Dinamed CBD Plus 1st Indoor

Welcome to my first diary and grow project. Setup: 1mx1mx2m Tent 400w Mh/Hps 3x CFL lights 20w Custom LED strip 120 SMD 150mm Centrigugal Extractor 150mm Bathroom Fan Intake (covered both intake and exhaust with pantyhose to prevent any unwelcome critters to seek the heat and enter the temple of bud. Oscillating Fan Arduino Monitoring Station -> IOT (Update to follow) Started the seeds off in Jiffy Pellets 14/06. Plants were out in the sunshine left to germinate with bottle tops covering them Day 1 - When they emerged I moved them to HID light with a high distance. (19/06) Day 2 - Changed HID to Led strips close to the leaves, as plant 1 showed signs of brown on the tip. (Could be light burn) Day 3/4 - We had to go away for the weekend. How could I leave my babies, so they had to travel with. Forgot my led bar and CFL's Lights at home, so had to improvise. Kept then snug and cozy in a Cooler bag with a single CFL. Started with a tiny low dose of Nutrients. Spray bottle kept them moist. CFL light touched one of my first leaves and left a burn mark. Well, the key goal here was just for them to survive. Will get back at it once they are home. Day 5 - Back home roots started to show on the bottom of the Jiffy Pellets. So since they survived the road trip, time to replant then into their permanent home. (Cocopeat 90%/Perlite 10%) 200ml on each plant after potting. Got the Led Bar up, with a small CFL on each and only add the HID High up for warmth at nights. As it is in the middle of winter here with night temps currently as low as 6 Degrees. 200ml Day 6/7 - The ladies are growing nicely. Managed to get the Humidity up to around 60% for the day with a wet towel and some water jars left in the grow room. All 3 grew well. Just a shame that one of the traveling ladies got burn by the CFL on tour... Will try to keep the humidity up.