. Plants 1, 5 and 6 are all absolute beasts. Maturation: 1st - well into flower - first shades of brown in some pistils. Plant 4: Height: 5th (98cm) although only 3cm taller than plant 3, overall she is a much larger plant. Her secondary nodes are the same height as plant 3. Maturation: 2nd - well into flower - all white pistils Plant 5: Height: 3rd (113cm) - one of the two thick/short girls who have grown at a similar pace all along - she is further ahead than plant 6 but not by much and I think she will probably exceed 120cm this week, though I do not think she will outgrow plant 1 or 6. Maturation: 5th - early into flower - bud sites developing. Plant 6: Height: 2nd (120cm) - my predictions were correct about this girl and her continued growth. I now think she might actually outgrow plant 1, which is quite worrying. Maturation: 6th - early into flower - bud sites forming - by far the least mature plant of the six. ### Week 6 Day 2 23:00 30/7 Photographed. Raised the light. Rotated the plants. Inspected, measured and reported on each plant. ### Week 6 Day 3 23:00 31/7 It has not escaped my attention that the plants that are more advanced into flower have darkened and have some burnt tips. I need to flush them and lay off the base nutes a bit. These plants are just growing and maturing so quickly that I cannot keep up. ### Week 6 Day 5 02:30 2/8 Fertigated 3l of nutrient mix, without either COCO A or B. ### Week 6 Day 6 01:30 3/8 photographed --- Thanks for reading growmies! 👊 ========== Tent: 120cm x 120cm x 180cm Light: 600w HID Elite Dual Spectrum HPS + Angel Wing Reflector Air: 5" duct fan system with carbon filter ~300 m3/hour + RAM 9" floor fan + 4" intake fan Pots: Air Pruner Fabric Pots 30l - UGro XL Coco + horticultural grade perlite (~20%) Seeds supplied by Royal Queen Seeds https://www.royalqueenseeds.com Nutrients supplied by Shogun Fertilisers https://www.shogunfertilisers.com/en ==========

SPEEDY BOOM AUTO by KANNABIA Week #13 Overall Week #7 Flower She's just about done the heat started to get to her towards the end of the week it was extremely hot this ☀️ summer and she still managed to flower in the heat!! Stay Growing!! Kannabia.com SPEEDY BOOM AUTO

Day 18 Transplanted today the plants into their 11L pots.😊 While instead i will let the Lemon Tree grow for another 4/5 days in the same pot because she only got 13 days, so I prefer to have it strengthened a little before the transplant. Day 24 Mimosa, Meringue, and Kmintz were Topped, Defoliated and also applied a light LST to the main stems of the plants. I will do the same for the Lemon Tree in the next 2/3 days.. I hope they have a quick recovery 🤞🏻 Day 27 LST also performed on the side branches of all plants except the Kmintz which is too small to bend its branches. Also Today we got 21 days for the Lemon Tree which has a great shape! Carried out topping, LST and a little defoliation.. 🙌🏻 In the next few days I will let them grow them without further stress. Have a great weekend gromies!! ☮️💚

I really enjoyed growing this strain. I hope I can get my hands on it again and take what I've learned and apply it. I didnt have any herm's or anything of the sort. I think Ethos really makes some great genetics. This stuff gets me really good. If i had prevented stretching's, and trained a little bit, I probably could have gotten a half pound out of here. Regardless 5.5 ounces is respectable for a 2nd grow if you ask me. Curing turned out very well. My whole place stinks when I burp these jars. Im OBSESSED with this Rosin. Best smelling and best tasting dabs I've ever had so far. Hope you all enjoyed this diary. I really loved sharing how this strain came out. I hope it comes out even better for all of you guys! We'll see where the future takes me!

Sie wächst gut habe sie heute getoppt Werde sie Ende nächster Woche auf 12 12 umstellen

🔥

💩Holy Crap Growmies We Are Back💩 Well after another short break we are back at it 😁 So what do you say we have some fun 👈 We got us the Strawberry Pie from FASTBUDS 😛 Seed soaked for 24 then placed in a tub with paper towels , once it cracked and rooted , placed into its main pot 👌 Lights being readjusted and chart updated .........👍rain water to be used entire growth👈 👉I used NutriNPK for nutrients for my grows and welcome anyone to give them a try .👈 👉 www.nutrinpk.com 👈 NutriNPK Cal MAG 14-0-14 NutriNPK Grow 28-14-14 NutriNPK Bloom 8-20-30 NutriNPK Bloom Booster 0-52-34 I GOT MULTIPLE DIARIES ON THE GO 😱 please check them out 😎 👉THANKS FOR TAKING THE TIME TO GO OVER MY DIARIES 👈

These fast buds strains impress everytime I'm happy to be growing another blackberry I love this strains smell and taste .. The plant is 100% organic and she lives her nutes and is just chugging along so nicely .. can't wait for next week to see some of that purple coming through her it's time now . Cheers canna family

On day 1 I adjusted the PH of my reservoir down to 6.1. On day 2 I adjusted the PH of the reservoir from 6.3 to 6.1. On day 3 the buds are really starting to bulk up and are putting out side flower clusters already in week 5. I adjusted the PH to 6.1. The goal is to coast from 6.1-6.3 then back to 6.1-6.3 ect. On day 4 things look good I scoped out the trichs and found some to be filing up with cannabinoids :) maybe she will be done in 7-8 weeks like the breeder says. On day 5 my reservoir temp got into the 80's because when the reservoir gets depleted it lowers the water level below the thermostat and I'm getting into the colder months so the cold air temperatures are causing the heater to heat when not needed. My temporary fix is to place the heater diagonally when the water level gets low and then when the water level drops a little more I will fill my reservoir back up fully so to keep the heaters thermostat running correctly. On day 6 I did another defoliation to improve light penetration and airflow in the canopy. I installed a new "Nano aquarium heater" this will be able to heat my reservoir without being affected by the water level in my reservoir. I also changed out my reservoir and adjusted the PH to 6.1. On day 7 the girls are looking and smelling great! I adjusted my reservoirs PH from 6.6 to 6.1. My Nano aquarium heater seems to do the job nothing out of the ordinary that I could tell after a night in the low 30's.