Gorilla Cookies Auto x Fast Buds

xTaps 26.05 While one run is still in full bloom, the next grow is already knocking – so here we go again. Plan: Germination will take place in a glass of water. Once cracked, the seed will be placed into an Eazy Plug, which is already sitting in the final 19L fabric pot. She'll veg for about 5 weeks in a 40×40×120 cm tent under a Sansi BR30 36W LED, while the main bloom tent is still occupied. After that, she'll move into the 70×70×160 cm tent under the Mars Hydro FC 1500 Evo 150W LED. Setup: 40×40×120 cm tent by Melko for Vegetation 70×70×160 cm tent by Mars Hydro for Flower Sansi BR30 36W LED @ 24/0 light cycle Mars Hydro FC 1500 Evo 150W LED @ 18/6 light cycle Mars Hydro 4-Inch exhaust system with app control Circulation fans: Mars Hydro & Taifun Mars Hydro 25×52 cm seedling heat mat with digital thermostat Nutrients: Organic: Biocanna Rhizotonic Biocanna Bio Vega Biocanna Bio Flores Biocanna Bio Boost Mineral: Terra Aquatica Calcium Magnesium Supplement Canna PK 13/14 The heat mat is set to 24 °C for germination. The water glass with the seed is currently sitting in the propagator. 27.05 Barely 24 hours later: the first white dot of the taproot is visible, the seed is still floating on the surface, a quick nudge was enough to make it sink. 28.05. 48 hours later, it's almost time. 30.05 96 hours after the start of germination, the seed was placed into an Eazyplug. For preparation, 100 ml of water were mixed with 0.1 ml of Biocanna Rhizotonic. The plug was briefly soaked in this solution (using a shot glass) until fully saturated, then gently squeezed to remove excess moisture. The remaining Rhizo mix was used to pre-moisten the surrounding soil in the final pot. The heat mat was set to 25 °C. The LED light was positioned near its highest point to provide gentle warmth and light for early development. 01.06 She needed a little bit help but did it. Welcome on earth, little seedling.