LSD - Cream Mandarine XL (Auto-DWC-Led)

2nd Week Report 24/10/19 - 31/10/19 25/10/19 I didn't flushed, but I filled the reservoir with 3l of 10% strength solution. Added to the current solution the same nutrients quantity as the first week (except for "Root Stimulator" and "Enzymes" that the first week were 20% strength and now got back to 10%). Now the reservoir should be filled with a 20% strength solution 29/10/19 - CMXL is 10cm height and it is growing really well along with his roots. - LSD is 6cm height and it is growing a little slower like his roots, but both of them look healty. I think in some days should start growing fast like CMXL Added 2 low frequency (113kHz) Ultrasonic Piezoelectric Discs: - One for the root chamber that should help with root expansion as it nebulize solution and the fog carries nutriments (like a small aeroponics integration) and will help my attempt of cloning. - One will stand in a 20% solution next to the plants to increase Humidity (and maybe feed them a little). I'll try to set them running 24/7 Switched water pump that sprays Rock Wool from 5sec every 30min to 6sec every 60min. Next week I plan to stop using the pump as "Top Feed" if roots will be well developed and probably I will use it as "Recirculation Pump" to keep nutrients in reservoir mixed better 30/10/19 Roots exposed to air inside reservoir got a little yellow after inserting the small fogger, so I will try to keep it 30/30 seconds ON/OFF. I will check next day if it's helpful to existing root o as root propagator for clone trial Topped CMXL and did a little of LST just by bending the main stem to expose the small growing next to fan leaves. The cutting was immediately dipped in a solution made by honey and Root Stimulation (the same I use for reservoir solution as it should contain rooting hormone), hoping it covers the cut like a gel and don't let the oxigen get in the cut until there will be some new growing. After that I put the cutting on the lid without any pot, as you can see in the picture some tape is covering the hole and it holding the topping. I covered it with a small jar to maintain humidity, hope to see some roots next week ;) I plan to fim LSD tomorrow if tonight grows enough 31/10/19 Filled the reservoir with 6L 20% strength solution and after that added 10% nutriment for 36L directly into the tote (like I did last week). Now nutrient solution inside reservoir should be 30% strength and it's ready for the 3rd week Pinched LSD Top with my fingers and applied LST by bending a little the main stem. Hope this FIMming works and returns better yield ;) Cloning trial didn't worked (I was expecting nothing, just a test), the cut part of the topping is already dry. I knew the topping was too short, next time if I try to clone his stem will be at lest 2cm Last Update 31/10/19 Next Update 03/11/19 with the next week See you guys ;)