First Grow!

D12 (03/12/2020): Start of the 2nd week. They look healthy. I have a second Mars Hydro TS1000W but I will wait 3-4 days to install it since they don't need more lights for now. I want to remove the drivers from inside of the tent to lower the temperature when both light will be installed. I want to do a wood base before to install the drivers and the dimers on it. - temp: 25C - no water - RH : 65% D13 (04/12/2020): The light is now at 18in from the plants. They now receive 450PPFD (35 000 lux). If they react well, I might install the second light sooner. - temp: 25C - water: PH6.4, temp: 19C, nutrient: PPM410 - RH: 65% D14 (05/12/2020): It's time for the second light. Always at 450PPFD (35 000 lux). I will probably put the lights back at 24in height and dim it, I'm making test tonight. - temp: 26C - no water - RH: 65% D15 (06/12/2020): Since two days my Glue Gelato have leaves that curl up and down. I'm not sure what it is. I made some research and It can be stress from the light (I don't think it's that cause I did check how many PPFD they receive and it's fine). It can be stress from higher temperature in the tent. It also can be stress from too much wind directly on the plant or stress from nutrients feed two days ago. They were thirsty especially the Glue Gelato so I gave them tap water no nutrients (around 500ml each plant). I readjusted the fans to make sure it was not blowing air directly on the plants. Last night I did installed my second Mars Hydro TS1000 light. Both light are now at 24in and dimmed at 75% to have 390PPFD (30 000 lux). I think PPFD 450 (35 000 lux) was to much for the Glue Gelato. The challenge will be to maintain a proper temperature in the tent with both light on. I did removed the drivers out of the tent and fixed them on a wood base to help reduce temperature in the tent. I also modified the light by removing two side panel on each light. I felt that the flat angle panel (90 degree one) was blocking at least one if not two line of LED and felt that it was not optimal. - temp: 26C - tap water: PH6.4 , no nutrients PPM110 - RH: 65% D16 (07/12/2020): Glue Gelato looks way better today. Pretty sure it was too much light and wind on it. I'm learning so that's fine as long as the plant recover from it. Both are growing new leaves and fast so they are healthy! 😀 - temp: 26C - no water - RH: 65% D17 (08/12/2020): Glue Gelato is fine, both looks healthy! It's crazy how the main stem on both plants got thicker in the last 2-3 days. I might water later today. If I do, it will be only with Max Minerals full dose. In order to make sure it was not nutrients toxicity that stressed the Glue Gelato, I'm cutting back on nut. Max Minerals contain a fair amount of nitrogen and minerals. I'm also watching a lot of video on LST and I'm planning to start it at beginning of week 3 when the third node will be fully grown. - temp: 26C - no water - RH: 65% D18 (09/12/2020): End of week 2 of veg and beginning of low stress training. I gave water with only max minerals. - temps: 27C - water: PH6.8, only max minerals PPM: 170 - RH: 65%