One order of Chicken n' Wafflez plz...

MemesTV All the nutrients are diluted down to 0.6 ish EC Target EC: 0.6 - 0.8 added in this order: CalMag → EC 0.4 Coco A: ~1.0 ml/L Coco B: ~1.0 ml/L Rhizotonic: 2 ml/L Cannazym: 1.5 ml/L Diluted with water back down to 0.6–0.8 EC pH 5.8–6.0

MemesTV PPFD: 200-250 Plant was looking okay, but decided to transplant it to the 70% coco / 30% perlite.. Was not getting enough dry back, roots looked fine when transplanting but figured might as well move her to the final pot before it gets more complicating. Feed: CalMag → EC 0.4 Coco A: ~1.2 ml/L Coco B: ~1.2 ml/L Rhizotonic: 2 ml/L Cannazym: 1.5 ml/L Diluted with water back down to 0.8–0.9 EC pH 5.8–6.0 At this point I started looking at Autopot, and decided to pull the trigger and get a reservoir and Autopot XL system ordered..

MemesTV PPFD: 300 ish Decided to increase the feed, and nutrients since diluting a lot was causing a bit of issues, mild ones at least.. Target EC: 1.1 CalMag → EC 0.4 Coco A: ~1.5 ml/L Coco B: ~1.5 ml/L Rhizotonic: 3 ml/L Cannazym: 2 ml/L Diluted if needed 1–1.1 EC pH 5.8–6.0

MemesTV PPFD str: 500-600 ish Increased the feed to full Canna recommendation, equipped the autopot XL sadly found out that the 5 gallon ac infinity fabric pots dont fit it properly.. So i had to find a round base that can hold it up while adding close to 10 wicks to let the feed reach the pot.. (seems to likes it though) - a few noteworthy notes.. Since using a reservoir now I completely removed CANNA RHIZOTONIC - as it would make the room smell quite bad after a few days.. Instead 1-2x a week i top feed a bit of it (not until run off around 400-600 ml) at 5.8 ph and 2ml / L Added a AC infinity moisture meter, its quite useful to see if the auto pot is working as intended.. Honestly I had a issue with over watering and now I rarely need to do much, the reservoir gets checked daily for PH readings and at times need to bring it down from 6.1 ph back down to 5.7-5.8 Gonna keep it in veg for a bit longer as my tent is quite tall, so i want to push it a bit more, keeping the light close by to keep it compact for now.

MemesTV PPFD str: ~600–650 I decided to experiment a bit this week by increasing the feed quite a bit (my normal feed is around 1.65 EC). I made a new batch and measured the EC at around 1.95 mS/cm. I decided to just send it and add it to the reservoir… well, note to future self: don’t do that again. After a few days of increasing, I ran into a bit of tip burn. Following that, today I moved the plant to a different base and top-fed some deionized water + CalMag at 0.4 EC, followed by a much calmer solution at 1.65 EC to relax things and flush the coco a bit. While waiting for runoff to stop after top-feeding, I had a chance to clean the base of the AutoPot as well as the reservoir. Once everything was clean and tidy, I put the plant back on the AutoPot + custom wick system. I dialed down the hotter feed that caused the tip burn and ended up with this, targeting ~1.75 EC: CalMag → EC 0.4 Coco A: ~2.5 ml/L Coco B: ~2.5 ml/L Cannazym: ~2.5 ml/L Canna Boost: ~2.5 ml/L This read around 1.85 EC, then I diluted it down to 1.75 EC. pH: 5.5–5.6 (apparently AutoPot recommends 5.5 pH in the reservoir for coco, which I didn’t know—I read about it yesterday, so I’ll be trying this.) Anyways, today marks the last day of veg for me. Tomorrow I’ll be flipping the light to 12/12. I’d love to keep the plant in veg longer, but honestly my tent is already filling out a lot, and I’m nervous the plant might stretch too much and cause issues later on. Ideally it would’ve been cool to do one more week of veg, but we’ll see how it goes. Since this is my 2nd grow ever honestly don't want to push it too much as i already know I might run into issues with tent size..

MemesTV PFD str: 700–750 (the fan is kind of blocking it a bit trying to figure out what I can do) Well… she’s exploding. I’d love to have more room in the tent for her to spread out a bit more, but it is what it is. Apart from the first week of stretch after the flip, there haven’t been any issues or anything worth pointing out. As far as maintenance goes, I trimmed a few leaves that were touching the heat pad since they dried up. I’m debating putting something between the leaves and the heat pad, but for now I’m just waiting until day 21 after the flip to lollipop and defoliate. Feed: Rhino Skin: 1.7 ml/L CalMag → EC 0.4 Coco A: ~2.5 ml/L Coco B: ~2.5 ml/L Cannazym: ~2.5 ml/L Canna Boost: ~2.5 ml/L This read around 1.85 EC, so I just left it as is. pH: 5.5 in the reservoir.

MemesTV PPFD str: 700–800 (I moved the light higher, but increased the power to 9/10) I kept everything pretty much the same this week. Not much has changed apart from the plant stretching even more. I still have a bit of height left in the tent, which is fine. I did a very minimal defoliation - just enough to let some light reach the lower nodes. Feed: Rhino Skin: 1.7 ml/L CalMag → EC 0.4 Coco A: ~2.5 ml/L Coco B: ~2.5 ml/L Cannazym: ~2.5 ml/L Canna Boost: ~2.5 ml/L This read around 1.85 EC, so I just left it as is. pH: 5.5 in the reservoir.

MemesTV I Really did not expect this plant to stretch this much since flipping to flower (that extra week of veg I gave it was really a mistake on my end). I was forced to do a emergency defoliation and install a scuffed trellis net.. Not even sure if it helped but at this point I'm just gonna let it do its thing, cant mess with it anymore. I am left with zero space for the light so lets see what happens... lesson learned though! Feed stayed the same but diluted it down to 1.75 ec, ph stayed the same PPFD: lowered to 600-750 as the light was cooking a lot of my leaves..

MemesTV Honestly, I haven’t touched the environment or even the light strength since the last time the plant got stressed from being too close to the light. I believe it’s at 50–60% power. Other than that, I introduced PK 13/14 this week, but only at about 1 ml/L instead of 1.5 ml/L (as shown on the feed chart). Feed: Rhino Skin: 1.7 ml/L CalMag → EC 0.4 Coco A: ~2.5 ml/L Coco B: ~2.5 ml/L Cannazym: ~2.5 ml/L Canna Boost: ~2.5 ml/L Canna PK 13/14 ~ 1 ml/L The EC was 2.04, so I diluted the mix down to 1.90–1.95 (I was nervous because last time I was close to 2.0, the plant got tip burn). This week, though, I’m noticing the new growth looks quite good, so I might experiment with 2.0+ next week. Since it’s my second ever grow, and my first time using an AutoPot, I’ve been aiming for a lighter feed and just watching how the plant reacts. The only main issue has been the height and how close we are to the light & space, but aside from that it’s been a really enjoyable run.

MemesTV Week by week, the terps are starting to smell better and better. I decided to run PK 13/14 for a few more days. I’ll be switching to Overdrive soon, but it still feels a bit early. Other than that, not much has changed. I brought the humidity down a bit and removed some older leaves that were damaged when I cranked the light too high. This week I also decided to get rid of a lot of the bud growth below the trellis, since I don’t think the light is sufficient for them to amount to much. Apart from that, the feed stayed pretty much the same: Rhino Skin: 1.7 ml/L CalMag → EC 0.35 Coco A: ~2.5 ml/L Coco B: ~2.5 ml/L Cannazym: ~2.5 ml/L Canna Boost: ~2.5 ml/L Canna PK 13/14: ~1.3 ml/L I diluted it down to 2.04 EC (it was around 2.15 EC).

MemesTV This week was a bit busy for me since I was away quite a lot, but things seem to be going as planned… (I think). The PK 13/14 window is done. I wanted to wait a bit longer before adding Overdrive and let the buds mature a bit more. I’m noticing a bit of fading on older fan leaves. I’m not sure if it’s supposed to be happening at this stage, but I’ll look into it more this week - it could be some kind of buildup after running PK with the AutoPots. This week was more of a coasting week while the buds put on some growth. The feed after PK 13/14 was: Rhino Skin: 1.8 ml/L CalMag → EC 0.4 Coco A: ~2.5 ml/L Coco B: ~2.5 ml/L Cannazym: ~2.5 ml/L Canna Boost: ~3.0 ml/L Total EC: 1.85. Also, before removing PK 13/14 from the reservoir, I flushed the plant with 2.5 L of deionized water and CalMag at 0.38 EC, with pH around 5.7–5.8. Runoff was a bit high - around 4.0 EC, but apparently that’s expected with AutoPots since salts can build up. Doing this seemed to break things up and release the accumulated salts. I didn’t want to keep chasing runoff EC, though, since there isn’t much time left in flower and it could end up doing more harm than good. Fingers crossed we finish strong—I’ll be starting Overdrive in 2–3 days.