Nanna Glue

mittenterps I am using drip nutrients feed line feeding around 700 PPM or 5ml/gallon of water. I use A, B, and Cal Mag from Drip Hydro. This run consists of 10 Nana Glue clones sourced from @smurphsauce aka Quest of Terps bred by Square One Genetics. I am growing inside of a 10x10 grow room. Lights are set to 25%. My equipment consists of a PULSE grow meter, 240V Titan Controller, Quest 110 dehumidifier, 4 Growers Choice ROI 720's, 4 Hurricane 20" fans, 8" exhaust and carbon filter hooked up to a Blue Labs humidistat, portable Pelonis 12000 BTU air conditioner and Mainstays oil filled radiant heater connected to a Blue Labs temperature meter, Mondi 1585X sump pump connected to a garden hose for hand watering, blue labs PH pen, blue labs PPM/EC pen, 10 fabric pots, 10 plastic plant saucers, and 10 plastic plant risers, and plastic trellis netting for plant support. After receiving the clones I transplanted them into 3 gallon quick fill coco coir blocks. 8 days after I transplanted I topped and took clones.

mittenterps A few weeks have past and I transplanted the 10 Nana Glue into 10 gallon fabric pots. When transplanting I used roughly 10 gallons of medium per pot. The plants were already in 3 gallons of medium. This makes the total volume of medium being used 13 gallons. I am currently watering the 10 plants using roughly 25 gallons of water or roughly 2.5 gallons per plant. I am getting roughly .5-1 gallon of run off per plant which I vacuum up using a shop vacuum. I changed the light cycle to 18 hours on 6 hours off to prepare for the transition to flower. Added trellis netting and began to weave branches for optimal coverage. I am feeding at 10ml/gal of Base A+B and 5ml/gal of Cal Mag. Lights are set at 50%. I noticed that the plants became much happier with the increase in feeding. I am preparing for the flip to flower and plan on doing that in the next few days. I experienced a light pest pressure. I normally spray once per 1 week with Mammoth Canncontrol and Lost Coast Plant therapy alternating each week. I noticed pressure from thrips so I increased the spray regimen. Over the course of three days I sprayed Mammoth, Lost Coast, then Mammoth again. Once flower starts I no longer spray anything on the plants. My equipment consists of a PULSE grow meter, 240V Titan Controller, Quest 110 dehumidifier, 4 Growers Choice ROI 720's, 4 Hurricane 20" fans, 8" exhaust and carbon filter hooked up to a Blue Labs humidistat, portable Pelonis 12000 BTU air conditioner and Mainstays oil filled radiant heater connected to a Blue Labs temperature meter, Mondi 1585X sump pump connected to a garden hose for hand watering, blue labs PH pen, blue labs PPM/EC pen, 10 fabric pots, 10 plastic plant saucers, and 10 plastic plant risers, and plastic trellis netting for plant support.

mittenterps 24 hours after flipping to flower I defoliated and removed lower branches. Day 1 of flower. I am feeding at 10ml/gal Base A 12ml/gal of Base B and 2ml/gal of Cal Mag. I noticed this week I had my PH closer to 5.8-5.9 than 6.0-6.2. I am happy anywhere around 5.8-6.2. I shoot for around 68-70 degrees for my water temperature. I tried getting a water wand for watering instead of just using the hose to get a little more air into the pots when I water, but the head clogged almost immediately from the nutrient feed. Plants are looking lush and vigorous with little to no issues. Plant main stems are all green with almost no presence of purpling on any of the stems. Canopy is looking nicely filled over the next week I will tuck where needed to fill in open spaces. I adjusted the fans so that they were not blowing on the plants as much to avoid causing any stress. Lights are at 75%. My equipment consists of a PULSE grow meter, 240V Titan Controller, Quest 110 dehumidifier, 4 Growers Choice ROI 720's, 4 Hurricane 20" fans, 8" exhaust and carbon filter hooked up to a Blue Labs humidistat, portable Pelonis 12000 BTU air conditioner and Mainstays oil filled radiant heater connected to a Blue Labs temperature meter, Mondi 1585X sump pump connected to a garden hose for hand watering, blue labs PH pen, blue labs PPM/EC pen, 10 fabric pots, 10 plastic plant saucers, and 10 plastic plant risers, and plastic trellis netting for plant support.

mittenterps The plants have recovered nicely from defoliation and have filled the canopy in nicely and are beginning to stretch. I will need to defoliate again by week 4. Day 7 of flower. Plants are really enjoying the increased feed and have taken the flip to flower well. I have been hand watering and haven't missed any days so far. Plants look great. I am feeding at 10ml/gal Base A 12ml/gal of Base B and 2ml/gal of Cal Mag. I have not seen any signs of salt build up with the plants. I have been feeding daily without any flush days. The plants are loving it and thriving. I have a feeling that this will be a great run if things keep going at this pace. Lights are set to 100%. My equipment consists of a PULSE grow meter, 240V Titan Controller, Quest 110 dehumidifier, 4 Growers Choice ROI 720's, 4 Hurricane 20" fans, 8" exhaust and carbon filter hooked up to a Blue Labs humidistat, portable Pelonis 12000 BTU air conditioner and Mainstays oil filled radiant heater connected to a Blue Labs temperature meter, Mondi 1585X sump pump connected to a garden hose for hand watering, blue labs PH pen, blue labs PPM/EC pen, 10 fabric pots, 10 plastic plant saucers, and 10 plastic plant risers, and plastic trellis netting for plant support.

mittenterps Week 3 of flower has just begun and pistols are starting to form. I am very happy with node spacing and plant size. I am confident that this harvest will be one of the better runs I have had in this room if kept at this pace. Day 14 of flower. I am feeding at 10ml/gal Base A 12ml/gal of Base B and 2ml/gal of Cal Mag. I plan on defoliating again during week 4. Lights are set to 100%. My equipment consists of a PULSE grow meter, 240V Titan Controller, Quest 110 dehumidifier, 4 Growers Choice ROI 720's, 4 Hurricane 20" fans, 8" exhaust and carbon filter hooked up to a Blue Labs humidistat, portable Pelonis 12000 BTU air conditioner and Mainstays oil filled radiant heater connected to a Blue Labs temperature meter, Mondi 1585X sump pump connected to a garden hose for hand watering, blue labs PH pen, blue labs PPM/EC pen, 10 fabric pots, 10 plastic plant saucers, and 10 plastic plant risers, and plastic trellis netting for plant support.

mittenterps Salt boy strip! Defoliated every leaf that I could reasonably get, spent about 6-8 hours in the room removing leaves before calling it quits. The plants will benefit from added airflow and remaining lower nugs will benefit from increased light penetration. Pistols are starting to get much bigger and will really start packing on weight! Day 21 of flower. I am feeding at 10ml/gal Base A 12ml/gal of Base B and 2ml/gal of Cal Mag. Lights are set to 100%. My equipment consists of a PULSE grow meter, 240V Titan Controller, Quest 110 dehumidifier, 4 Growers Choice ROI 720's, 4 Hurricane 20" fans, 8" exhaust and carbon filter hooked up to a Blue Labs humidistat, portable Pelonis 12000 BTU air conditioner and Mainstays oil filled radiant heater connected to a Blue Labs temperature meter, Mondi 1585X sump pump connected to a garden hose for hand watering, blue labs PH pen, blue labs PPM/EC pen, 10 fabric pots, 10 plastic plant saucers, and 10 plastic plant risers, and plastic trellis netting for plant support.

mittenterps Bounced back from the leaf strip last week very nicely. Plants are starting to put on a good amount of weight and the buds are developing nicely. Today is day 30 of flower. I'm really looking forward to seeing what yield numbers are like on these girls, the room looks heavy. I did a good job this run of filling the canopy space nicely. I am feeding at 8ml/gal Base A 10ml/gal of Base B and 0ml/gal of Cal Mag. Lights are set to 100%. My equipment consists of a PULSE grow meter, 240V Titan Controller, Quest 110 dehumidifier, 4 Growers Choice ROI 720's, 4 Hurricane 20" fans, 8" exhaust and carbon filter hooked up to a Blue Labs humidistat, portable Pelonis 12000 BTU air conditioner and Mainstays oil filled radiant heater connected to a Blue Labs temperature meter, Mondi 1585X sump pump connected to a garden hose for hand watering, blue labs PH pen, blue labs PPM/EC pen, 10 fabric pots, 10 plastic plant saucers, and 10 plastic plant risers, and plastic trellis netting for plant support.

mittenterps Plants looked great. (I hadn't uploaded these 2 years ago, so I went back and uploaded them. It was only right.)

mittenterps Plants looked great. (I hadn't uploaded these 2 years ago, so I went back and uploaded them. It was only right.)

mittenterps Plants looked great. (I hadn't uploaded these 2 years ago, so I went back and uploaded them. It was only right.)

mittenterps Harvest. (I hadn't uploaded these 2 years ago, so I went back and uploaded them. It was only right.)

mittenterps All for Hash Rosin, would recommend Nana Glue to anyone. We took this Nana Glue mother and bred it with Tropic Truffle the following season and then again the season after that with Banana Shack. Needless to say, it's been a rosin-producing staple in my garden.