First grow ever Royal Gorilla Auto

This is my first time ever trying to grow cannabis so please forgive me if I break any unwritten rules, and any help is greatly appreciated. So, I planted the seed directly in the medium on 11th of august at 11 am. Then for the next few days i kept looking after it. Since I don't have a humidifier yet, I tried to increase the humidity by hanging wet towels near the air-intake and by covering the pot with plastic. I used tap water that was left uncovered for at least 24h and tried to keep the PH near 6. As of 14th of august, the plant has already sprouted and made it's way out of the soil. As you can see in the picture, the tip of the plant is bent, I am suspecting it could've been because of the plastic film over the pot. I am hoping this "stress" would not affect her too much. :( I removed the plastic film and instead cut out the bottom of a plastic bottle and put it over the sprouted seedling. I am planning to keep it on until I see some leaves or get a humidifier. 3-4 hours later : Now I have added a humidifier that can bring up RH. Originally I wanted to put it inside the tent but there is not enough space. So, I have put it outside near the air-intake vent. I have also removed the plastic bottle from over the plant since now the whole tent has enough humidity. 16/8/21 I have added more soil at the bottom of the pot and have also lowered the light. The plant is a bit stretchy with 2.7 inch height. I'm assuming it's because my light is too weak(at only 30 actual watts from the wall). 17/8/21 seems like lowering the light has helped because in the last 24 hours, she hasn't got any taller but the leaves have grown a little more. 18/8/21 So I had checked her in the morning but in the afternoon I saw her leaning at like a 60 degrees angle. There was no bend in the stem and the pivot seemed to be at the roots. The culprit, in my opinion, was the loose soil and strong airflow from the air-intake. This combination made her shake from left to right and was kind of plucking her from the ground. I reinforced the loose soil and compacted it a little, plus i also added a small amount of dry soil on top to support the stem and to straighten her. The wire around her is actually not supporting her, it's just preventative in case she starts leaning over again. Fingers crossed. 18/8/21 11 pm The light accidentally fell over her, laid her flat on the soil and also folded the stem right below the first and only set of leaves. It was looking really bad, her head went completely limp just hanging by few fibers. I immediately stood her up and put some dry soil at the bottom of the stem to kinda reinforce her to stand straight again. Then I took some wire and supported the limp "head" with it. You can see the question picture. 20/8/21 She has made a miraculous recovery in just 36 hours. I have removed the crutches and she is standing on her own. However there is a bend right below the leaves where the stem had broken. At this point I am just grateful that she has made a speedy recovery and because this is my first grow ever, I don't even really care how this accident would affect the final yield. I just want to bring her to conclusion and give her a full life cycle. (You can see in the picture the point where the stem had folded over because even after recovery she is left with a bent head) I am also working on a monitoring setup. So far I have managed to put in a DHT22 sensor that tracks temperature and humidity, and also a camera. I am using a Raspberry Pi 3B to interact with the sensors. I have not developed a GUI yet so that's why in the screenshot you only see the sensor readings on the webpage and nothing else.