Chat
RecommendedRecommended

budnet aeroponics

2
13
5
1328
5 years ago
Follow
2
Indoor
Room Type
Topping
weeks Technique
Defoliation
weeks Technique
83.279 l
Pot Size
Grow Conditions
Week 6
Flowering
40.64
cm
inch
Height
12 hrs
Light Schedule
13+ conditions after
Login
Nutrients
ml/l
ml/gal
tsp/gal
1+ nutrients after
Login
Commented by
zerobane zerobane
5 years ago
###11/20 update#### PH 6.2 PPM 918 CO2 500 Temp 72F cycle time 4mins-off/11seconds-on Light cycle: 12on/12off Another great week, switched over to full bloom cycle with 12/12. Some minor trimming but otherwise fairly hands off at this point. Now the exciting part happens! notes: -Ladies are sucking up a solid 14 gallons a week now. -Smell is getting strong, this would be a bad apartment strain(s) without heavy ventilation. The charcoal filter I have only makes a marginal difference. -Res cleaned out on last cycle. Will clean out flower basins this week and get rid of a nutrient / salt build up. Tend to flush a bit more towards end as the nutrient dosing get higher.
Similar Diaries
Lemon Kix auto
6 weeks
Lemon Kix autoweed_be_thy_medicine
Auto Lemon Kix (Auto Lemon Zkittle)
3 years ago · 6 comments
behbod
2 weeks
behbodbehbod
Critical
3 years ago · 5 comments
Northern Lights Auto
6 weeks
Northern Lights Auto CPLGreenthumb
Northern Lights
3 years ago · 6 comments
Rando clone war
15 weeks
Rando clone warRodamis_Prime
Rando clone war
3 years ago · 48 comments
Blueberry Auto (fastbuds)
11 weeks
Blueberry Auto (fastbuds)AnteroLemon
Blueberry Auto
3 years ago · 21 comments
Ak420
4 weeks
Ak420Cat_girl
AK420 Autoflower
3 years ago · 6 comments
Killer Kush Auto
12 weeks
Killer Kush Auto JohnnyBlaze
Killer Kush Auto
3 years ago · 36 comments
Grow Questions
zerobane
zerobanestarted grow question 5 years ago
Leaves are fanning upwards and undergrowth is huge in flowering phase. Should i be worried about the upwards fan, should I trim on this point or just leave as is and just remove dead leaves?
Solved
Leaves. Curl up
like
DWCHC
DWCHCanswered grow question 5 years ago
When mine get to this point, I deleaf anything that doesn't have trichomes showing or are laying ontop of another bud..the flower auxins are in abundance and allowing a higher par down deeper into the canopy can really help out lower bud development. One rule I follow is to avoid removing more than 30% of the canopy on any day, usually followed up with a light nute application and a few days rest before another selective deleaf. To this end, I've reduced workload during trimming and have had less popcorn buds. On a side note, resin production is a defence mechanism of the plant to discourage browsing by pests. When the right amount of leaves are removed, the plant will respond with an increase in resin to counteract the browsing.. I don't know of any science study's that have been done in this area, but my trials have shown a noticable difference.. Cheers
Comments
Login

Show by Week
Sort by
popularity
popularity
newest
oldest
Ferenc
Ferencweek 2
Nice system mate @zerobane
zerobane
zerobaneweek 9
Thanks @dwchc and @Cannibalgardens Harvest in next 48-72 hours pending time with holiday; i'll update the journal with results. I did 2 experiments for this grow that support both comments. Keeping a consistent canopy seems key for yields, i'll go little more "cutty" with reducing canopy towards middle of bloom to increase light on next grow and run a control with no canopy cutting as a test. 1. the green crack on right side - 1 plant no trimming, 1 plant moderate, 1 plant heavy trimming throughout grow to keep a solid canopy. I'll weigh out results, but so far the the heavy trim is showing the largest colas. 2. The left side is the ak47 - it has 1 clone growing in back and 1 re-grow on same plant that was harvested on my first grow in front. Curious to see the yields and strength on re-grow. One thing I did notice was the nutrients starting spiking on return res; 800 on feed / 1200 in return. Even when i dropped to 200 for flush, the return was still showing 600-700ppm. Interesting; not sure on the "why" or what nutrient is coming back at such a high level.
CRiSPrGrow
CRiSPrGrowweek 1
"Cycle time: 7 seconds on / 5 minutes off " for the top feeding right? very informative 👌
CRiSPrGrow
CRiSPrGrow
@zerobane, very interesting !
zerobane
zerobane
@CRiSPrGrow, Thanks! Will add more info on setup for week 2. Using a mistking repeat cycle timer; the 7s-on/5m-off is the spray cycle for the aero nozzles. The aim at top of rootzone and spray a 50 micron mist.